Search the record

EE WAS SHOVELING UNDER CONVEYORS, COMPLAINED OF SORE BACK.

EE WAS CUTTING RUBBER BELTING FOR A FLOOR MAT WHEN THE UTILITY KNIFE SLIPPED FROM THE BELTING AND WENT ACROSS HIS UPPER RIGHT LEG, CAUSING A SMALL LACERATION.

EE WAS PUTTING A METAL SCREEN ON FORKLIFT. WHEN SCREEN WAS DROPPED ONTO FORKS, THE SIDE OF THE SCREEN BUMPED HIS ANKLE.

EE WAS TIGHTENING A NUT ON A CONVEYOR TROUGHING ROLLER WHEN HIS WRENCH BROKE. HE FELL BACKWARDS FROM THE JOLT AND TWISTED HIS KNEE.

EE WAS LIFTING A STEEL CHUTE LINER INTO PLACE TO BE WELDED. AFTERWARDS HE FELT PAIN IN HIS CHEST.

EMPLOYEE WAS REPLACING BOLTS IN A LOOSE GRIZZLEY RAIL. HIS LEG SLIPPED BETWEEN TWO RAILS AND BRUISED HIS KNEE.

ADJUSTING FORKS ON FORKLIFT, HAND SLIPPED OFF AND PINCHED FINGER BETWEEN FORKS AND METAL STRUCTURE.

EMPLOYEE WAS CHECKING THE FUEL LEVEL IN A D8 DOZER AND DURING THE PREPARATION CHECK HE TWISTED HIS KNEE.

YEE WAS BRUSHING OFF SOME MATERIAL ON THE TOP OF THE MACHINE WHEN A SHARP EDGE CUT THROUGH HIS GLOVE.

EMPLOYEE WAS PERFORMING ROUTINE MORNIGN EQUIPMENT INSPECTIONS. AFTER INSPECTING CONDITION OF HAZEMAG CRUSHER, EE TWISTED HIS RIGHT FOOT WHEN TURNING AWAY TO LEAVE AREA.

THE EE WAS PARTICIPATING IN A MOCK EMERGENCY DRIVE AT THE POWER PLANT CONVEYOR. HE WAS REMOVING A PATIENT ON A STRETCHER AND HAD TO LIFT THE STRETCHER ABOVE THE RAILING WHICH WAS SHOULDER HEIG HT.

LIFTING ROCKS OUT OF CHUTE, AND CHANGING HAMMERS. EE WAS STANDING IN AN AWKWARD POSITION AND TWISTED THE WRONG WAY WHILE PUSHING AND LIFTING.

TEE WAS CLEANING SIDES OF SCREEN UNDERFLOW HOPPER WHEN SOME ACCUMULATION OF CULM FELL ON HIS HAND AND CAUSED HIS HAND TO BUMP UP AGAINST THE STEEL SIDE.

MAKING A TAP SPLICE ONTHE INSULATED QUADRAPLEX QIRE. HE WAS HOLDING OTHER WIRE OUT OF THE WAY AND STRIPPING INSULATION. KNIFE SLIPPED OFF WIRE AND STRUCK FINGER.

TOWARDS THE END OF SHIFT, EMPLOYEE REPORTED HE HAD PAIN IN BACK, BUT COULD NOT PINPOINT A SPECIFIC TIME WHEN THE PAIN BEGAN.

EMPLOYEE THOUGHT CAUSTIC PUMP WAS NOT WORKING - WALKED OVER TO SEE IF SHAFT WAS TURNING. AT THIS POINT, HE CAME IN CONTACT WITH CAUSTIC, THROUGH SPLASH OR POSSIBLY BY HAND CONTAMINATION & RUBB ING EYE. EMPLOYEE WAS IN RESTRICTED AREA WITHOUT APPROVAL GEAR.

HE WAS LIFTING A MOTOR CONTROL CENTER WITH A CRANE ASSISTING. WHILE PULLING AND LIFTING THE MOTOR CONTROL CENTER THROUGH THE DOORWAY SIDEWAYS, HE PULLED MUSCLES IN HIS BACK. AT THE TIME OF THE INJURY HE DID NOT GIVE MUCH THOUGHT TO THE MUSCLE PULL. IT AFFECTED HIS LEFT SIDE, LOWER BACK AND LEFT HIP.

EMPLOYEE LIFTED GUARD ON CONVEYOR BELT TO INSPECT AREA WHEN HIS GLOVE TOUCHED A ROLLER & CAUGHT HIS FINGER.