Search the record

SEVERE PAIN IN RIGHT SHOULDER WHILE GETTING DOWNOFF FORK LIFT, SUPPORTING MOST OF BODY WEIGHT FROM RIGHT ARM ON DOOR POST OF FORK LIFT

MOVING OFFICE FURNITURE EE ALLEDGEDLY STRAINED LEFT HAND AND WRIST.

EMPLOYEE WAS MOVING MILL LINERS ON A PALLET THAT HAD SHIFTED OUT OF PLACE.

EMPLOYEE WAS MOVING A SECTION OF FENCE,FENCE SECTION HAD RAZOR WIRE ON THE TOP OF IT.WHILE MOVING THE SECTION OFF OF THE PILE,A BROKEN PIECE OF RAZOR WIRE CAUGHT THE EMPLOYEES LEFT LEG.

EMPLOYEE COULD NOT SPECIFY ANY ONE ACTIVITY THAT CONTRIBUTED TO HIS INJURY. EMPLOYEE REPORTED INJURY ON 9-4-96.

EMPLLOYEE WAS WORKING WITH THE CRUUSHER MAINTENANCE CREW MOVING 55 GALLON DRUMS OF GREASE WITH A BOOM TRUCK. DRUM STRUCK THE SIDE RAIL OF WORK AREA. EMPLOYEE SHIFT HIS BODY BACKWARDS VERY QUI CKLY EMPLOYEE WAS NOT GOING TO BE STRUCK BY DRUM THIS NOISE STARTLED HIM CAUSING HIM TO REACT TO THE NOISE.

EE WAS POWER-WASHING THE DRILL, WHEN HE WAS TRYING TO REPOSITION HIMSELF IN BETWEEN 2 RAIL GUARDS HE SLIPPED ON THE WET CONDITIONS AND FELL TO HIS LEFT SIDE LANDING ON THE LEFT GUARD RAIL. THI S BRUISED HIS LEFT LOWER RIB.

EE WAS TRYING TO REMOVE JACKLEG OUT OF A LIFTER HOLE. STEEL HUNG UP AND THE EE STRAINED HIS BACK.

EE WAS CLEANING OUT THE AREA UNDER BELT #1 WITH A SHOVEL WHEN THE INJURY HAPPENED.

THE INTERSECITON OF THE 440 ACCESS RAMPA ND THE 400 PRODUCTIO DRIFT HAS BEEN MINED SEVERAL MONTHS AGO. BECAUSE THE ORE WAS HARD AND THICK, THE THE DRIFT WIDTH HAD BEEN INCREASED TO 13'X13'. THE BACK WAS FRACTURED AND THE DENSITY OF SPLIT SET AND EPOXY BOLTS WAS HEAVY. THE FAILURE WAS BLASTING VIBRATION INDCUED IN FRACTURED JOINTED GROUND. THE BLASTING WAS IN THE NEW ACCESS DRIFT

EE IS HAVING PROBLEMS WITH OLD INJURY. REOCCURRING PAIN.

SMALL ROCK FELL FROM THE BACK STRIKING THE MINERS LEFT KNEE EMPLOYEE HAD 4 SUTURES.

EMPLOYEE STEPPED ON A ROCK THAT WAS ON A MUCK PILE AND IT SLIPPED OUT FROM UNDERNEATH HIM. THE EMPLOYEE FELL. AS A RESULT OF THE FALL, HE TWISTED HIS RIGHT KNEE.

EE BECAME SATURATAED WITH BARREN WATER. [LOW CONCENTRATION OF CYANIDE SOLUTION]. HE STUCK HIS LOWER LEGS INTO HEAP RETURN TO FLUME TANKS. HE WS THEN OVERCOME THROUGH CYANIDE ABSORITION.

HYDROGEN CYANIDE GAS EXPOSURE. INCIDENT IS STILLUNDER INVESTIGATION.

INSTALLING 6' SS BOLT. A ROCK FELL OUT OF BACK AND HIT HIM IN THE FACE.

EMP MISUNDERSTOOD MECHANICS REQUEST TO LET OFF OF COME A LONG AND ATTEMPTED TO TIGHTEN PRESSURE ON UNIT. ANGLE IRON THAT COME A LONG WAS ATTACHED TO CAME LOOSE CAUSING SUDDEN RELEASE OF PRESSU RE. EMP FELL OVER BACKWARDS, TUMBLED DOWN BANK.

INJURED RING FINGER, RIGHT HAND, WHILE USING 20# SLEDGE HAMMER TO LOOSEN DRIED CEMENT IN U/G TRUCK BED. HEAD CAME OFF SLEDGE CAUSING IRRATIC DIRECTION OF SWING- STRUCK RIGHT HAND ON DUMP BOX L EVER.

12-8-95 FRI DAY SHIFT. DC-1 PRODUCTION CUT WAS BLASTED FROM THE TIP OF BACKFILLED LEVEL 1 ORE PASS. ROUND WAS LEFT UNSUPPORTED DURING WEEKEND. SUN 12-10 SWING SHIFT - ROUND WAS MUCKED OUT AND ROOF BOLTING WAS STARTED. DC-1 OREPASS INTERSECTION BEGAN TO FAIL AND EMP'S WITHDREW EQUIPMENT.

CHECKING GROUND CONDITIONS, A ROCK FELL AND HIT EE ON THE RIGHT SHOULDER.

EE'S REPECITIVE USE OF HAND TOOLS EE NOTIFED ANOTHER PERSON OF SYMPTOMS ON 12/95 EE WENT OFF WORK ON 6/4/96

WHILE MEASURING REBAR, AS HE STEPPED BACK HE LOST HIS FOOTING, GRASPED THE TAPE MEASURE AND CUT THE FINGERS OF HIS LEFT HAND.

HANGING UTILITY PIPE, PIECE OF PIPE SLID BACK ON SCISSOR LIFT, CAUGHT FINGER BETWEEN PIPE AND SCISSOR LIFT RAIL.

INSTALLING 6'SPLIT SET ROCK BOLT, A HARD HAT SIZE ROCK FELL FROM THE BACK AND HIT THE EMP IN THERIGHT FOREARM.

THE FIRST ROUND SLAB ROUND ESTABLISHING A NEW INTERSECITON AT ST-4 & ST-5 IN TEH SOUTHWEEST EXTENSION OREBODY HAD BEEN TAKE PRIOR TO SWING SHIFT ON 11-12-95. THE SECOND ROUND (FULL ROUND) WAS TAKEN DURING THE FIRST HALF OF THE SHIFT. THIRD ROUND WAS DRILLED, BLASTED AND MUCKED DURING THE DURING THE SECOND HALF OF THE SHIFT.

WHILE GUIDING A DOWNCOMER INTO A TANK, FELLOW EE WAS USING A SLEDGE HAMMER TO HELP ALIGN IT. EE ATTEMPTED TO SHOW FELLOW EE WHERE TO HIT DOWNCOMER, AND WAS STRUCK WITH HAMMER ON LEFT RING FING ER.

ROCK/SLAB FELL OUT OF BACK WHILE BOLTING. SLAB HIT THE EMPLOYEE IN THE RIGHT SHOULDER AND ARM. EMPLOYEE WAS X-RAYED AND EXAMINED BY A DR. ON 10-23-95 & WAS TOLD HE WAS BRUISED. HE WENT BACK FO R A 2ND X-RAY ON 10-28-95 AND DISCOVERED THAT HIS COLLAR BONE WAS BROKEN.

EMPLOYEE WAS PULLING CONCRETE MIX WHILE PUMPING EMPLOYEE GOT MIXTURE INTO BOOT CAUSING A CEMENT BURN

USING LEGS & FEET TO ROLL CYLINDERS WHILE ROLLING A CYLINDER THE CYLINDER CAME UP AGAINST A ROCK CAUSING IT NOT TO MOVE ON ONE END WHEN EMPLOYEE PUT PRESSURE ON OTHER END CYLINDER SLID AROUND CAUSING EMPLOYEE TO LOOSE HIS BALANCE THUS TWISTING HIS KNEE

EMPLOYEE FOUND A GROUND FALL IN 6J-17 AT 11:00 PM ON 9-23-95 WHEN HE WENT INTO THE CUT TO GET BOLT DRIVER. THE FALL WAS AT THE BACKFILL FACE AND IT WAS 8' HIGH X 10' WIDE X 12' LONG. THE LAST ACTIVITY IN THIS CUT WAS ON SWING SHIFT ON 8-30-95. POSSIBLE CAUSE OF THE FALL WAS WEAK, HIGHLY FRACTURED GROUND AND NARROW PILLAR WIDTH.

AFTER STRIKING RIGHT FIXTURE WITH RAISED BED OF TRUCK ATTEMPTED TO REPLACE FIXTURE ON HANGER FIXTURE DROPPED STRIKING EE ON R. FOREARM WITH BROKED GLASS.

TWO EMPLOYEES HAD JUST STARTED BOLTING THE SECOND ROUND OF SQ-4 PRODUCTION CUT ON THE RIGHT SIDEACTING MINE FOREMAN NOTICED THE LEFT SIDE WAS STARTING TO WORK. HE WITHDREW BOTH EMPLOYEES. THE BACK BROKE TO A FLAT LAYING SLIP 12' HIGH X 12' LONG AND 6' ABOVE AND THE 6' SPLIT BOLT SET. THE INTERSECTION DID NOT FALL.

REMOVING COVER PLATE TO FIND OIL LEAK DID NOT SUPPOSED PLATE OR ACCEPT ASSISTADE AS OFFERED BY A CO WORKER, PLATE FELL CATCHING RIGHT HAND AREA INDEX FINGER.

EE WAS PUTTING HIS TOOLS AWAY AT THE END OF THE JOB. A DUST DEVIL WIND GUST BLEW SAND AND DUST IN ON HIM. HE GOT SAND IN HIS RT EYE AND VCOULD NOT GET IT OUT.

INSTALLING SPLIT SET ROCK BOLTS & 8" STRAPS, A SMALL ROCK SLAB FELL.

THE EE ATTEMPTED TO WALK AROUND THE LOADER, THE LOADER STARTED MOVING & PINCED THE LEFT ANKLE INTO THE RIB WITH THE REAR BUMPER OF THE LOADER.

WHILE STAMPING DORE BAR WITH PUNCH & HAMMER--HIT PUNCH OFF CENTER, CAUSING A PIECE OF HAMMER TO FLY OFF, STRIKING EE IN LEFT FOREARM. PIECE EMBEDDED IN ARM.

SCALING THE FACE, A ROCK ROLLED DOWN THE SCALING BAR & HIT EE IN THE NOSE.

MINING MILL TAIL SOLIDS W/CRUSHED ORE FOR AGGLOMERATION-OPERATING LOADER. W/BUCKET LOADED W/WET MATERIAL. ARTICULATION OF LOADER TO THE RIGHT WHILE LEFT FRONT WHEEL RAN OVER BUMP IN GROUND MADE LOADER LAID OVER AT ABOUT 48 DEGREES, OPERATOR CAUGHT LEFT FOOT BETWEEN CAB & BRAKE PEDAL.

HELPING TO INSTALL A SPLIT ROCK BOLT, JACKLEG MACHINE SLIPPED AND THE DRIVER HIT THE RIGHT HAND, BRUISING THE RIGHT HAND.

EMPLOYEE TOSSED THE COME-A-LONG UP TO AN EMPLOYEE STRIKING HIS LEFT THUMB.

WHILE LOADING ORE THE JCI-250 LHD JERKED AND THE OPERATOR ALLEGEDLY FELT A SHARP PAIN IN HIS BACK. REQUESTED TO SEE A DOCTOR 2-1-95.

GROUND FALL 15' LONG X 16' WIDE X 7' HIGH.

WHILE CORRECTING BAD GROUND IN THE SF-33 DRIFT ON THE 7TH LEVEL. THE BACK STARTED WORKING - EMPLOYEES WITHDREW FROM THE DRIFT-DANGERED IT OFF. THE FALL WAS DISCOVERED AT 11:30 PM APPROX 11' HIGH. THE DRIFT WAS APPROX 9' HIGH + 8' WIDE WITH WET GROUND CONDITIONS +6' SPLIT SET BOLTS.

A ROCK FELL HITTING THE EE ON THE LEFT SHIN CAUSING A POSSIBLE INFECTION AND CELLUTITIS.

THE EMPLOYEE DECIDED TO TAKE A SHORT CUT ACROSS THE TOP OF THE FUEL TANK TO DISMOUNT ON THE REARACCESS LADDER, SLIPPING AND FALLING APPROX 12' TO THE GROUND. NOTE THIS IS NOT AN APPROVED ACCE SS OR AN APPROVED WORK METHOD.

EE WAS REMOVING APPROX. 15' STEEL PIPE ( 1-1/4 DIA.) FROM A CARBON COLUMN. THE PIPE GOT HEAVY AND CAUGHT HER HAND BETWEEN PIPE AND HANDRAIL AND CAUSED HER BACK TO BEND. RELEASED TO RETURN TO W ORK ON 1-8-94, BUT DID NOT RETURN PER HER CHOICEUNTIL 1-10-95.

A GROUND FALL OCCURRED IN THE C-ZONE MINE IN THE WEST POD IN 61-19 CUT ABOVE THE ANCHORAGE ABOUT 20' BACK FROM FACE, THE FALL WAS CAUSED BY A SLIP IN THE BACK AND RIGHT RIB. THE STRIKE OF THE SLIP WAS PARALLEL TO THE DRIFT.

MINER WAS LOADING THE DRIFT FOR BLASTING WHEN A ROCK FELL FROM THE TOP OF THE FACE AND STRUCK THE MINER ON THE LEFT FOOT.

WHILE DRILLING THE JACKLEG DRILL SLIPPED, THE EE TRIED TO CATCH THE DRILL PULLING A MUSCLE IN HID BICEP. WENT TO DR ON 10-13-94. LOST TIME 10-19-94 BECAUSE OF SEVERE HEADACHES, BUT DR COULD NO T VERIFY HEADACHES WERE THE RESULT OF THE INJURED ARM WHICH WAS ALRIGHT BY 10-19-94. REQUEST A DEGREE 10 FILING STATUS AS NON-OCCUPATION. NO MEDICAL REPORTS SUPPORT THE ARM INJURY CAUSED THE