Search the record

EMPLOYEE WAS HE5PING TO INSTALL A NEW DRISCO PIPE LINE AT THE KREBS CYCLONE TOWER BEHIND THE MILL. HE WAS SUPPORTING THE PIPE ON HIS SHOULDER SO HE COULD LINE THE FLANGES WHEN HE FELT PAIN IN HIS RIGHT SHOU5DER. HE REPORTED TO FOREMAN IMMEDIATELY BUT DID NOT GO TO THE DOCTOR UNTIL LATER.

EMP WAS CLIMBIN1 DOWN FROM THE #2 WATER WAGON HIS FOOT SLIPPED ON A ROCK CAUSING HIM TO FALL AND TURN HIS ANKLE

EMP WAS HOLDING A GENERATOR IN P LACE DRUING REPLACEMENT WHILE TRYING TO START THE BOLTS HE DROPPED THE GENERATOR REACHED TO CATCH IT AND PULLED A MUSCLE IN HIS BACK

EMPLOYEE WAS OPERATING #20 CAT TRUCK WHEN HE WAS JARRED BY THE SHOVEL OPERATOR CAUSING HIM TO HURT HIS BACK

EMP WAS GREASING #3 ROD MILL BY POURING HEAVY OIL FROM A CUP THROUGH A GUARD OVER THE MAIN DRIVE GEAR WHILE STANDING ON A HANDRAILED STEPPED PLATFORM HE LOST HIS BALANCE AND FELL AGAINST MOTOR HOUSING HE SCRATCHED HIS LEFT LEG AND LATER ON 5 16 85 STATED THAT HE HAD HURT HIS BACK ALSO WHEN HE FELL

EE WAS IN STORAGE ROOM WHEN HE ACCIDENTLY KNOCKED A DIAPHRAM PUMP CAM SHAFT OFF SHELF HITTING HIS LEFT FOOT. HE LOST HIS BALANCE & FELL BACKWARDS INTO ROD MILL BEARING.

EMP HAD COMPLETED INSTALLING INJUECTOR IN EUCLID WHEN HE SLIPPD ON LADDER AND HIT HIS LEFT INDEX FINGER ON THE SHARP EDGE OF FAN

EE WAS MOVING OXYGEN BOTTLE INTO WROK AREA TO REPLACE EMPTY CYLINDER. WHILE WALKING BACKWARDS EE TRIPPED OVER BROKEN CONCRETE LOST HIS BALANCE & WAS STRUCK IN T HE GROIN BY THE END OF THE B OTTLE

EMPL WELDING ON PART OF SECTION OF STEPS TO BE INSTALLED AT CRUSHER.WHILE MANUVERING SUB-ASSEMBLY INTO PROPER WELDING POSTION,STRAINED HIS BACK.

EMPLOYEE WAS IN THE PROCESS OFINSTALLING AN ELECTRIC HOIST TO REMOVE MOTOR FROM #2 SALA PUMP. HE ATTEMPTED TO LIFT HOIST AND STRAINED HIS LOWER BACK.

EE WAS WORKING ON FEED SCREW FOR CHEM SPOD DRYER WHEN PANEL HOLDER FELL DOWN CHUTE STRIKING HIM ON RT FOREARM LACERATION REQUIRED 7 STITCHES.

EMPLOYEE WAS REMOVING A BLOCKAGE IN THE ORE TUNNEL CHUTE, HE WAS PULLING ON THE GATE TO ALLOW SOME LARGE ROCKS TO PASS WHEN HE FELT A POP AND A STINGING PAIN

EMPLOYEE WAS REMOVING BLOCKAGE IN ORE TUNNEL CHUTE. HE FELL AND SCRATCHED THE TOP OF HIS LEFT HAND REINJURED HIS BACK

EE WAS PUTTING BUCKET CYLINDER PIN ON #7-245 SHOVEL. HIS HAND SLIPPED OFF END OF PIN & WAS CAUGHT BETWEEN CYLINDER ROD & BUCKET FRAME MASHING HIS SECOND THIRD & FOURTH FINGER. 18 SUTURES WERE REQUIRED IN 4TH FINGER 8 IN 3RD FINGER.

EMPLOYEE WAS WORKING ON CELLS #3 WHEN HE SLIPPED OFF PADDLE SHAFT INTO CELLS, HITTING HIS RIGHT KNEE, HIP AND SHOULDER.

EMP WAS SHARPENING HIS KNIFE TO SKIN SOME WIRE WHEN THE KNIFE SLIPPED AND CUT HIS MIDDLE FINGER ON LEFT HAND LACERATION REQUIRED 5 STITCHES

HE WAS STARTING TO CLIMB UP STEPS ON #16 TRUCK WHEN HE SLIPPED ON AN ICE BUILD-UP ON STEP & STRUCK HIS RIGHT SHIN CAUSING A LACERATION THAT REQUIRED 3 STITCHES & BRUISES.

EMP WAS REPLACING A WATER PIPE AT THE TRAYLOR CRUSHER THAT HAD FROZEN AND BURST A 10\ SECTION OF UNSECURED 1" PIPE FELL 2 FEET TRAPPING EMPLOYEES FINGER BETWEEN IT AND AN I-BEAM SEVERI NG THE FIRST JOINT OF RING FINGER ON LEFT HAND

EMPLOYEE WAS ASSISTING WITH LOADING A TRUCK WITH GABBED MATERIAL AT DRY GRIND. HE ATTEMPTED TO EMP. WAS ASSISTING WITH LOADING A TRUCK AWITH BAGGED MATERIAL AT DRY GRIND. HE ATTEMPTED TO PIC K UP ONE SIDE OF A DOCK PLATE AS CO-WORKER WAS DRIVING THE FORKLIFT UNDER IT. HE SPRAINED HIS LOWER BACK.

EMPLOYEE APPARENTLY HAD HIS BELT AND CLOTHING TO BECOME ENTANGLED ON SHAFT CAUSING CONSTRUCTION TO CENTER OF BODY RESULTING IN DEATGH

REPLACING FUSE INSIDE SUB-STATION WHERE LIGHTNING HAD BLOWN OUT FUSE AND LIGHTNING PROBABLY RAN IN AGAIN WHILE EMPL WAS CHANGING FUSE.

EE WAS LOADING SHOT WHEN DUST BLEW UP FROM ANOTHER AREA. HE WASHED HIS EYES BUT WAS UNABLE TO CLEAN DUST FROM LEFT EYE.

EMPLOYEE WAS WORKING ON DIAPHRAM PUMP REPLACEMENT. AS HE WAS MOVING PUMP INTO POSITION FOR SETTING, HE SPRAINED HIS LOWER BACK.

EMPLOYEE WAS REMOVING AND REINSTALLING LIFTER BARS INSIDE 3 ROD MILL IT WAS A SMALL AREA WHERE EMPLOYEE HAD TO BEND OVER IN AN AWKWARD POSITION TO WORK