Search the record

The employee experienced physical strain due to the repetitive pulling of the wire, which was built up in a chute that was plugged in an awkward position, and required a medical evaluation.

Loose dirt from the rain and mud caused the employee to slip, causing an abrasion of the right knee.

Individual was in the finish mill, shoveling out mill balls - breeze blew debris in EE's eye resulting in minor eye irritation.

Employee was struck in the left eye by a rivet buster piston. Employee was wearing safety glasses at the time of the incident.

The employee was climbing on a drill rig and strained EE's shoulder area

Employee injured left pinky finger while trying to disengage a gear. Employee went to medical facility, was treated and release to light duty.

Employee was releasing a pressurized line and it exploded and cut employee's hand.

Employee was climbing a ladder when they slipped and fell 8 feet to the ground. They sustained a fracture in their right hand, a contusion on their right hip and a contusion on their left foot.

Employee was using ladder, slipped and fell approximately 12 feet.

Employee was staging grease drums, one pulled away and they stopped it with their right arm and their elbow popped an pain ensued.

Employee opened a poke hole on the hot air slide. It immediately went positive. The force blew off EE's hood and burned EE's neck and ear.

Employee was moving a cart down a ramp when the items on the cart slid and lacerated left hand.

Was lifting a hoist on a platform in the tower and EE reinjured a hernia.

Finger was pinched by a roller on the tire system.

Smashed finger when lance slipped inside poke hole over refractory.

Operating the drill over a period of six months caused an injury on the right palm.

Walking down stairs and somehow rolled foot outward.

Laceration to right hand caused by pipe stand striking employee while turning and wrapping shaft assembly.

The control room monitored a variation in temperature within a bin which was handled by normal procedures, consistent with design capacity. There was no injury or illness resulting from this condition. This pressure excursion does not constitute an "accident" as set out at 30 C.F.R §50.2(h). The "blast gate" which is designed to relieve pressure in this type of situation did open.

while moving an air lance arms, strained EE's left shoulder.

Employee was climbing into North side of Pantleg to see if the welds were cut on a seal plate, not realizing it was under pressure and got hit by plate piece.

The employee was holding a piece of wood to brace the metal while another employee was hitting in place. The other employee went to swing the sledgehammer getting it caught in the chain fall chains knocking EE off balance causing EE to hit the EE's hand.

Employee was picking up a case of 6 hams and 2 turkeys. While loading hams and turkeys into the tailgate of the truck, EE strained back.

Unplugging tire chute, strained back.

Employee was Shoveling Material and twisted body they felt a pinch in lower back Note: Employee returned to work the following day on Modified Duty 7/14/2020

Chemical Burn blisters to both ankles. Employee is reporting "Working in a very dusty environment the product we were cleaning got into my boot and by the end of the day they were rubbed raw"

Employee was mucking out the cone of 4cy10 vessel and was struck in the right shoulder by piece of falling debris.

Employee was using a crowbar to break rocks stuck in the vibrating screen. one rock broke easier than expected, causing to reach farther then intended and fingers were smashed between bar and screens.

Burn to hands and knees due to hot material

Shoveling into a skid steer bucket and felt a pop in back, experienced pain in lower back.

Smashed thumb in between a pinch point.

Employee was attempting to close the isolation valve on 5AC1 and felt a pop in EE's right shoulder

Smashed little Finger on Equipment

Left rear wheel came off of cart and lost control of vehicle, braced for impact when cart fish-tailed. Initially, a first aid incident, follow up Dr. appt July 1, placed employee on restricted duty.

Walking up stairs between f-2 and f-4 foot got caught between grates causing strain on left foot

During cleanup, pinched hand between chipping gun gat and equipment housing.

Was pushing a loaded wheel barrow on an uneven surface and hit a bump causing pain in left lower back.

EE States Exposure to dust in workplace water system with silica has caused EE to be diagnosed with Lupus in 2016

Walked down the staircase rolling ankle.

Laceration to right hand finger.

Strained back when turning to dump shovel.

Employee Stepped over an I-Beam, Clinker on the other side of I-beam, sprained left knee

Lost grip of Hydraulic ram

Mill Ball fell from above and struck employee on hand, bounced off and hit knee

3 workers were welding on a flat 5' X 5' steel door for a hammer mill (4BR1), the door was turned upright resting on the ground & leaned against a forklift for the final welding position. The door became unbalanced while the workers were welding, & fell over striking EE on the leg. EE was taken to the hospital by ambulance & was admitted for a broken leg.

Employee placed a metal rake against a post while waiting for a bucket to fill. Metal rake fell and hit employee in the back. Employee had a personal motorcycle accident 6/28/16.

Employee was cleaning under the kiln feed and dust hopper when shove bumped the chute and material came out covering ee. Dust got in eye causing an irritation and burn to face and right eye

Employee was lifting a lock and load weighing about 20lbs. EE set the lock and load in the CAT bucket, stood up and felt a pinch in the back resulting in a strained back.

While employee was removing a large piece of Rebond from Cyclone opening, EE pinched EE's finger between the rebond and the side of the opening. The result was a minor bruising of the finger.

Employee was trying to loosen a hydraulic line on a unit and sprained lower back due to excess tightened fitting.