Search the record

WHILE EMPL USING SHOVEL AROUND ROCK PLANT,SHOVEL HANDLE SPLIT AND JAMMED INTO EMPL LEFT HAND BETWEEN THUMB AND INDEX FINGER CAUSING DEEP PUNCTURE WOUND.

WHILE EE WAS CUTTING A HOLE WITH AN ACETELINE TORCH, A PIECE OF HOT SLAG FLEW INTO HIS LEFT EAR, CAUSING RUPTURE IN EAR. EE DID NOT SEEK MEDICAL TREATMENT UNTIL 6-1-92, DUE TO NO PAIN BEING FE LT BY EE. EE RECEIVED 1 ST TREATMENT FROM EISHENOWER IMMED CARE THEN REFERRED TO EAR NOSE THROAT SPECIALIST.

WHILE EE WAS CLIMBING DOWN OFF OF AN 8X20 TYLER SCREEN ON THE AGGREGATE PLANT, HE HIT AND BRUISED HIS RIGHT ELBOW.

WHILE EMPLOYEE WAS CHANGING A CONVEYOR BELT AT THE AGGREGATE PLANT, HE FELT A PAIN IN HIS LOWER BACK AREA.

WHILE EMPLOYEE WAS HELPING TO CHANGE SCREENS AT PLANT HE BECAME DIZZY, OVERHEATED AND STARTED VOMITING. HIS FOREMAN IMMEDIATELY TOOK HIM TO VALLEY URGENT CARE IN EL CENTRO WHERE HE WAS TRANSFE RRED TO EL CENTRO MEDICAL CENTER. ON 9-29-91 WHILE STILL IN HOSPITAL, EMPLOYEE DIED.

EMPLOYEE WAS TAKING A TRAMP RELIEFT CYLINDER APART. WHILE TRYING TO REMOVE A PISTON FROM THE BAD CYLINDER, THE PISTON BLEW OUT AND SMASHED THE EMPLOYEE'S MIDDLE FINGER ON LEFT HAND.

EMPLOYEE WAS STEPPING DOWN OFF OF A CATWALK AND HE STEPPED ON A ROCK WHICH CAUSED HIM TO TWIST HIS ANKLE.

EMPLOYEE WAS LIFTING A TOOLBOX AND COMPLAINED OF PAIN IN GROIN AREA.

CARRYING PC OF FEEDER WITH OTHER EMP FEEDED FELL HIT HIM ON BACK OF LEG KNOCKED HIM TO GROUND.

WAS MAKING ADJUSTMENT ON A SMALL GENERATOR AND THE SCREWDRIVER AND THE SCREWDRIVER SLIPPED AND SHORTED A WIRE CAUSING MINOR INJURY TO HIS INDEX FINGER.

WHILE LIFTING SCREEN PANELS UP TO 4'X16'CRUSHED SCREEN SCREEN PANEL SLIPPED CRUSHING LITTLE FINGER ON LEFT HAND BETWEEN SCREEN PANEL & LIFTING CABLE.

HE WAS CLIMBING UNDER THE STACKER AND PUT HIS HAND DOWN ON A PIECE OF BROKEN WOOD. THIS CAUSED SPLINTERS TO GET STUCK IN THE PALM OF HIS HAND.

HE WAS PUTTING A BELT ON THE 2ND SCREEN AND THE WIND BLEW A PIECE OF METAL IN HIS EYE.

EMPLOYEE WAS AT THE #2 ROCK PLANT 1ST SCREENING TOWER REPAIRING IT WHILE HE WAS LOOSENING A BOLT THE WRENCH SLIPPED & HE CUT HIS THUMB ON ANOTHER BOLT

EMPL WAS SHOVELING AROUND TAILPULLEY AT PLANT & HE STRAINED BACK.

HE WAS REPAIRING CRUSHER CONVEYOR AND PULLED TOO HARD AND SPRAINED HIS RIGHT SHOULDER.

INJURED WAS REPAIRING 51 INCH CONE CRUSHER AND A PLATE POPPED OPEN AND CAUGHT HIS HAND BETWEEN THE BELT AND PLATE-HE BROKE HIS HAND.

I,NAME WAS REPARING A HOLE IN THE CONVEYOR AND REACHED OUT AND PULLED A MUSCLE IN HIS SHOULDER.

EMPLOYEE WAS REMOVING BLOCKAGE UNDER CRUSHER AND GOT SOME ROCK IN HIS LEFT EYE.

I.NAME WAS TRYING TO CLAMP A CONVEYOR BELT AND HE GOT HIS THUMB CAUGHT BETWEEN TWO PIECES OF METAL.

I.NAME WAS LIFTING A 150 LBS SCREEN PANEL WITH ANOTHER EMPLOYEE AND ONE LIFTED BEFORE THE OTHER WAS READY CAUSING I.NAME'S HAND BEING WEDGED BETWEEN TWO SCREEN PANELS. HE SMASHED HIS RIGHT HAD .

WHILE FABRICATION 6" HEAVY WALL PIPE, HE GOT HIS LEFT RING FINGER CAUGHT BETWEEN PIPE, HE SMASHED AND CUT HIS FINGER APPROX. 16 STITCHES.

SOMETIME BETWEEN 8 AND 10 PM EMPLOYEE GOT SPLINTER LODGED IN LEFT ELBOW WHILE HE WAS WORKING WITH OLD TIMBERS.

EMPL STANDING UP AFTER HOOKING CRANE TO CONVEYOR LEG.WHEN LEG WAS LIFTED IT ROLLED AND CONTACTED ANKLE.BROKEN OR CRACKED ANKLE AND SMALL LACERSATION.

I,NAME WAS WELDING IN THE DIRECT SUN IN TEMPERATURES OVER 110 DEGREES.

HE WAS TIGHTENING BOLTS ON ROCK CRUSHER AND SLIPPED AND FELL ON HIS TAILBONE. THIS RESULTED IN A FISSURE ON TAILBONE.

WHILE USING A DRILL TO REMOVE A BROKEN BOLT THE DRILL BIT LOCKED AND SPUN THE DRILL.THE INJUREDS WRIST WAS CAUGHT BETWEEN THE DRILL AND 1/2 PLATE CAUSING LACERATION ON RIGHT WRIST.

CONVEYOR WAS BEING REMOVED BY SECTION FOR REMODELING OF PLANT CATWALK ON ONE PARTICULAR SECTION SEPARATED FROM CONVEYOR & FELL APPROX 12 FT TO GROUND CAUSING TWO EMPLOYEES TO LOOSE BALANCE & F ALL SAME DISTANCE TO GROUND

CONVEYOR WAS BEING REMOVED BY SECTION FOR REMODELING OF PLNAT.CATWALK ON ONE PARTICULAR SECTION SEPERATED FROM CONVEYOR AND FELL APPROXIMATELY 12 FEET TO GROUND CAUSING TWO EMPLOYEES TO LOSE B ALANCE AND FALL SOME DISTANCE TO GROUND.

THIS WAS NO AN ACCIDENT WAS A POSSIBLE ALTERATION BETWEEN TWO EMPLS THIS REPORT BEING SUBMITTED FOR COMPLIANCE REASONS

EMPLOYEE WAS WORKING TOO CLOSE TO WELDER WHEN HE RECEIVED WELDING BURNS TO BOTH EYES

AS EMPLOYEE WAS CHECKING INCOMING VOLTAGE ON STARTER SCREEN, IT SHORTED OUT CAUSING AN ELECTRICAL FLASH BACK, BURNING EMPLOYEES FACE AND HANDS.

CARDIO-PULMONARY ARREST.