Search the record

EMPLOYEE WAS HELPING ANOTHER EMPLOYEE TO ROLL OVER A METAL LADDER AND STRAINED HIS BACK.

EE WAS CLEARING OUT 4' CRUSHER. A ROCK WAS STUCK IN BOTTOM OF CRUSHER. HE WAS PULLING ON ROCK WITH A HOOK BAR. THE BAR SLIPPED OFF ROCK AND HE HIT HIS FINGER ON THE CONE PART OF CRUSHER.

EE WAS USING SLEDGE HAMMER TO KNOCK CONCRETE WALL DOWN NEXT TO CRUSHER.

EE WAS USING A WEDGE AT JAW CRUSHER TO LOOSEN A ROCK. THE WEDGE KICKED BACKWARD & HIT HIM IN CHIN.

EMPLOYEE WAS MOVING A LARGE ROCK OUT OF ROADWAY THAT LEADS TO PIT. WHEN HE STRAIGHTENED UP HE FELT SOMETHING PULL.

EMPLOYEE WAS GETTING UP ON TOYOTA SKID STEER LOADER. HE SLIPPED & FELL ON LEFT ELBOW.

A ROCK FELL FROM A PIT TRUCK ONTO THE PIT ROAD. EMPLOYEE WAS TRYING TO ROLL THE ROCK FROM THE ROAD, WHEN HE FELT A MUSCLE PULL IN HIS BACK.

EMPLOYEE WAS ATTEMPTING TO UNSTOP FEED CHUTE ON PUGMILL WITH HAMMER. HE WAS HITTING THE CHUTE WITH THE HAMMER. THE HAMMER HEAD CAME OFF AND HIS HAND STRUCK THE CHUTE.

EMPLOYEE WAS PUTTING AIR PRESSURE IN AN OIL TANK TO GET THE OIL OUT(ALTHOUGH HE WAS INSTRUCTED NOT TO). THE TANK BURST AND HIT HIM ON HIS LEFT LEG.

EE WAS STANDING ON ALOWER END OF 357 CONVEYOR BELT. BELT WAS FROSTY. HE WAS HOLDING TO HANDRAIL WITH ONE HAND. HE SLIPPED & FELL, WHILE STILL HOLDING TO RAIL CAUSING HIS BODY TO TWIST.

EMP WAS WALKING FROM REAR RIGHT SIDE OF LOADER TO CAB, WHILE CARRYING LUNCH BOX. SIPPED AND WAS HOLDING TO ANTENNA RATHER THAN GRAB BAR AND FELLTO GROUND.

EMPLOYEE GOT OFF CATERPILLAR 769B. CAUGHT HIS RING ON THE CAT WALK AND IT MASHED HIS FINGER AND CUT IT.

EMPLOYEE TOOK BATTERY BOX LID TO 988B TO CHARGE BATTERY (TO JUMP IT OF) HE PUT THECABLES ON THE LOADER THE CABLES FELL & HIT THE LID TO THE BATTERY BOX THE LID FELL ON EMPLOYEES FINGER

EMPLOYEE WAS PUTTING MOTOR ON JAW CRUSHER HE PICKED MOTOR UP A LITTLE & IT MOVED (SLID) & CAUGHT HIS FINGER & MASHED IT

EE WAS WORKING AT CRUSHER UNDER FEEDER. HE BACK INTO A BOLT (WALKING--TOOK STEP BACKWARDS)

EE WAS GOING TO GET INTO CRANE. HE SLIPPED AND FELL ON ICE.

EMPLOYEE WAS IN 769 TRUCK BEING LOADED. A LARGE ROCK WAS LOADED ONTO THE TRUCK AND IT SHOOK THE TRUCK AND JERKED HIM. HE HAD A SAFETY BELT ON.

EE HAD BEEN WORKING ON A HOIST REPAIRING A SWITCH. THE WIND BLEW AND DEBRIS GOT IN HIS EYE.

EMPLOYEE WAS WORKING TO GET ROCXKS UNJAMMED OIN FEED BOX ON 4 CRUSHER HE WAS PUNCHING ON THE JAMMED ROCKS WITH A ROD TO LOOSEN THEM HE WAS INSTRUCTED BY HIS SUPERVISOR TO MOVE ASIDE TO PREVENT INJUYRH HE DID NOT DO SO & A ROCK FLL TO GROUND& ROLLED AGAINST HIS ANKLE

AS PER PHYSICIANS HEALTH INSURANCE CLAIM FORM DIAGNOSES IS SILICOSES WE WERE MADE AWARE OF THIS AROUND 04-21-93

EMPLOYEE WAS STANDING ON A 5FT LADDER HE WAS APPROX 2FT OFF THE GROUND HE WAS WORKING ON THE RE AR END OF A 988B LOADER WHEN THE LADDER SLIPPED OUT FROM UNDER HIM HIS GRAOIN FELL AGAINST THE EDGE OF LOADER

EE WAS WELDING ON LOADER BUCKET SOMETHING GOT IN HIS EYE.

54736YEE WAS HELPING FIX WATER PUMP.HE FELL INTO DREDGE POND.

EMPLOYEE WAS CARRYING METAL FROM GROUND TO #57 STONE CHUTE ON #57 BIN AT CRUSHER.

EMPLOYEE WAS WORKING AT THE PUG-MILL AT END OF CONVEYOR APPROX. 15' OFF GROUND. IT WAS END OF THE SHIFT & THE PUGMILL WAS SHUT DOWN. THE PUG-MILL OPERATOR NOTIFIED HIS FELLOW EMPLOYEE HE WAS G OING TO RE-START THE PUG-MILL TO CLEAN IT OUT WITH A WATER HOSE. THE EMPLOYEE WAS LOCATED ON A WALK WAY BESIDE THE PUGMILL & TOLD THE PUG-MILL OPERATOR IT WAS OK TO START. EMPLOYEE THEN MOVED

EMPLOYEE WAS WALKING ACROSS A WALKWAY.HE HAD GREASE ON HIS SHOES FROM WORKING ON CRANE.HE SLIPPED AND STARTED TO FALL.HE CAUGHT HIMSELF WITH HIS LEFT ARM AND SPRINED SHOULDER.

EE WAS PULLING SAND BIN DOOR DOOR WAS HARD TO OPEN HE FELT SOMETHING PULLING AND STINGING INSIDE HIS GROIN AREA WHEN HE PULLED DOOR.

EMPLOYEE WAS ON TOP OF AGGREGATE BINS ON WALKWAY. HE TRIPPED ON SOMETHING & FELL CAUSING HIS LEFT ARM TO GO THRU A #57 SCREEN. HIS ARM WAS CUT.

EMPL BACKING WELDING TRUCK INTO PARKING SPACE.BACKED INTO A DIVOT/HOLLOW CAUSING STEERING WHEEL TO SPIN IN HANDS.THUMB WAS JARRED BY THE SPOKE OF STEERING WHEEL CAUSING INJ.

EMPLOYEE WAS IN SHOP TIGHTENING A PIPE IN VICE. HE KICKED HANDLE WITH HIS FOOT TO TIGHTEN IT MORE. HE HURT HIS LEFT ANKLE.

EMPLOYEE WAS IN BACK OF DUMP TRUCK BED WELDING. HE STRUCK WITH HAMMER. HE RAISED WELDING HELMET UP TO CHECK SLAG. A PIECE FLEW OFF & HIT HIM IN EYE.

EMPL WORKING AT CRUSHER WHILE ANOTHER EMPL WAS WELDING.GLARE FROM OTHER EMPL WELDING BURNT EYES.

ANOTHER EMPL WAS USING A GRINDER WORKING ON CONE CRUSHER IN SHOP AREA.THINKS A FRAGMENT OF METAL WAS THROWN FROM WORK AREA INTO HIS EYE.WAS WEARING SAFETY GLASSES WHILE WELDING BUT TOOK THEM O FF WHEN NOT WELDING.

WORKING ON AIR COMPRESSOR, STRETCHED ACROSS FRAME TO REACH AMP GAUGE, FELT A BURNING PULLING ON RIGHT SIDE.

EMPLOYEE WAS INSPECTING 6X16 SECO SCREEN DURING STONE CRUSHING OPERATION AND CLEARING DEBRIS WHEN SOMETHING GOT IN HIS RIGHT EYE.

EMPLOYEE WAS WORKING ON SIDE OF JAW CRUSHER WHEN HE ALMOST FELL. HE CAUGHT HIMSELF WITH HIS LEFT ARM. EMPLOYEE WAS STANDING ON A 3-4' PLATFORM.

EMPL WASHING OUT UNDER CONVEYOR BELT.WIND BLEW HARD AND GOT SAND IN RIGHT EYE.NOT WEARING SAFETY GOGGLES.

EMPLOYEE WAS REMOVING TRANSMISSION FROM FRONT END LOADER WHEN WRENCH HE WAS USING SLIPPED & HIT HIM ON CHEEK UNDER RIGHT EYE

EMPLOYEE WAS USING A PRY BAR TO PRY ROCKS LOOSE THAT WERE HUNG IN CRUSHER CHUTE. THE ROCKS SLID & HIT PRY BAR CAUSING HIS HAND TO BE MASHED AGAINST SIDE OF CHUTE.

I,NAME & ANOTHER EMPLOYEE WERE LIFTING A BATTERY UP TO PUT IN A 988 LOADER. APPARENTLY HE STRAINED A MUSCLE IN THE PROCESS OF LIFTING THE BATTERY. HE WORKED THE NEXT DAY THEN MISSED TWO DAYS.

EMPL WAS STEPPING OFF OF WALKWAY TO A LOWER ELEVATION HIS KNEE CAME IN CONTACT WITH PROTRUDING BAR AND CUT IT

EMPLOYEE WAS STANDING BESIDE LOADER REACHED FOR ENGINE STOP HIS ELBOW WAS CUT BY MOVING FAN BLADES.

EMPLOYEE TWISTED ANKLE ON LOOSE STONE WHILE UNLOADING STOCK BINS. RESULTED IN STRAIN TO LEFT ANKLE, EXPECT FULL RECOVERY.

EMPLOYEE STOOD UP AFTER KNEELING DOWN TO WORK ON EQUIPMENT. WHEN HE DID HI TWISTED HIS KNEE.

EMPLOYEE WAS GETTING OUT OF LOADER WHEN HIS HEEL OF HIS SHOE WAS CAUGHT IN THE LIP OF TIRE HE THEN JUMPED FORWARD AND LANDED ON HIS HEELS AND HURT HIS LEFT FOOT

EMPLOYEE WAS ADJUSTING A BELT WHEN HIS FINGER WAS CAUGHT BETWEEN WRENCH AND ADJUSTING BOLT AND HIS FINGERNAIL WAS RIPPED OFF.

EMPLOYEE WAS TIGHTENING A BOLT ON A CONE CRUSHER DROPPED A WRENCH APPROX. 70 LB ON HIS LEFT FOOT AND BADLY BRUISED 3 TOES JUST BEHIND STEEL ON STEEL TOED SAFETY SHOES.

EMPL COMING OUT OF BLDG FELT HIMSELF BEGIN TO FALL.PUT HAND ON DOORJAMB TO CATCH HIS FALL WHEN DOOR SLAMMED SHUT CRUSHING/SMASHING RIGHT HAND.

I.NAME INJURED 9MPLOYEE WAS WORKING WITH I.NAME AT CRUSHER THEY WERE PULLING A SHEAVE OFF A 200H.P.MOTOR I.NAME WAS TAKING BOLTS OFF WHEN SHEAVE SLIPED OFF BUSHING & CAUGHT HIS FINGER BETWEEN PULLEY & THE MA3N SHAFT

EMPLOYEE WAS WO9KING ON REPAIR TO CRANE BOOM.HE WAS CLAMPING ANGLE IRON ON BOOM FOR WELDING.METAL SLIPPED AND PULLED OFF THUMB NAIL.