Email me when a new MSHA incident is filed at Globe Mill.
EMPLOYEE WAS PUSHING LOOSE SAND WITH DOZER IN SOFT SAND AND WHEN WALKING AWAY HIS RIGHT LEG STARTING HURTING ALSO HIS TOES FELT NUM.
EMPLOYEE WAS GOING TO COLUMBIA MACHINE CO. TO PICK UP A 5 H.P. ELECTRIC MOTOR. EMPLOYEE WAS WATCHING SIGNAL LIGHT AND AS HE GOT THROUGH LIGHT, TRAFFIC HAD STOPPED IN FRONT OF HIM AND HE HIT TH E REAR OF THE CAR.
EMPLS MIDDLE FINGER ON LEFT HAND WAS CAUGHT BY DRILL PRESS & PIECE OF SANDING MATERIAL CUTTING FINGER ABOVE FINGERNAIL. SUTURES RQUIRED TO CLOSE WOUND.
EMPLOYEE COMPLAINED OF SORENESS IN LEFT WRIST AND WAS DIAGNOSED BY DR WILLIAMS AS HAVING TENDONITIS OF LEFT WRIST DUE TO REPEATED MOVEMENT OF OPERATING DOZER CONTROLS.
EMPLOYEE WAS REMOVING LIME ROCK FROM DITCH IN FRONT OF GRIZZLY AT THE FASTER PACE THAN USAL, CAUSING A PAIN TO CATCH HIM IN THE BACK.
EMPLOYEE WAS USING A SHOVEL ON TRACTOR TO CLEAN UP SAND AND ROCK BEHIND LOG WORK. WHEN HE TURNED TO EMPTY SHOVEL INTO BUCKET A CATCH CAUGHT HIM IN HIS BACK.
EMPLOYEE WAS OPENING 6" VALVE IN (UNREADABLE) AND FAILED TO PUT VALVE WRENCH NEAR SPOKE IN WHEEL WHEN HE PULLED WRENCH IT SLIPPED ON WHEEL.
EMPLOYEE WAS DRILLING THE BOTTOM OF A METAL PIPE WHEN THE DRILL BIT SLIPPED AND STRUCK HIM UNDER THE LEFT EYE. LACERATION OF CHEEK UNDER LEFT EYE CLOSURES AND BANDAID APPLIED.
EMPLOYEE CUT HAND WHEN CAN OF WELDING RODS SLIPPED AND JAGGED EDGE STRUCK HIS LEFT HAND.
EMPLOYEE WAS WELDING IN AN OVERHEAD POSTION WHEN A SMALL PIECE OF WELDING SLAG GOT INTO HIS LEFT EAR.EMPLOYEE DID NOT REPORT INJURY UNTIL A WEEK LATER AT WHICH TIME IT BECAME INFECTED.DOCTOR A DMINISTERED ANTIBIOTICS FOR INFECTION.
EMPLOYEE WAS PAINTING AN OVERHEAD PIPE. THE EMPLOYEE STEPPED FROM A STEEL BEAM INTO THE BUCKET OF THE FRONT END LOADE TO BE LOWERED TO THE GROUND.L WHEN THE OPERATOR SHIFTED THE LOADER INTO RE VERSE AND ATTEMPTED TO MOVE THE LOADER ROLLED FORWARD AND PINNED THE EMPLOYEE BETWEEN THE TOP EDGE OF THE BUCKET AND THE FLANGES OF THE BEAM.
WHILE IN THE SITTING POSITION THE EE WAS PAINTING PLANT PIPING OUTSIDE THE BUILDING HANDRAIL. THE LOCATION OF THE PIPE REQUIRED THE EE TO REACH THROUGH THE HANDRAIL. WHEN THE EE ATTEMPTED TO S TAND UP TO MOVE TO A NEW POSITION HIS KNEE TEMPORARILTY POPPED OUT OF SOCKET.
RIGHT HAND WAS CUT WHILE OPERATING A 6" VALVE ON HIGH PRESSURE LINE TO EAST HIGH PRESSURE MONITIR.
MISC OPER CUTTI3G BRUSH ON POND WALL WITH CHAIN SAW DURING 1ST SHIFT.HE HAD CUT BUSH DOWN AND BUSH HAD FELL OVER BUT WASNT COMPLETELY CUT OFF STUMP.WHEN HE FINISHED CUTTING BUSH OFF STUMP SAW KICKED BACK HI7TING OPERATOR ON LEFT KNEE.CUT 1'' LONG VERY SHALLOW,DIDNT BLEED.