Search the record

EE wrote was pitching mud out of k-4 chute and rock rolled down and hit backside of hand and wrist. Doctor put EE on modified duty on 5/8/2019. EE is not to use right arm until follow up appointment.

Cutting new skirt rubber knife came off rubber cut right leg employee received three stitches was put on restricted duty for one week

Was holding up skirt board rubber while pulling a belt on when the pry bar came in contact with the tail pulley pinching finger between the pry bar and I beam. Employee was put on light duty or restricted duty.

Lining up truss on F-5-B with come a long when chain broke hitting EE right wrist. Physician performed procedures Laceration/wound repair at Dearborn county Hospital phone 8125378240

EE was working on the Telsmith #44 tightening bolts. Wrench slipped off the bolt causing him to fall into the belt guard and motor. He received a scraped shin and buttocks. He did not go to the doctor until 5/20/08.

Employee was cutting a toggle bearing out and when he went to pry it off, it fell out and hit his left foot, behind his steel toe.

Employee was installing liners in M-2 Syntrons. The pry bar slipped and hit his upper lip and lacerated it.

EE was trying to unplug the crusher using a pry bar and hammer. While he was driving the bar into the material, he hit his index finger on his right hand. His finger was laid open.

Employee was cutting the belt off on M-17 conveyor and slipped. He hit his knee with the belt and slipped and cut his knee. Due to weather conditions, this was a factor in the injury.

Inj Employee and another employee, were replacing return rollers on m-23 converyor and while trying to break the bolt loose, the bolt broke, causing inj EE to ram his elbow against the trough roller assembly.

He was working in a small electrical box and was stripping a wire and cut his left forearm.

Ee was attempting to pry loose bridged conglomerate from crusher opening. the bridged material came loose and caused the pry bar to hit him in the head.

INSTALLING V-BELT HAD A COME ALONG ON REDUCER TO PULL TURNBUCKLE BACK. COME A LONG CAME LOOSE, REDUCER TURNED AND HIT EE S TAILBONE.

EE WAS USING A COME-ALONG TO REMOVE A MOTOR FROM A SLURRY PUMP. WHILE PULLING ON THE COME-ALONG THE EYE RING IN THE MOTOR BROKE OFF CAUSING EE'S ARM TO HIT A HAND RAIL.

EE WAS PRYING THE COUNTERWEIGHT OFF OF THE FLOAT SIDE BEARING, THE PRY BAR SLIPPED & HIS HAND HIT THE CORNER OF THE COUNTERWEIGHT. IT TORE HIS SKIN.

EE WAS CUTTING THE BELT & LOST HIS FOOTING, CAUSING HIM TO CUT HIS FINGER.

EE WAS USING A PORTAPOWER AND WHEN THE PRESSURE WENT UP HYDRAULIC FLUID LEAKED AND HIT EE IN THEEYES. (THE PRESSURE IN THE HYDRAULIC HOSES CAUSED THE FLUID TO SPRAY FROM OUT AROUND COUPLINGS).

EE WAS SWINGING A SLEDGE HAMMER, HITTING A BOARD TO INSTALL THE HOUSING. THE HAMMER KICKED BACK AND EE'S HAND HIT A PIN ON THE SHAKER.

EE WAS ATTEMPTING TO DISLODGE A ROCK FROM THE GRIZZLY, WITH A SLEDGE HAMMER, AND THE ROCK HIT HIM IN THE CHIN.

THE MEN WERE REMOVING A TAIL PULLEY, USING A PULLING BAR TO MOVE THE BELT BACK AND THE LUG BROKE. THE CHAIN AND LUG OFF OF THE BAR HIT INJURED IN THE FACE.

EE WAS HOOKING UP COMEALONG AND BENT HIS LITTLE FINGER BACK.