Milton Plant Metal/Non-Metal

Employee was struck by a small piece of metal in their nose as EE was helping on changing an anvil in the crusher. The employee had to have the metal removed and stitches for wound closure.

Employee was struck by a falling rock from the level above were EE was working. The employee received a cut to the back of EE's head which required 2 stitches to close.

Employee was in impact crusher welding - employee was on knees. When EE stood up EE felt pain in lower back and left leg.

EE was working on front suspensions of pickup truck. He was holding a breaker bar with socket on a nut while other EE was using a 1" drive air powered impact wrench to loosen nut when the breaker bar spun pinching ring finger between shock and breaker bar.

Employee stepped out on catwalk of loader to clean windows when he felt something pull in his left knee area.

EE was guiding inside part of breaker into case of main breaker when it pushed forward pinching finger between both parts cutting end of little finger almost off.

EE WAS USING TORCH TO CUT A BUSHING INSIDE A BREAKER HAMMER WHEN IT BLEW BACK HOT GREASE THAT WAS TRAPPED INSIDE THE BUSING AND CASE CAUSING HOT GREASE TO LAND ON HIS NECK.

BAR BROKE ON CRUSHER. EE WAS TURNING BAR ON IMPELLER WHEN BAR CAUGHT THUMB ON RIGHT HAND.

EMPLOYEE WAS TRYING TO START WATER TRUCK. HE POURED GAS IN THE CARBURETOR OF THE TRUCK AND THE ENGINE BACKFIRED AND IGNITED THE GAS.

EMPLOYEE WAS REMOVING WATER PIPES SO CRANE COULD REMOVE STONE CRUSHER. AS EMPLOYEE WAS REMOVING WATER PIPES A CLUMP OF LIME DUST FELL OFF OF SIDE OF STONE BIN STRIKING EMPLOYEE IN RIGHT EYE U NDER SAFETY GLASSES.

EMPLOYEE WAS LOADING WITH SHOVEL AND DIRT FLEW IN RIGHT EYE. THEY REMOVED A PIECE OF STONE FROMHIS RIGHT EYE.

EMPLOYEE WAS DOING VARIOUS JOBS THROUGHOUT THE DAY. HE DID NOT REALIZE ANYTHING WAS IN HIS EYE UNTIL LATE IN THE DAY. IRRITATION BECAME MORE INTENSE AND HE DECIDED TO GO FOR AN EXAMINATION. DO OCTOR FOUND A PIECE OF STEEL IN HIS RIGHT EYE.

EMPLOYEE WAS RUNNING DROPBALL. HE WAS PULLING ON THE LEVER AND INJURED HIS RIGHT SHOULDER.

54736YEE WAS PULLING ON LEVER ON THE DROPBALL AS HE WAS RUNNING IT.

EMPLOYEE WAS OPENING THE CHUTE ON THE 3A BIN.HE PULLED ON THE LEVER TO LOAD A TRUCK AND SPRAINED HIS RIGHT WRIST.

EMPLOYEE WAS PRYING ON HOIST CYLINDER TO PUT PIN IN MACK STOCK TRUCK.

TWO EMPLOYEES WERE CUTTING DOWN TREES ON THE HILL AT THE EAST SIDE OF THE QUARRY WHEN THE TREE BEING CUT BY THE OTHER MAN FELL ON TOP OF I,NAME TWISTING HIS RIGHT ANKLE.

EMPLOYEE WAS CUTTING A HOLE IN A BUCKET OF GREASE WITH A POCKET KNIFE, WHEN THE KNIFE SLIPPED AND CUT HIS LEFT ARM AT THE WRIST.

EMP. WAS PUTTING TOP ON CONE CRUSHER. CHAIN HOIST SLIPPED AND TOP OF CHUTE WENT U IN THE AIR AND CAUGHT EMP. RIGHT INDEX FINGER CUTTING IT ON THE CHUTE ABOVE.

EMPL BREAK WEDG9D MATERIAL TO ALLOW MATERIAL TO FEED INTO CRUSHER.ROCK LYING ON REAR DOME AREA.WHILE BREAKING WEDGED ROCK,ROCK LYING ON DOME SLID AND CAUGHT EMPL RIGHT ANKLE.PRECAUTIONS TAKEN SUPT ASSISTING3EMPL.ROCK LYING ON DOME CHECKED FOR STABILITY AND DETERMINED OK.WHEN ROCK BROKE IT FELL INTO CRUSHER AND STARTED BREAKING CAUSING VIBRATIONS LOOSENING ROCK ON DOME CAUSING IT T

EMPLOYEE WAS USING A COME-A-LONG TO LOOSEN UP WHEEL OF A PLUGGED CAGE MILL. HE WAS USING HIS FOOT TO PUSH ON THE COME-A-LONG (BECAUSE IT WAS PISITIONED AT FLOOR LEVEL FOR CONNECTION). HIS FOOT SLIPPED OFF THE HANDLE, BRUISING AND LACERATING HIS LEFT SHIN.