Soiland Co., Inc. Metal/Non-Metal

The employee was conducting plant maintenance. The employee was pushing on lever to operate a gate door on screen 1. Lever would not move the gate due to debris around the gate. The employee pushed harder on the lever to get the gate to move. The employee felt a sharp pain in the lower back at the time the gate finally moved into the desired position.

Employee was cutting a conveyor belt on the ground. Employee knelt down onto a nail that was still in the mat that was used to secure the conveyor belt while in its rolled up position. Employee sustained a puncture wound to EE's left knee.

Employee was doing her daily weighmaster scale duties when she started to say her left hand hurt.

Employee had belt on the ground. Cutting with left hand using a utility knife, when the knife jumped over the straight edge & cut inner top part of right thumb.

Steel fabricating all morning while installing part I got a sliver of debris in my eye.

EE was working at her computer when she noticed that her right hand was hurting and swollen.

Employee was washing his face after grinding a pulley and got some fines and dust in his left eye.

Employee used head of left foot to stomp down on lever locking bucket on bobcat.

Employee was clearing trees and brush with a chain saw. While clearing debris with his right hand, he held the running saw with his left hand and it touched his leg.

Was hand pickng debris ofof conveyor belt. Wind was blowing cross ways. Debris got in the side of the glasses and rock or debris was under his eye. Flushed at eye wash station and used another eye wash at home but still sore next day.

Employee was helping load a piece of equipment into a trailer with a crane when the equipment swung left pinning his inner left leg against trailer wall.

Mechanic fell as a result of pulling on a piece of metal while testing integrity of the weld. Said employee fell to the ground and was struck by the metal in the back and neck after hitting the ground.

Lifting camper shell onto truck bed. After putting camper shell on truck bed EE had a sharp shooting pain in r upper shoulder.

WHILE ATTEMPTING TO CHANGE THE BELTS ON THE JAW CRUSHER, THE MOTOR NEEDED TO BE REPOSITIONED. WHILE REPOSITIONING THE MOTOR, A BOLT BROKE WHICH CAUSED THE MOTOR TO FALL, SMASHING EE FINGER BETWEEN THE MOTOR AND GUARD

EE WAS CLIMBING LADDER TO TIE OFF AT TOP WHEN THE LADDER SLIPPED, SENDING HIM TO THE GRAVEL SURFACE BELOW. IT WAS LATER DETERMINED THAT HE HAD FRACTURED HIS RIGHT ARM.

UNCHAINING A BUNDLE OF 12 X 12 CRIBING THAT HAD BEEN MOVED WITH TO 988B CAT LOADER. ONE ROLLED OFF THE STACK & LANDED ON THE TOP OF HIS RIGHT FOOT.

EMPLOYEE FAILED TO TURN ON MAIN CRUSHER BEFORE OPERATION BEGAN, CAUSING THE CONE TO FILL WITH 8" TO 6" ROCK. ROCK HAD TO BE REMOVED BY HAND. WHILE REMOVING ROCK A ROCK FELL ON HAND SMASHING MI DDLE FINGER RIGHT HAND.

EMPLOYEE WENT TO PICK UP A 2# HAND GRINDER TO USE ON A LOADER, FELT A SHARP PAIN IN BACK. MENTIONED PAIN TO OTHER EMPLOYEE, DID NOT REPORT TO SUPERVISOR UNTIL 6:15PM. AT THIS TIME HE WAS TOLD TO GO TO THE EMERGENCY ROOM TO HAVE IT CHECKED.

EE FAILED TO SECURE LADDER WITH ROPE BEFOR GREASING APRON FEEDER. LADDER SLIPPED AND EE FELL APPROX. 8 T 10' TO GROUND BELOW. ABRASION TO LEFT EYEBROW, 3 STITCHES REQUIRED--LEFT WIRST AND CHES T SORE FROM FALL.

EMPLOYEE WAS ATTEMPTING TO DISLODGE A ROCK JAM IN MAIN CRUSHER WITH A CROW BAR. THE CROW BAR SLIPPED SMASHING HIS FINGERNAIL ON THIRD FINGER RIGHT HAND.