Search the record

HE WAS HELPING MOVE A GEAR BOX, WHEN THE SHAFT HE WAS HOLDING BROKE, SNATCHING & SPRAINING HIS RIGHT HAND. AFTER REST DID NOT HELP THE HAND TO HEAL, SURGERY WAS PERFORMED ON 4/18/02 TO REATTAC H A LOOSE LIGAMENT IN THE HAND.

EMPLOYEE WAS IMPROPERLY REMOVING A DRILL BIT ON A FACE HOLE. THE BIT WAS SITTIG ON THE GROUND AND HE REACHED UNDER THE TABLE TO LINE THE BIT UP WITH THE HAMMER AS IT CAME DOWN. HIS THUMB WAS T OP OF THE BIT WHEN THE HAMMER CAME DOWN, AMPUTATING HIS LEFT THUMB. GLOVES WERE ON.

WAS TIGHTENING THE TENSION ROD AT THE PRIMARY CRUSHER WHEN THE ROD BROKE, AND THE TORQUE EXTENSION HANDLE END RAKED ACROSS HIS HAND CAUSING A DEEP LACERATION REQUIRING STITCHES TO CLOSE.

EE WAS MEASURING FOR WEAR PLATE C TWIN SAND SCREW WHEN HE WAS GETTING DOWN TO STRIKE HIS UPPER LIP INTO SAND SCREW. EE WAS WEARING ALL REQUIRED PPE PLUS SAFETY HARNESS.

EE WAS USING A PRY BAR TO REMOVE A ROCK FROM A CHUTE. THE BAR SLIPPED & HE HIT HIS FINGER ON THE EDGE OF THE CHUTE

EE WAS LIFTING SCREENS INTO PLACE ON THE BOTTOM DECK OF #2 SCREEN.

TIGHTENING TAIL PULLEY ADJUSTER NUT WITH 3/4" DRIVE RATCHET. RATCHET SLIPPED OFF OF NUT, CAUSING EMPLOYEE TO CUT PINKY FINGER ON RIGHT HAND BETWEEN RATCHET HANDLE AND ROCK ON THE GROUND.

EE WAS RAISING THE BALL LATCH ON THE GREASE TRAILOR WHEN HE TOOK PIECE OF STEEL PIPE AND TRIED TO KNOCK THE LATCH UP. WHEN HE DID HE SMASHED HIS LEFT RING FINGER BETWEEN THE PIPE AND THE THREE WAY HITCH.

WHILE TIGHTENING THE SCREWS TO A BREAKER IN AN ELECTRICAL BOX THE SCREWDRIVER MADE CONTACT WITH THE METAL FRAME CAUSING AN ELECTRICAL SHORT & F LASHBURNS TO EE'S EYES. HE WAS GIVEN PRESCRIPTIO N FOR HIS EYES.

WHILE TIGHTENING THE SCREWS TO A BREAKER IN AN ELECTRICAL BOX THE SCREWDRIVER MADE CONTACT WITHTHE METAL FRAME CAUSING AN ELECTRICAL SHORT AND ELECTRICAL BURNS TO EMPLOYEE'S FACE, EYES AND FOREARM.

EE HAD BEGUN CLIMBING A LADDER. HE HAD 2 SODAS IN HIS LEFT HAND AND WAS THEREFORE USING HIS LEFT ARM ON THE LADDER RUNG RATHER THAN HIS HAND. HE BEGAN WITH HIS LEFT FOOT ON THE 1ST RUNG AND RT . HAND ON A RUNG ABOUT HEAD HEIGHT. WHEN HE TRANSFERRED HIS WEIGHT ON RT. FOOT ON 2ND RUNG HIS FOOT SLIPPED CAUSING HIM TO FALL ABOUT TWO FEET TO THE GROUND CAUSING A SPRAINED ANKLE & CRACKED

PAD EYE ON JAW PLATE PULLED LOOSE NA DHIT EMPLOYEE ON THE LEFT SIDE OF NECK REQUIRING 4 STITCHES.

EMPLOYEE WAS CLIMBING OUT OF A CHUTE WHEN HIS FOOT SLIPPED AND HIS KNEE TWISTED.

EE WAS LOADING TRUCKS WITH A 980F WHEEL LOADER. THIS LOADER HAS FINGERTIP CONTROL AS TO SPEED AND BUCKET MANEUVERABILITY. EE NOTICED A STINGING SENSATION IN HIS RIGHT SHOULDER. AFTER SEVERAL H OURS THE PAIN DID NOT SUBSIDE SO MEDICAL ATTENTION WAS SOUGHT.

EMPLOYEE WAS PLACING SCREENS IN #2 SCREEN. HE WAS LYING ON HIS BACK BETWEEN DECKS 1 & @. HE WAS TURNING TO GO IN A BETTER BOYD POSITION WHEN HE STRUCK A SHARP PORTION OF THE UPPER DECK FRAME . WITH HIS RIGHT CHECK RESULTING IN A SMALL CUT IN WHICH THREE STITCHES WERE TAKEN.

EMPLOYEE WAS PRYING A ROCK LOOSE IN FEED HOPPER. IT ROLLED WHEN FREED AND STRUCK HIM IN LEFT KNEE.

EE WAS ATTEMPTING TO CLEAR A ROCK FROM THE TAKE UP PULLEY. EE WAS STANDING ON THE GROUND WITH LEFT HAND HOLDING THE PIPE THE TAKE UP PULLEY WEIGHT OPERATES IN. HE SIGNALED FOR THE BOLT TO BE B UMPED AROUND WHICH SHOULD CLEAR THE ROCK. WHEN THE BELT (BOLT?) WAS BUMPED THE COUNTERWEIGHT SWUNG SIDEWAYS PINCHING EMPLOYEE'S LEFT INDEX FINGER.

INJURED PERSON WAS ASSISTING IN THE REMOVAL OF A MOTOR SHIV ON THE PRIMARY JAW CRUSHER. UPON DISASSEMBLY THE SHIV FELL TO THE GROUND PINCHING HIS LITTLE FINGER ON THE LEFT HAND BETWEEN THE SHI V AND THE GROUND.

INJURED WAS CARRYING A PIECE OF METAL TUBING TO BE USED FOR A SCALE GUARD. HE SLIPPED AND FELL AND THE TUBING (WEIGHING 60-80 LBS) LANDED ON HISLEFT HAND.

FELL THROUGH JAW CRUSHER APPROX 10' MOVABLE JAW WAS NOT STATIONARY-EMPLOYEE WAS REMOVING A WEDGE.

THE EE WAS CHANGING A TOOTH ON HIS LOADER. HE USED A HAMMER TO HIT THE TOOTH AND LOSING IT UP. WHEN HE HIT THE TOOTH ON THE POINT END A CHIP CAME OFF AND HIT HIM IN HIS LEFT UPPER ARM BICEP.