Buscar en el registro

He was bolting in low top, he was pushing up a bolt with his left hand to get on the pod to push up and strained his left shoulder.

Was parking block at '14450 in between entries #2 & #3, a truss bolt broke, the strap came down hitting him on the hard hat sliding down to his right wrist. He was seen at the hospital and released to work. On 6/19/2015 he was placed on restricted duty.

Was hand dragging a bolter cable down the #1 entry in 3-Left, he had the bolter cable over his right shoulder when the cable got hung on a rock, he felt his right shoulder pop.

Was standing up hog panel and strained his abdomen.

Employee was putting floor grading at the belt drive, a strap fell between the grading and frame and when he reached for it he pinched his finger between the grading and frame. (Fractured left index finger)

Employee reported on 2/4/2015 that on 1/16/2015 he bumped his left knee against a knob on the side of a scoop.

crew was off loading 42" structure when he caught his finger underneath the bottom roller causing a laceration. (required stitches)

On a bolter he had the rub-rail off the operator's side of the mass, working on the suction hose. He went to put it back on and felt a pop in his groin area.

Was roof bolting when the lower drill steel became stuck in the drill pot. While trying to remove the steel from the drill pot, an upper section of the drill steel fell from the bolt hole, striking the employees right hand.

Was running jumper hoses from the pump car to the monorail. Was dragging a 50 ft. section when he collapsed with back pain.

Was pulling cables through trollies, felt pain in abdomen

When opening the door of the Sandvic LS195 while still in the cab. His hand was caught between the cage on the door and the cage on the frame; causing his finger when opening the door to be smashed between the door and the frame.

He was standing a 25 stack of hog panel up when the previous stack became dislodged. Falling onto the employee striking him in the face.

Employee just stepped through an approximate 3' x 3' mandoor at xc22, the air caught the door and slammed it shut abruptly. Employee was holding onto the door handle with his right hand, as the door slammed shut, he pulled his hand away quickly and his index finger was struck by the door or he struck his hand on the door frame.

He was standing behind a Kubota putting a tire in the bed, the tire caught on the corner & he felt a pop. We received a note from the doctor to place him on restricted duty on Oct. 1, 2014

Was pulling out a VFD inverters out of cabinet to clean and the inverter fell out and cutting employee's finger

While lifting the hitch on a trailer, strained her back.

While loading a structure trailer into the belt-line, a crew member grabbed a rail and started to load, as he jerked the rail out he struck ee in the nose.

Miner was bending over to move miner cable & felt a sharp pain in his lower back.

Was loading hog panel onto bolter from side of machine. A stack fell against bolter catching his arm causing laceration.

Employee was moving continuous miner cable out of the entry in preparation for mining. When he lifted the cable to his waist he felt a sharp pain between his shoulder blades and shot down his back. He went down on the ground and had lost the feeling from his shoulders down. No physical damage has been identified by the medical testing.

Employee was using a roof bolting machine to install chain hangers in preparation for a belt move. While pushing a steel back into the drill hole, the steel suddenly angled off to one side. As the employee reached to straighten the steel it recoiled back, striking his left index finger. The impact fractured the finger.

Employee was shimming up under a small column held in place with a chain fall and it shifting slightly, catching his right hand in a pinch point. The employee was wearing metacarpal gloves at the time.

Employee was operating a roof bolter, installing wire mesh on the corner of a pillar. He leaned over to pick up a section of mesh from the floor, while on the drill deck and pulled a muscle in his back. He sought medical attention on 9/16/2013. Medical provider placed employee on restricted duty. Employee returned to work under these restrictions.

Two employees were moving top roller assemblies up against the rib. They had moved several without incident. While moving the roller, the employee felt a pop in his lower back resulting in a back strain injury.

Employee was setting concrete form work at new retaining wall and aggravated an existing shoulder injury.

Employee was helping lower loads into the slope house. The load got too close to the perimeter cable on the floor and he stuck his foot out to push the load away from the cable with his foot, causing a sprained foot.

The crew was conveying fan line down the shaft, and the fan line caught the head frame. The wind gust knocked the line loose and struck the injured worker in the left forearm.

While employee was mucking he reported his back was bothering him. On 8-27-2012, he was taken in for medical evaluation.

EE was handling a piece of sheet metal when it slipped through his hands and lacerated left forearm.

EE was at bottom of shaft when he looked up to the work deck grout dropped in his eye.

As the employee stepped onto the steps to enter the maintenance trailer, he tripped but did not fall. As he tripped, he reached out to catch himself and in the process, he dislocated his shoulder.

Person had strained a muscle in his back off the job at home. He re-strained the muscle hooking up a tow cable at work.