Search the record

Operator was cutting a conveyor belt section. EE was almost all the way through the belt when the knife slipped through and hit EE's upper leg. About 8" up from the knee.

EE was adjusting a tail pulley with a breaker bar. EE was using a wrench to loosen the pulley when the breaker bar loosened suddenly, causing EE's body to jerk and fall to ground landing on right knee. Injury resulted in an indicated meniscus and ACL tear.

Employee was using a bar to poke chute when a rock fell onto the bar. Employee held on to bar as it pulled him, causing a muscle strain in his left shoulder

Cutting rubber tabs off of a screen panel. Knife slipped and cut left index finger. 3 stitches were required. Returned to work the same day.

Using pry bar and porter power to repair water drain for belt press. Pry bar slipped and jarred his left arm. Neck Sprain.

While using a utility knife, the knife slipped off and he cut his leg. Stitches.

Employee was using a hoe to pull rock off of shot. Another rock rolled off screen and struck ee in month. We recently received aother and dx from dentist.

Installing wedges that hold ball liner in crusher. Was holding wedge in one hand and using hammer in other hand. Struck tip of right thumb with hammer.

Putting platform on drill rig, when wrench he was using slipped off. Left arm slipped and he felt pain in left shoulder. Shoulder strain.

EE WAS UNWIRING MOTOR OF BLACKTOP PLANT. MOTOR WAS TAPED WITH ELECTRICAL TAPE- EE WAS CUTTING TAPE OFF WITH RAZOR KNIFE. KNIFE SLIPPED AND CUT THROUGH GLASS, LACERATING RIGHT INDEX FINGER.

EE WAS WORKING ON CRUSHER LOOSTENING MOTOR BASE BOLTS. LEFT HAND SMALL FINGER WAS PINCHED BETWEEN WRENCH & MOTOR BASE.

PULLING UTILITY KNIFE ACROSS STIRTING A SECONDARY CRUSHER. KNIFE SLIPPED & LACERATED R FOREARM.

HAMMERING WEDGE THAT HOLDS 4' CRUSHER TIGHT, MISSED WEDGE AND STRUCK LEFT SMALL FINGER.

TIGHTENING BOLTS IN CRUSHER - STRAINED BY PULLING ON RATCHET. SAW OWN CHIROPRACTOR - FEW SESSIONS.

OPENING UP CHAIN LINK USING HAMMER. STRUCK LT. THUMB WITH HAMMER.

DRIVING TRACK CHAIN PIN IN PLACE WITH 12 LB. SLEDGEHAMMER. A CHIP FROM TRACK PIN LACERATED INSIDE OF LT. THIGH.

CUTTING A FLOOR MAT FOR THE TRUCK, USING UTILITY KNIFE. KNIFE SLIPPED AND LACERATED RIGHT UPPER THIGH.

WHILE CUTTING USED CONVEYOR BELT, SLIPPED WITH UTILITY KNIFE AND LACERATED LEFT HAND AT BASE OFTHUMB.