Search the record

Plant Manager was reversing the rotation(polarity) of the sand screw motor at the electrical panel which created an arc flash in the panel

Miner was connecting pipe which was suspended from forklift to a fixed flange, as miner leaned down to connect the flanges, forklift boom moved abruptly, pushing the miner with the boom, causing the miner to fall forward & down into a hyperextended position. Miner was evaluated by physician and released with no restrictions. Miner was prescribed 800 mg Ibuprofen for contusion.

Normal working conditions. Dry, clear mid 50's temperatures. Production activities

Miner was asked to tighten the clamp rail bolts on the outside of shaker screen. As EE turned, EE immediately ran into the handle of a ball valve at the end of a spray bar striking EE in the left eye. EE suffered a cut/laceration to the bottom of EE's eyelid. EE was released from the ER with eye drops & a follow up with a ophthalmologist.

No adverse conditions. The fall site is a ladder and catwalk next to a log washer. This washplant is located inside a building. Environmental conditions are not a factor.

Worker was cutting a rubber boot on the wash plant using a razor blade in right hand. While cutting, the blade slipped and cut left hand ring finger.

Laborer was standing in the mud picking shack. EE felt pain in EE's elbow while removing mud clods from the conveyor belt.

The worker slipped and fell on tailbone. The conditions were very slick due to ice and snowpack.

The miner was cutting a zip tie wrap using a razor blade knife. While cutting, the blade slipped from the zip tie and cut the miners thumb. The cut required 4 sutures.

Mine worker was picking chunks of mud from the feed conveyor belt. Worker felt a strain and soreness in upper wrist/forearm area.

The miner was working with another worker to move a 400 lbs. roll of conveyor belting and hurt back.

Two workers were moving pit pumps. The flange's on the poly pipe had to be removed. The fourth bolt would not come off, and the pipe was being held up by a chain that was attached to the excavator. EE used a torch to remove the bolt. When it came off, the poly pipe struck EE in the forehead.

The miner was cutting belting with a box cutter when the knife slipped and they cut their leg.

The right side ride control went out on the loader causing the seat to bounce.

The miner was picking mud at a mud picking station. As the miner was reaching to throw a chunk of mud from the conveyor, ee strained back.

While removing electrical motor from conveyor employee twisted back causing severe pain, Fredrick Mills #52723 ,stacking conveyor C432