Search the record

A fully trained miner was fatally injured while attempting to remove a splice pin from a 72" mechanical belt splice. The splice was positioned near the outby side of the tail frame. The victim was positioned between the bottom conveyor belt and the top conveyor belt. Investigation is on-going by company, state and federal officials.

FMC employees were attempting to seal the hoist shaft at the Bremen Portal at Ken American Paradise Mine No. 9. Steel beams were welded in place metal decking was secured covering the shaft. Methane accumulated in the shaft and caused a series of two explosions 4-5 seconds apart. The second explosion killed FMC employee. No other fatalities or injuries occurred.

Oil leak was noticed during operation of the end loader. Foreman instructed operator to block the machine & went to get oil. Returned & found EE under the machine looking for the leak. Loader had been raised by tilting the bucket on the ground. Foreman got under machine to help look. Machine came down on top of them shortly after that, just as foreman saw that it was not blocked.

The 12 East longwall had mined out of seam from 3-10 shield. Shield tip to face had been roof bolted so the coal floor could be removed. The victim was standing with his back to the face. A rib struck the victim measuring 12' long by 4' wide by 1' thick. The victim was a trained and experienced longwall supervisor. The roof control and protective equipment were compliant.

EE was operating the company #24-43 Wagner ST 2DS Can-setter at x-cut #11 in B Canyon,#2 entry in the 23rd East intake. When the victim was found, he was unconscious & unresponsive, his mid torso was pinned in the articulation area of the machine. His feet were in the cab & he was seated in the seat. CPR was administered. The victim was pronounced dead upon arriving on the surface.

A fatal accident occurred on the longwall face around #144 shield. A ladder line hose got pinched under the toe of the #144 shield. EE did not see hose under shield and initiated the electronic push of the pan-line. The hose that was pinched under the toe of the shield, stretched by movement of pan-line, broke apart and high pressure emulsion fluid struck victim as he traveled by.

EE was cutting grass with 7300 compact track loader w/attached brush hog. For some unknown reason the machine lost traction and slid down small embankment into water. Cause of incident unknown at this time. Compliance with rules/reg not a factor, mining equip/system unknown to be a factor, but was used, PPE not a factor, job skills/miner proficiency/training/attitude not a factor.

Employee was directing an end loader towards himself to hook a strap to it for removal of a dolly that was used to move the hi-wall miner launch. Contributing factors were attempting to hook a 6' strap while standing in front of this moving machine and stationary dolly. Cause was human error/bad judgement by the victim and end loader opr.

The victim was leaning over a base lift jack housing. The molded casing catastrophically failed striking the victim in the chest from unknown/undetectable reasons. Cause was catastrophic failure of the housing. Compliance with rules/regs, protective items not a factor, miner proficiency may be a factor, mining equip/systems may be a factor.

On Thursday August 16, 2007 an outburst occurred during rescue work on the Main West panel. The outburst occurred in the No. 1 entry inby crosscut #126. Rescue work was ongoing to remove coal and debris which had filled the No. 1 entry during an outburst that occurred on August 6, 2007.

On Thursday, August 16, 2007 an outburst occurred during rescue work on the Main West Panel. The outburst occurred in the No. 1 entry inby crosscut 126. Rescue work was ongoing to remove coal and debris which had filled the No. 1 entry during an outburst that occurred on August 6, 2007.

On Thursday, August 16, 2007 an outburst occurred during rescue work on the Main West Panel. The outburst occurred in the No. 1 entry inby crosscut 126. Rescue work was ongoing to remove coal and debris which had filled the No. 1 entry during an outburst that occurred on August 6, 2007.

On August 6, 2007 at 2:50 am a bounce/outburst occurred at the Crandall Canyon Mine. It affected the current mining location in the South Barrier of West Mains extending outby to approx. X/C 119. The outburst affected all 4 entries and rescue operations were begun immediately. Rescue operations to reach the miners were unsuccessful.

On August 6, 2007 at 2:50 am a bounce/outburst occurred at the Crandall Canyon Mine. It affected the current mining location in the South Barrier of West Mains extending outby to approx. X/C 119. The outburst affected all 4 entries and rescue operations were begun immediately. Rescue operations to reach the miners were unsuccessful.

On August 6, 2007 at 2:50 am a bounce/outburst occurred at the Crandall Canyon Mine. It affected the current mining location in the South Barrier of West Mains extending outby to approx. X/C 119. The outburst affected all 4 entries and rescue operations were begun immediately. Rescue operations to reach the miners were unsuccessful.

On August 6, 2007 at 2:50 am a bounce/outburst occurred at the Crandall Canyon Mine. It affected the current mining location in the South Barrier of West Mains extending outby to approx. X/C 119. The outburst affected all 4 entries and rescue operations were begun immediately. Rescue operations to reach the miners were unsuccessful.

On August 6, 2007 at 2:50 am a bounce/outburst occurred at the Crandall Canyon Mine. It affected the current mining location in the South Barrier of West Mains extending outby to approx. X/C 119. The outburst affected all 4 entries and rescue operations were begun immediately. Rescue operations to reach the miners were unsuccessful.

On August 6, 2007 at 2:50 am a bounce/outburst occurred at the Crandall Canyon Mine. It affected the current mining location in the South Barrier of West Mains extending outby to approx. X/C 119. The outburst affected all 4 entries and rescue operations were begun immediately. Rescue operations to reach the miners were unsuccessful.

EMPLOYEE WAS APPARENTLY INSPECTING CONVEYOR BELT TAKE-UP AT 2ND M.NORTH DRIVE WHEN HIS LEFT ARM BECAME ENTANGLED BETWEEN THE BOTTOM BELT AND THE STATIONARY ROLLER, CAUSING AVULSION LEFT ARM AN D FACIAL INJURIES. ACCIDENT IS CURRENTLY UNDER INVESTIGATION BY COMPANY, STATE AND MSHA OFFICIALS. AUTOPSY PENDING.

A MINER OPERATOR WAS MINING IN THE M-2 (010-0) SECTION IN THE #23 ROOM BETWEEN #9 & #10 ENTRY. WHILE MINING THE 2ND HALF OF THE CUT A PIECE OF ROCK FELL FROM THE ROOF. THE ROCK STRUCK THE MAN ON THE HEAD. THE ROCK WAS APPROX. 15'4"L X 105" W X 0-4"T

WHILE HELPING TO INSTALL STEEL ARCHES A ROCK APPROXIMATELY 89"X33"X5"-14" DISLODGED FROM THE MINE ROOF STRIKING THE VICTIM

EE WAS ASSIGNED TO BURN AND WELD ON A BELT CONVEYOR TRANSFER. AFTER RETURNING FROM LUNCH. THE EE STARTED TO BURN METAL WHEN A SLAB OF RIB CAME LOOSE STRIKIN GHIM. CAUSING FATAL INJURIES SIZE O F ROCK 2'X4'X10'.

VICTIM WAS OPERATING THE REAR 20 TON LOCOMOTIVE OF A TRIP CONSISTING OF 4 CARS AND 2 LOCOMOTIVES. A PIECE OF STEEL (8/X20'X1") ON THE CAR ADJACENT TO THE REAR LOCOMOTIVE CAUGHT ON THE RIBLINE AND CAME OVER TOP OF LOCOMOTIVE THAT VICTIM WAS OPERATING, STRIKING VICTIM. ACCIDENT REMAINS UNDER INVESTIGATION AT THIS TIME.

A SURFACE HAULAGE FATALITY OCCURRED ON ONEIDA MINE NO. 1 REFUSE HAUL ROAD. A MACK RD888SX TANDEM DUMP OPERATED BY THOMAS DAVIE STUMP TRAVELED DOWN GRADE FOR APPROX 5 MILE AND WENT THRU THE BER M AND OVERTURNED, KILLING EE WHO WAS RIDING IN THE PASSENGER SEAT.