Registro de la MSHA sobre PLANT #21 (ID de mina 4701100). Muertes, incidentes no mortales agrupados por año, operador y controlador actuales, y contexto de la mina.
Avísenme cuando se presente un nuevo incidente de la MSHA en PLANT #21.
HE INDICATES HE FELL FROM HIS TRUCK AFTER GREASING THE DRIVE SHAFT. CLIMBING DOWN, HIS FOOT SLIPPED AND HE FELL ONTO HIS BACK, LANDING ON THE GROUND.
EE INJURY OCCURRED WHILE WELDING ACROSS FROM ANOTHER WELDER.
INJURED HAD BEEN KNEELING ON THE METAL FO A FRONT END LAODER BUCKET AND THINKS THATS WHAT CAUSED SWELLING ON HIS KNEE.
AFTER CUTTING A PIECE OF METAL RECTANGULAR TUBE, HE ATTEMPTED TO PUT THE TUBING ONTO THE WELDING TABLE AND HIS THUMB GOT SMASHED BETWEEN THE TABLE AND THE TUBING.
EE WAS PUTTING AWAY SCREENS WHEN ONE SCREEN SLIPPED CAUSING THE LACERATION IN THE PALM OF THE R HAND.
EE WAS GRINDING ON METAL WHEN A PARTICLE BECAME LODGED IN HIS EYE EE REPORTS THAT HE WAS WEARING PROTECTIVE EYEWEAR AT THE TIME.
EE REPORTED ON 2-14-91 THAT HE HAD EXPEREINCED PAIN IN HIS ELBOW WHILE LIFTING AN OBJECT. HE SO7UGHT MEDICAL ATTENTION AFTER PROBLEM FAILED TO CLEAR ISTSELF.
WHILE PERFORMING A BRAKE JOB, EE REPORTS THAT HIS L THUMB NAIL WAS PINCHED BETWEEN SPRING LOADED BRAKE SHOES.
EE REPORTS THAT AS HE WAS DRILLING INTO A LARGE BOULDER A PIECE OF CLAY DISLODGED AND FELL ON HIM.
INJURED REPORTS THAT WHILE PERFORMING MAINTENANCE ON THE SAND STACKER, HE HIT HIS HAND WITH A HAMMER.
I.NAME HAMMERING WEDGES FROM THEIR PINS ON A SCREEN DECK.A WEDGE FLEW UP AND HIT HIM IN EYE.
I NAME REPORTS HE EXPERIENCED PAIN AS HE WAS ASSISTING ANOTHER EMPLOYEE LIFT A HEAVY PART
EE REPORTS A PIECE OF METAL BECAME LODGED IN HIS KNUCKLE WHILE REPAIRING UNDERCARRIAGE OF D-6 DOZER.
HE REPORTS THAT HE WAS HITTING A BEARING ON A CLUTCH SHAFT WITH A HAMMER, WHEN A PIECE BROKE OFF AND WENT INTO HIS RIGHT LEG.
HAVING LUNCH,SLIPPED AND GRABBED ONTO SOMETHING TO BREAK FALL.WHEN HE LANDED A BLOCK OF WOOD FELL AND SMASHED MIDDLE FINGER.
WHILE AIR-ARCING NEAR SHOP,GUST OF WIND BLEW DIRT INTO I.NAME EYES.
EMPL WORKING IN MAINT SHOP WELDING WHEN EYE PROBLEM OCCURRED.
CUTTING METAL FROM FEEDER HOPPER TO BE REPLACED BY NEW METAL.PROPANE TANK LOCATED NEARBY POPPED ITS RELIEF VALVE AND THE ESCAPING GAS WAS IGNITED BY SPARKS FROM CUTTING TORCH.THE IGNITED ESCAP ING GAS CAUSED THE BURNS TO THE FACE.
WHILE WELDING A HALF CLAMP LET LOOSE STRIKING I.NAME ON FOREHEAD.
WHILE SCRAPING DUST OFF A PIECE OF EQUIPMENT A RUST CHIP GOT LODGED UNDER THE BOTTOM EYE LID.
WHILE HOLDING A PIN WITH LEFT HAND AND DRIVING IT WITH A HAMMER IN THE OTHER HAND. HE MISSED THE PIN AND STRUCK HIS THUMB ON THE LEFT HAND.
PAINTING TRAILER DEBRIS AND FRAGMENTS BLEW IN EYE
EXHAUSTION OCCURRED WHILE WELDING ON LOADER BUCKET
WHILE TIGHTENING TRACK IDLER BOLT WITH RACHET WRENCH EMPLS THUMB WAS PINCHED BETWEEN RACHET HANDLE & TRACK PAD. THUMB WAS SPLIT OPEN.
FRAMING TRAILER HITCH ONE OF CROSS MEMBERS FELL AND LANDED ON FOOT JUST BEHING THE STEEL TOE OF HIS SHOE
WHILE PREPARING TO REMOVE EXISTING HOPPER FROM CONE CRUSHER, THE HOPPER WAS CHAINED TO PREVENT FALLING. WHEN THE 1ST BRACKET WAS CUT LOOSE, THE HOPPER SHIFTED AND DROPPED A FEW INCHES SMASHIN G THE WELDER'S HAND AND FINGERS.
WHILE LIFTING HEAVY OBJECT CLAIMANT STATES HE SLIPPED ON ICE STRAINING RIGHT LEG KNEE AND ANKLE.
WELDING PLATES ON DUMP TRUCK BOXES PLATE FELL ONTO FOOT BREAKING LITTLE TOE.
I.NAME DRIVING 2UT PIN THAT INJ I.NAME WAS HOLDING.I.NAME SLIPPED AND FELL FORWARD INTO PATH OF MAUL.
EMPLOYEE REMOVED CAP FROM HYDROLIC RESERVOIR ON AIR COMPRESSOR WHILE ENGINE WAS RUNNING THE CAP FLEW OFF AND STRUCK EMPLOYEE IN THE FACE HE SUFFERED LIP LACERATION AND LOST SEVERAL TEETH