Buscar en el registro

While trying to line up pipe on the leach pad employee slipped and fell on right arm causing pain. Employee later went to the hospital for x-rays that came back negative, was referred to an ortho doctor. Employee came back to work the following day on restricted duty with their right arm.

A miner fractured their hand when it was pinched between a drill steel and the rib/wall. This occurred when a drill steel fell into the slushing lane and got stuck between the ribs. the miner tried to pry the steel free when the steel pinched their hand against the rib.

Turning a piece of rail over and felt a pulling in left arm. No diagnosis at this time.

Miner grabbed slusher cable near the block and got EE's hand stuck in the block causing a laceration of EE's left hand.

While pulling a hitch pin from a loci, the hitch pin moved, pinching the motor operator's finger between the hitch pin and the wall of the loci. The incident resulted in a laceration that required stitches.

While moving a slusher block, the nipper slipped on the muck pile and fell causing EE's left number 5 finger to get pinched between the slusher cable and the slusher block. EE was taken to the doctor where EE received stitches.

While preparing to wet the muck down, the miner turned on the 1" water line when the hose failed where it connected to the nozzle. The hose was pushed back and cut the miner's hand. The miner received sutures.

While fitting up a support for the fender of an LHD, debris fell from above the mechanic and entered EE's eye between EE's hard hat and safety glasses. The mechanic was taken to the eye doctor where a foreign body was removed from the eye and they were prescribed antibiotics for infection.

On September 4th the cager was pulling powder off the no. 3 skip when they felt a strain in lower groin area. The incident wasn't reported until 10/4/2024. The injured cager was taken to the doctor on 10/8/2024 where they were diagnosed with a hernia and placed on restricted duty.

Mechanic received a small cut on finger. EE went to the Doctor on own. Received one very small stitch. EE did not report it until the end of the following shift (8/23).

A miner and partner were moving a 10"X10" cap. As they were setting the cap in place one of the miners caught the tip of left index finger. The tip of the finger was de-gloved. Surgery was preformed the following day. Amputation to the first knuckle was required.

Miner was looking up and material entered EE's eye. Miner was wearing safety glasses. Eye Doctor removed foreign body from Miners left eye.

Engineer was painting survey points on the back in 49-360 ER. Dust entered EE's left eye. Miner was wearing safety glasses. Did not notice discomfort until that evening while removing contact lenses. Took EE to the eye doctor the next morning (9/15/22). Diagnosis was Keratitis. Antibiotic drops prescribed.

Shaft Crew was lowering replacement liner into the 3700 pocket. Section of liner bounced and hit Miner on the lower right leg. Miner was seen by Doctor the next day and and was given a full release (08/21/2022). Miner Worked the remainder of Miner's rotation. Miner started next rotation on 08/26/2022. Saw doctor on 08/30/2022 and was given a work release for 09/13/2022.

Miner was assisting a Mechanic with the removal of an hydraulic cylinder. The cylinder slipped and it crushed the tip of the Miners right index finger.

Mill Maintenance man was repositioning a sheet of diamond plate on saw horse - felt a shoulder muscle pull (left shoulder). Surgery to left shoulder was done on Friday, November 26, 2021

Building metal latch boxes, felt eye irritation, tried to wash out with eye wash, still felt irritated - Right eye.

4900 Pocket #1 side - pulling chute to load skip, closed chute and finger caught bolt on airline - ripping finger nail off.

Motorman move bad ore car to side track, ore car derailed at the switch. Miner got off motor and tried to move ore car with their body...strain sprain to lower back.

Employee was off loading a 12" HDPE Tee from the back of a light vehicle when the Tee fell to the side smashing their left ring finger between the Tee and the bed of the light vehicle causing a laceration to the finger that required stiches.

Operator was tasked with moving a 993K loader from the 5340 bench to the PM bay. As the operator was placing the wheel chocks in the holder operator felt discomfort in their back / shoulder. Supervisor was notified and operator was transferred to local hospital for assessment. Site HSE and management were notified and investigation was initiated.

Employee was working on the leach pad to repair the water lines for the grasshoppers when some dust possibly containing a small amount of lime got into EE's left eye.

4900-081 lifting jackleg drill onto bolt deck, lower back started hurting. Going to get powder it got worse.

Employee was lifting shop vacuum into the back of the pickup and felt pain in shoulder. This became reportable when employee received prescription for medication to help with pain and sleep on 11/2/20.

5200-206 Put hand on wire bolted to rib, rock came off rib striking right hand.

5200-165 Timbering, cap fell out, threw miner into mat

3200-033 Raise - loading lagging onto timber slide at bottom of 033 Raise, rock fell from timber slide hitting miner on top of hardhat

Mechanic moving LHD tire, reported possible hernia on May 14th 2020. Mechanic thought it would get better over time - Requested to go see medical provider on July 14th 2020. Waiting for second opinion and surgical date.

3000-020 Chute - ore car overfilled while pulling muck, the handle on chute valve to open gate came off. While cleaning up mess, miner was using hands to pick up rocks. A rock fell from chute or ore car landing on miners left hand.

5500 #3 Station, moving 12"x12"x5' wood shaft dividers, caught right thumb between two dividers.

Miner stabbing roof bolts next to miner in heading. Stabbed bolt fell out of monster mat striking miner on back of left leg.