Buscar en el registro

EMP WAS WORKING AS A MECHANIC ON REAR DIFFERENTILA OF SCRAPER INSTALLING A SHIM. PINION SKUOOED CAUSING A CUT, BY THE SHIM, OF INDEX FINGER OF LEFT HAND.

CUT FINGERS ON SHARP EDGE ON BOTTOM OF TOOL BOX DRAWER.

EE WAS HOOKING A PUMP TRAILER ONTO A PIECK BALL HITCH WHEN TRAILER BECAME UNBALANCED. HE HAD TO PUSH & PULL TRAILER TO GET IT HOOKED TO BAAL ON TRUCK. HE FELT A TWINGE OF PAIN IN HIS BACK AT T HAT TIME.

EMPLOYEE WAS WIPING OFF THE BOTTOM OF A DRILL STEM WHEN THE DRILL STEM SLIPPED DOWN AND CAUGHT HIS FINGE TIP. LACERATED FINGER.

EMPLOYEE WAS REMOVING A BROKEN LIGHT BULB AND CUT HIS FINGER WHICH RESULTED IN BLOOD POISONING.

EMPLOYEE HAS A REPETITIVE TRAUMA DISORDER IN NECK AND WAS REPORTED BECAUSE IT STARTED DUE TO A CAR WRECK. ON 12-4-92 WE LEARNED THAT WHILE BOARDING HIS GRADER ON 10-30-92 HE PULLED SOMETHING I N HIS NECK AND SHOULDERS AND FELT PAIN.

EMPLOYEE WAS LOADING A WATER COOLER INTO A SUPPLY TRUCK WHEN HE FELT PAIN IN HIS BACK

EMPLOYEE WAS CLIMBING A 992 LOADER HE DROPPED AN ACCESS HATCH BEHIND THE CAB & HIS FOOT WAS CAUGHT BETWEEN THE HATCH & ENGINE HOUSING

EMPLOYEE WAS MOVING CRIB BLOCKS AND AFTER SITTING DOWN FOR A BREAK HIS BACK BECAME STIFF.

EE WAS WORKING ON A DOZER IN AN ACKWARD POSITION AND LATER FELT PAIN IN HIS HIP.

EMPLOYEE WAS DISPOSITIONING A HIGHWALL MINER POWER CABLE AND STRAINED HIS BACK.

PULLING A ROCK OFF HIGHWALL MINER A ROCK SLIPPED FELL AND STRUCK EMPL ON FOOT BEHIND PROTECTIVE TOE CAP.

EMPLOYEE BENT OVER TO PICK UP A PIECE OF METAL BAR. (2X4X3 FT). WHEN HE STRAIGHTENED UP, FELT PAIN IN BACK AND HIP.

EE PULLED OR TORE MUSCLES IN HIS SHOULDER WHILE TRYING TO DISINBRACE A LATCH.

45256WN MAY HAVE REINURED BACK WHILE DISMOUNTING A LOADER BUT NO EVENT OCCURED.

68935 UNLOADING A DRILL CABLE THE EE REACHED OVERHEAD AND PULLED ON THE CABLE WITH HIS LEFT ARM AND FELT PAIN.

EMPLOYEE DROPPED A CONVEYOR ROLLER FRAME ON HIS FOOT.

EMPLOYEE WAS PREPARING TO EXIT A VCB AS HE TURNED TO EXIT HE FELT A PULL IN HIS BACK NO EVENT TOOK PLACE OTHER THAN TURNING TO EXIT

EMPLOYEE WAS WORKING ON A 2570 BUCKET SHROUD WHEN IT FELL OVER STRIKING HIM AND PINNING HIM TO THE GROUND.

EMPLOYEE WAS PULLING ON 3" PIPE TO LINE IT UP WITH BARREL. EMPLOYEE CANNOT STATE WHAT HAPPEND. ALLEGED SHOULDER STRAIN. DID NOT SEEK DR TREATMENT UNTIL 10-28-91.

EMPLOYEE WAS NOT BOTHERED WITH A EYE PROBLEM UNTIL ABOUT 9:00PM WENT TO DOC & DID NOT FIND ANYTHING IN EYE UNTIL TWO DAYS LATER AT THIS TIME A SMALL OBJECT WAS REMOVED FROM EYE WITH MAGNET

WHILE DISMOUNTING WATER SCRAPER EMPLOYEE CAUGHT HIS FINGER BETWEEN HAND HOLD & BODY OF SCRAPER

EMPLOYEE WAS WASHING EQUIPMENT WHEN HE ALLEGES THAT SOMETHING GOT INTO HIS EYE.NOTHING FOUND AT AID STATION IN EYE-EMPLOYEE DID NOT COME TO WORK ON 05-29-91.EYE SWOLLEN SENT EMPLOYEE TO DOCTOR ON 05-30-91.

EMPLOYEE WAS GETTING MATERIAL FROM TOOL BOX ON WELDING TRUCK WHEN LID CAME CLOSED ON EMPLOYEES THUMB

PERFOR CLEANUP IN THE LOWER DECK OF DRAGLINE STOPPED FOR LUNCH BACK PAIN

EMPLOYEE WAS CONNECTING A CABLE FOR 2570 DRAGLING INTO CAM-LOCK CONNECTOR WHEN FINGER GOT CAUGHT IN CAM LOCK.

EMPLOYEE WAS HELPING GREASE HOSE AT THE HANDLE VALVE.WHEN THE AIR WAS TURNED ON TO OPERATE PUMP.THE PUMP TOOK ON TOO MUCH AIR AND THE END OF THE HOSE SNAPPED AND STRUCK EMPLOYEE IN THE EYE.

EMPLOYEE WAS SUPERVISING THE REPLACEMENT OF SEGMENTS ON 2570 WHILE BEING IN A SQUATTING POSITION,THE EMPLOYEE STOOD UP AND AT THE TIME KNEE POPPED.NOT DID NOT LOSE WORK DAYS UNTIL 08-09-91.

EMPLOYEE WAS MAKING UP TOW CABLES FOR REPAIR WORK. HE BENT OVER TO PICK UP OBJECT OFF FLOOR AND ALLEGES LOW BACK PAIN.

EE WAS REMOVING A BELLY PAN FROM UNIT 3911 DOZER WHEN HE ALLEGED BACK PAIN.

EMPL WORKING ON DRAG CLEVIS ,RAISED UP UNDER HEAVY PIECE OF STEEL STRIKING HEAD AND INJURING NECK.NOT REPORTED TO COMPANY UNTIL 5-25-90.

EMPLOYEE WAS MOVING HYD JACK AND FELT PAIN IN LOWER BACK.

EMPLOYEE WAS DOING REPAIR WORK WHEN A IMPACT WRENCH FELL FROM A PLATFORM STRIKING HIM BELOW LEFT EYE

EMPL ASSEMBLING REPAIR LINK.PIN BECAME DISLODGED UNEXPECTEDLY & SLID AGAINST EMPL FINGERS.WENT TO DR 11-9-89.

EMPLOYEE WAS MOUNTING A 992-C LOADER. PULLED HIMSELF UP ON HAND RAIL AND STRUCK MIRROR WITH NOSE. EMPLOYEE WAS MOUNTING LOADER FROM REAR TIRE. (NOTE) EMPLOYEE DID NOT START LOOSING TIME UNT IL 10-11-89.

EMPLOYEE WAS PULLING ON A WATER HOSE, USED TO CLEAN PREP PLANT FLOORS WHEN HOSE CAUGHT ON PIPE STRUCTURE RESULTING IN A STRAIN TO BACK.

EMPLOYEE WAS HELPING PUT A DECK BUSHING ON STABLIZER AND BOTH HANDS WERE ON STABLIZER TO HELP POSTION IT, BUSHING SLID DOWN SHAFT STRICKING EMPLOYEES THUMBS.

EMPLOYEE WAS MOVING A PIPE WHEN HE SAT PIPE ON BLOCKS TO REMOVE SLING PIPE ROLLED CATCHING LEG AGINST ANOTHER PIPE.

EMPLOYEE ALLEDGED HE PICKED UP A STEEL PIN USED ON THE DRAGLINE BUCKET AND FELT A BURNING SONSATION DOWN HIS LEG.

EMPLOYEE WAS CLEANING SHOP AREA WHEN HE LIFTED.HE ALLEGED HE FELT BACK PAIN THIS EMPLOYEE HAS A CHRONIC BACK PROBLEM.

EMPL REMOVING OUTRIGGER PAD FROM MOBILE CRANE.PAD WAS STUCK EMPL USED FORCE TO LOOSEN,PAD FELL CATCHING MIDDLE FINGER LEFT HAND.

EMPL REMOVING ROCK FROM TAILGATE OF TRUCK AND TAILGATE CAME SHUT ON EMPL FINGER.

EMPLOYEE WAS DISMOUNTING FLY ASH TRUCK #6210 WHEN HE STEPPED FROM LAST STEP TO GROUND HE FELT PAIN IN LOWER BACK.

THE INJURED WAS REPAIRING A TRAMSMISSION ON A WATER TRUCK.A TRAMSMISSION MOUNT WAS BROKEN AND HAD A SHARP EDGE.HE CONTACTED THE SHARP EDGE WITH HIS THUMB.STITCHES TAKEN.

THE INJURED CAME TO WORK WITH TIHGTNESS IN HIS LOWER ABCK.HE DID NOT REPORT AN ACCIDENT OR RECALL ANY ACTIVITY WHICH COULD LEAD TO HIS CONDITION.

I.NAME WAS REMOVING RADIATOR CAP ON 380-B RUBBER TIRED DOZER WHEN CAP BLEW OUT & HOT WATER BLEW OUT HE REMOVED THE CAP SLOWLY & IT GAVE NO INDICATION OF BEING HOT

I NAME WAS MOVING A PALLET OF DOZER ROLLERS TO A STORAGE AREA ALONG THE NORTH OUTSIDE SHOP WALL. HE STOPPED THE FORKLIFT TO MOVE A BARREL. AS HE RAISED THE LOAD A ROLLER FELL OFF THE PALLET, H E DISMOUNTED AND REPLACED THE ROLLER ON THE PALLET AS HE DID SO, THE LOAD OF ROLLERS FELL OFF THE PALLET STRIKING HIS LEFT LEG AND FOOT.

HE RECEIVED SPILLED DIESEL FUEL ON HIS SHIRT WHILE REPAIRING A BROKEN FUEL LINE. HE CALLED IN DAT AFTER REPORTING A RASH.

I NAME WAS CARRING A PIECE OF STAINLESS STEEL METAL 16INCH WIDE AND 112 INCH LONG HE TRIED TO SET THE PIECE OF METAL UP AGAINST THE WALL. THE METAL SLIPPED AND HE TRIED TO CATCH THE METAL WITH HIS LEG. THE METAL HAD BEEN CUT ON A SHEAR AND THE SHARP EDGE LACERATED HIS L EFT LEG.

I,NAME WAS DISM2UNTING A ROWBOAT ONTO THE DREDGE, WHEN HE SLIPPED AND STRUCK HIS KNEE AGAINST THE DREDGE.