Buscar en el registro

On 9/3/2013 the employee was exiting a vehicle. While he was exiting he had a hold of the steering wheel and lost his footing. This action twisted his wrist towards him. He was taken to the doctor and released. On a follow-up appointment on 9/10/2013 he was diagnosed with a hair line fracture.

EE was found laying on the deck of a barge. There were no witnesses to what happened. The EE was taken to the hospital for observation

EE was working in U/G Stores location changing security cameras. He was walking and slipped on an uneven surface and strained his left knee. He went home and self treated the knee, it did not get better and he was taken to the Dr. 10/11/2012 where he was given 2 cortisone injections and a prescription Pain Medicine.

The employee was climbing down off of a haulage truck and slipped on the last step contacting the bumper with his right knee. He was taken the a doctor and released. On 9/25/2012 the employee was taken back to the doctor and given a medrol does pack and released with no restrictions.

On 6/27/2012 the employee fell hurting his left arm. He finished his shift and was seen by local doctor the following day. On 7/11/2012 the employee had surgery to repair a torn tendon in his biceps muscle.

Employee was changing a limit switch on the tertiary crusher. He was sitting on a guard that was approx. 5' off the floor and when he went to get up he lost his balance and fell. As a result of the fall he fractured four ribs on the right side and a cut to his fore head that required sutures.

Employee was performing maintenance in inspection speed in the 8' shaft, when the skip encountered a tight spot at the 1040' location. This tight spot caused the skip to momentarily stop and then release causing the employee to lose his balance and fall. He put his rt. arm out and broke his forearm.

Employee was performing maintenance in inspection speed in the 8' shaft, when the skip encountered a tight spot at the 1040' location causing the skip to momentarily stop and then release causing the employee to lose his balance and fall down. The fall caused contusions to his lumbar and pelvic area.

Employee fell on the stairway while exiting the cab of a scaler. He bruised his back.

Not sure as to exact cause of accident, however, during the day, the EE noticed that his Left Knee was getting stiff. After being examined by a doctor, he was sent for an MRI on 12/17/2010. He was diagnosed with grade 4 tear of the lateral meniscus of his left knee.

Right foot slipped off the last rung of ladder. Hurt right knee.

On 3/9/2009 employee fell off of a barge cover on to the barge (approx.6'). He was taken to the local medical clinic where he was treated and released. The area that was bruised started collecting blood over a period of time until a follow up visit was required. Doctors made a decision to drain it on 6/18/2009. Incident became reportable at this time.

EE was climbing down the ladder of the roof bolter. He had a water cooler in his hand while descending the ladder. He was approx. five feet from the bottom of the ladder, when he lost his footing and could not hold on to the rails of the ladder. He then fell to the ground breaking his left, lower arm.

EE was checking a ceiling monitoring device that had fallen using a Getman lift. The ladder to enter the basket was jammed. The ee used an unapproved method to enter/exit the basket. Upon exiting the basket, ee fell & hit his right elbow on the floor. He was sent to the dr on 10/4/07 & was released with no restrictions. On 10/26/07 it was determined he had a closed fracture.

Injured party twisted right ankle while walking.

THE SUPPORTING CABLE ON SPIDER PARTED CAUSING SPIDER TO FALL AND CAUSING INJURED PARTY TO FALL FROM SPIDER.

EE WAS STANDING ON POWDER RIG DECK (APPROX. 3' HIGH), CLEANING OUT AMMONIA NITRATE POT. HE STARTED TO GET OFF THE PLATFORM BY CLIMBING DOWN THE LADDER. IT IS A 2-RUNG LADDER, BEING THE PLATFORM IS ONLY 3' HIGH. NOT KNOWING IT, HE TRIPPED ON THE TOE PLATE OR MISSED THE LADDER. HE FELL ON THE FLOOR ON HIS RIGHT SIDE.

EMPLOYEE WAS ATTEMPTING TO SET THE COLLET BACK IN PLACE ON THE LEFT CYLINDER OF A CAT LOADER. HE WAS STANDING ON A LADDER. AS HE WAS DECENDING FROM THE LADDER & REACHED THE 2ND TO LAST STEP FROM THE BOTTOM HE LOST HIS FOOTING & FELL BACKWARD ONTO HIS BACK. THE SELF RESCUER WHICH ATTACHED TO HIS BELT STRUCK HIM ON HIS LOWER BACK CAUSING A BRUISE.

EE WAS WALKING AROUND THE UNDER CUTTER. HE SLIPPED ON A PREVIOUS CUT ON THE FLOOR. WHILE FALLING HE TRIED TO STOP HIS FALL USING HIS RIGHT ARM. WHEN HE HIT THE FLOOR WITH HIS RIGHT HAND IT PULLED HIS SHOULDER AS WELL. HE RETURNED TO WORK THE FOLLOWING DAY BUT COMPLAINED ABOUT HIS SHOULDER HURTING UNTIL OCT 4TH WHEN HE HAD SURGERY.

Ee was changing a collic pin on a hyd. cylinder for 992 loader. He was standing between arms holding the pin. As he was shifting his body to move his foot slipped causing him to fall on one of the arms. The pin he was holding also hit the arm crushing his left little finger and breaking the first joint of the finger.

EE WAS ARRIVING AT WORK WALKING AWAY FROM MANCAGE. HE STEPPED IN A DIP IN THE FLOOR CAUSING HIM TO FALL ON HIS KNEES.

EMPLOYEE WAS SHOVELING SALT CLEANING SCREENPLANT DECK. HE APPARENTLY PASSED OUT, FELL AND HIT HIS HEAD. HE HAD A CUT AROUND HIS LEFT EYE. HAD TO HAVE STITCHES.

EE WAS COMING DOWN A LADDER. HIS FOOT SLIPPED & HE FELL TO THE FLOOR HITTING HIS LEFT SHOULDER.