Billie Mine Metal/Non-Metal

Employee was driving a 2 yrd L.H.D. down ramp. He hit wall or rib striking chest on steering wheel causing pain. Worked all week then went to doctor on 10-29-04. Released to work on 11-1-04.

EMPLOYEE WAS GROUND SUPPORTING BACK OF TUNNEL WHEN SOME LOOSE MATERIAL SLID DOWN DRILL STEEL STRIKING EMPLOYEE ON HEAD CAUSING A CUT NEEDING STITCHES.

EMPLOYEE WAS PUTTING IN GROUND SUPPORT AFTER BARRING DOWN. LOOSE MATERIAL SLID DOWN DRILL STEEL STRIKING EE ON HIS NOSE CAUSING A CUT NEEDED 4 STITCHES.

EMPLOYEE WAS TESTING AN ENGINE ON ONE OF THE TRUCKS AT THE UNDERGROUND SHOP AREA. THE ENGINE SPILLED MOTOR OIL ON MANIFOLD CAUSING IT TO SMOKE, CAUSING SMOKE INHALATION IRRITATION.

Employee was riding in a loader bucket, bucket bounced when it rubbed rib, and he was holding on to pivot of injuector bucket smashing his finger tips of his left hand.

INSTRUCTING NEW TRUCK DRIVER, HE CAUGHT HIS LEFT ANKLE BETWEEN THE TRUCK TIRE AND LOOSE MATERIAL AT RIB OF TUNNEL.

Employee was ground supporting the back at alpine heading, when loose material fell, sliding down drill steel, striking employee on the face and left side of head.

EE CLAIMS HE WAS HELPING DRILL A FACE ROUND, WHEN A LOADER OPERATOR APPROACHED AND MUCKER APPARENTLY HIT AGAINST EE'S LOWER BACK, CAUSING INJURY. HIS PARTNER CLAIMS HE DID NOT SEE ANYTHING. THE MUCKER BUCKET WAS 5' IN THE AIR OR HIGHER; COULD NOT HAVE HIT HIS BACK AREA.

WHILE DRILLING FOR GROUND SUPPORT HOLES THROUGH CHAINLINK FENCE, LOOSE MATERIAL FELL OUT OF BACK, PUSHING CHAINLINK FENCING AND DRILL STEEL AGAINST EE'S BACK, CAUSING A BACK INJURY AND CUT ON FOREHEAD.

WHILE DUMPING MUCK FROM SCOOP INTO TRUCK EMPLOYEE RAN INTO SIDE OF HAUL TRUCK. NO DAMAGE ON EQUIPMENT, EMPLOYEE JARRED LEFT SHOULDER AND LEFT ARM.

Pulling jackleg machine back from face, after drilling a hole for blasting.

Employee was handling crib wood and piece of crib slipped crushing employee's finger.

CONNECTING FIRE HOSE TO WATER SUPPLY VALVE & FORGOT TO ADJUST IT SO THAT IT WOULD NOT LEAK. SOMETHING POPPED OR CRACKED HIS WRIST.

EE WAS LOADING A DRIFT ROUND TO BLAST WHEN SOME LOOSE MATERIAL SLOUGHED OFF THE LEFT RIB, STRIKING EE ON THE LEFT SIDE OF BODY CAUSING HIM TO LOUNGE FORWARD AND FRACTURING LEFT ANKLE.

EMPLOYEE WAS WORKING ON WELDING FLOP GATE AT 1150 POCKET CHUTE STANDING ON #2 HOPPER HE LOST HIS FOOTING FELL INTO HOPPER ABOUT 10 FEET, HIT HIS LOWER BACK AND RIGHT LEG.

EMPLOYEE WAS USING PRY BAR TO CLEAN MUD OFF ROLLER. ROLLER CAUGHT PRY BAR AND EMPLOYEE PULLED BACK AND HIT HIS LEFT ARM ON A PIECE OF STEEL PLATE, CAUSING A LACERATION.

EE WAS LOADING ROLLS OF CHAIN LINK FENCING AND BUNDLES OF BOLTS ON TO CAGE TO SEND UNDERGROUND, WHEN HE FELT SHARP PAIN TO LOWER BACK, FINISHED WORKING HIS SHIFT.

EE WAS GOING TO INSTALL AN ELECTRICAL CONTACT COMPONENT THAT WE RECEIVED. HE TRIED TO CUT PLASTIC WRAP WITH SHARP KNIFE. KNIFE SLIPPED, SLICING LEFT HAND PALM BELOW THUMB REQUIRING STITCHES.

EE WAS GROUND SUPPORTING, HE WAS CUTTING SOME OLD BOLTS WITH A TORCH, WHEN THE CHAIN LINK HOLDING THE BOLT SLIPPED AND LOOSE MATERIAL FELL STRIKING EE ON RIGHT SHOULDER AND RIGHT LEG.

DRIVER WAS SHUTTING OFF ENGINE SLIPPED ON OIL LOST BALANCE THEN TWISTED BACK WHILE REGAINING BALANCE.

DRIVING DUMP TRUCK WHEN WNGINE DIED THE TRUCK HIT RIB/WALL CAUSING LEFT KNEE TO HIT CONTROL PANEL OF TRUCK.

DURING GROUND SUPPORT, DEBRIS FELL ON HARD HAT. 2-15-02 PER CALL USING FORK LIFT.

EE WAS DRIVING UNDERGROUND DUMP TRUCK. THE ENGINE DIED. EE LOST CONTROL OF THE TRUCK AND IT HIT THE RIB.

UNDERGROUND DUMP TRUCK HIT STEEL SET WHEN TRUCK CAME TO SUDDEN STOP DRIVER HIT CANOPY WITH LEFT SHOULDER.

EE WAS CUTTING OLD BOLT WITH HACKSAW. STANDING ON MUCKER BUCKET HACKSAW BLADE BROKE WITH PRESSURE AND EE FELL FROM BUCKET STRIKING RIB & FLOOR. APPROX. 4 TO 5 FT. HURTING HIS HEAD & BACK.

EE WAS MOVING ELECTRICAL CABLE WHEN LOOSE MATERIAL FELL OFF EQUIPMENT APRON AND HIT HIS RIGHT THUMB.

EE WAS DRIVING A TRUCK, WHILE WAITING TO GET LOADED, LOOSE MATERIAL FELL FROM CHAIN LINK FENCING ON HIS HARD HAT CAUSING HIS NECK TO JAM DOWN ON HIS SHOULDERS.

EE WAS USING A BEARING PULLER-PULLER SLIPPED WHEN HE APPLIED FORCE AND STRUCK HIM IN THE MOUTH CUTTING UPPER LIP.

EE WAS HELPING TO LOAD AN ELECTRICAL BOX ON TO THE SHAFT CAGE WHEN HE SLIPPED AND CUT HIS RIGHT FOREARM ON A WELDED LIFT LUG NEEDING STITCHES.

THE EE WAS INSTALLING GROUND SUPPORT, WITH A DRILL MACHINE,JACKLEG, WHEN HE SMASHED HIS MIDDLE FINGER AT THE TIP. CAUSING A BONE SPLINTER. Y2107400272

EMPLOYEE WAS DRIVING AN 8 TON HAUL TRUCK FULL OF CEMENTED BACKFILL, WHEN A HYD HOSE BUSTED SPRAYING HOT HYD OIL ONTO THE EMPLOYEE'S FACE AND EYES.

EE WAS MUCKING SHAFT BOTTOM, MUCKER JUMPED GEAR TO NEUTRAL AND STRUCK HAULAGE WALL.

EMPLOYEE WAS HELPING A MINER GROUND SUPPORT ON UNEVEN GROUND WHEN SOME LOOSE MATERIAL FELL & ROLLED DOWN DECLINE SLOPE STRIKING THE EMPLOYEE ON THE BACK OF THE RIGHT KNEE CAUSING SOME BRUISING TO THE CALF AREA.

EE STATES THAT MAN CARRIER ROLLED BACK ABOUT 2 SFT TAPPING THE RIB CUAISNG BACK INJURIES AND A HERNIA.

EMPLOYEE WAS CLEANING UP MUD WITH A CLAM SHELL, AS HE WAS MOVING CLAM SHELL INTO BUCKET, CLAM SHELL CLOSED ON LEFT HAND LITTLE FINGER.

EE WAS INSTALLING GROUND SUPPORT, AS HE WAS ROCK BOLTING SOME MATERIAL CAME DOWN AND HE WAS STRUCK ON THE NECK AND SHOULDER AREA.

DEBRIS FROM BLAST STRUCK WORKER IN LEG.

EMPLOYEE SUFFERED A HEARING LOSS DUE TO A BLAST.NOT SURE IF PERMANENT OR NOT.