Napa Shop: 52 citaciones de la MSHA Metal/Non-Metal

Working on loader and employee felt a slight strain in back at the time. The next day the employee reported that his back was feeling sore. Employee was placed on modified duty starting 6-25-15.

During disassembly of transmission pump, a hammer and punch were used to remove the shaft from the housing. On the third strike a chip flew off the punch and struck the upper lip. Employee requested a band-aid and declined a trip to the doctor.

Employee was doing housekeeping in surplus equipment storage area. He was not wearing gloves while picking up old scrap wood and equipment parts. Employee noticed his wrist itched but was not aware of a bug bite until the next morning when he noticed his left wrist was swollen. We sent employee to the doctor where he received a tetanus shot and a splint to wear for two days.

While cutting steel in a band saw a small amount of steel particles built up close to the blade drive pulley. Employee lift guard and went to clear build up with finger, saw blade caught glove and pinched index finger tip of the left hand on edge of saw frame.

doing a welding repair under an excavator in an awkward position

Employee felt and heard a tearing sound from the left shoulder while working the lever back and forth of a 1/4 ton chain come along. Employee was in the act of removing a rod assembly from a hydraulic cylinder. The hydraulic cylinder was laying horizontally in the shop on the cylinder work bench.

Employee set lunch box down to go load a skid steer loader on an equipment transport trailer. As the employee set his lunch box on the ground he heard two (2) popping sounds and felt extreme pain in right shoulder.

Loader was parked on pressure wash pad, employee was climbing down ladder and slipped

EE was pulling out a piece of steel from yard storage, when he was stung by 5 or 6 yellow jackets on arm and neck. (L) arm was quite swollen.

EE had been typing at desk since start of shift. He turned to look at calendar (right side) and felt neck stiffen. Progressively got worse as day progressed. EE was released to full duty on 9/26/11 but was prescribed physical therapy, which caused incident to become reportable per Denver Office. First appt available was 9/13/11.

While EE was filling 5 gal bucket with soap and exiting an area where other containers were stored, his foot was caught on said containers and caused ee to trip. As he was falling his left forearm contacted a hot muffler on steam cleaner. This caused 2nd degree burns to effected area.

The EE was removing the dust cover over the threaded port hole on a grease barrel and cut his right finger on the metal pull tab. The laceration to the tip of his pinky finger required two stitches.

The EE was exiting a Loader #71-926. As he climbed down the ladder his hand slipped on the handrail. He twisted his left knee. Saw company doctor on 4-30-09. No restrictions that prevented him from doing his job. Returned to doctor on several occasions. Surgery done on 7-29-09. Reportable as of then.

The EE accessed the front end loader Co. #71-485 via the ladder, located on the left hand side, to check fluids. While descending from the right side of the cat 988F loader at 05:45 am, the operators visibility was limited and the EE misjudged the distance from the last rung to the ground, hyperextending his left knee.

EE was working on vehicle 22-311. While working on suspension he heard a popping type sound. He immediately pulled his left arm away from bolts being tightened. The leaf springs may have shifted. Springs were not under load.

He was working on brake assembly for a motor grader. Assembly had been removed from grader for rebuild. While on the bench, he tested the piston seals & retainers blew out & struck him on lip & under chin causing laceration.

The ee was trying to make an adjustment to the table. The handle used to move the table saddle swung around striking the ee (r) tip of index finger-(r) hand. causing the nail to partially come loose.

Jump starting equipment( haul truck). Stepping across from truck to truck, lost footing, grabbed handrail, fell against the truck and fell to the ground.

Prying on a bearing rack with a heelbar inside a gear box. The heelbar slipped which caused my right forearm to hit the gear box housing. The edge of the housing was fairly sharp.

Picking up cages and stacking onto truck trailer. Bent over to pick up another cage and felt pain in back.

WHILE OPERATING ENGINE LATHE, A LONG, SHARP SHAVING FLEW OUT AND LACERATED EE'S RIGHT MIDDLE FINGER.

Not sure, Employee noticed eye itching & burning & asked to see the Dr.

Installing air tank under equipment, he went to get under equipment and hit his hard hat on a bar jamming his neck.

EE WAS PUTTING FILTERS INTO BOX ON LUBE TRUCK THAT HAS A HINGED LID. THE LID FELL ONTO EE'S LEFT THUMB - CONTUSION.

Operating a milling machine and handling various tools and materials a small piece of metal lodged into right hand.

MOVING BOX, FELT PAIN IN SHOULDER

OPERATING 4 1/2' GRINDER FOR LONG PERIODS OF TIME. FOREARM WAS SORE AND PAIN NEVER WENT AWAY.

EE BEGAN TO AIR TIRE UP. HE PLACED BEAD BLASTER TANK ONTO TIRE AND OPENED VALVE. EE FELT SOMETHING GO INTO HIS EYE UNDER HIS SAFETY GLASSES.

INSPECTING SLINGS, TURNED TO WALK AWAY & SLIPPED ON GREASE OIL.

Installing safety latch on wire rope hook using screw driver, and screw driver slipped and went across knuckle on left index finger.

(EE WAS OPERATING LATHE.) CHIP WOUND DOWN INTO CHIP PAN, GRABBED THE CHIPS IN PAN AND THE ROTATING CHUCK ON THE LATHE CAUGHT THE CHIPS AND PULLED THEM OUT ONTO EE'S HAND, CAUSING CUT.

HOOKING UP BRAKE LINES TO THE BRAKE VALVE LAYING ON PLATFORM WITH SHOULDER & ARMS DOWN INTO MACHINE PULLING ON BRAKE LINE, FELT PAIN IN LOWER BACK.

RIGHT HAND AND ARM HAVE BEEN HURTING, BECAME WORSE WITH HAUL OF USE, RIGHT JOINT AT BASE OF THUMB BECAME PAINFUL, TYPING SEEMED TO AGGRIVATE IT, COULD NOT USE SCISSORS. HAS BEEN ACCUMULATING, RMI.

PLACING DIFFERENTIAL IN ROCK TRUCK FELT SOMETHING PULL IN LEFT SHOULDER WHILE PULLING WRENCH.

OPERATING CORDLESS DRILL, AIRTOOLS & HAMMER, HE STARTED EXPERIENCING SHARP PAIN IN RIGHT LOWER ELBOW.

EE PLACED VALVE IN VICE, USED WRENCH TO REMOVE FITTING WHILE PULLING THE RIGHT HAND WAS CRUSHED BETWEEN VALVE AND VICE.

WHILE GRINDING A PIECE OF STEEL FLEW IN RIGHT EYE.

GRINDING ON WINDOW SEAL AND A PIECE OF METAL WENT INTO R EYE.

EE WAS BOLTING TANK WHEN HE FELT A STINGING AND PINCHING FEELING.

PLACED LADDER UP AGAINST WALL, CLIMBED UP AND STARTED UNSCREWING SCREWS LADDER SLIPPED OUT AND DOWN CAUSING EE TO FALL.

WORKING TO REMOVE ESSENTRIC WITH IMPACT TOOLS & PRY BAR, SHOULDER STARTED ACHING.

EE PERFORMS CONCRETE WORK AND CARPENTRY WORK. DURING PERFORMING THESE ACTIVITIES HE NOTICED THAT HIS NECK AND SHOULDERS WILL START TO HURT.

GRINDING FOR ABOUT 10 DAYS IN AWKWARD POSITIONS HE STARTED TO NOTICE LEFT ARM/ELBOW HURTING.

WENT TO CLOSE DOOE RON EXCAVATOR WHILE HOLDING ON TO RAIL SLAMMED DOOR WITH R HAND CATCHING L HAND, RING FINGER IN DOOR.

GRINDING STEEL PLATE FOR SIDE OF BUCKET. GRINDING DUST FELL IN LEFT EYE. HE THOUGHT IT CAME OUT, BUT EYE STARTED TO FEEL WORSE OVER THE WEEKEND.

RT HAND STRUCK AGAINST HARD SURFACE WHILE HOLDING GRINDER.

MOVING BOXES UP AND DOWN STAIRS NOTICED RIGHT KNEE STARTED TO HURT.

CLEANING UP AND PERFORMING YARD WORK. MOVING HEAVY MATERIAL. DID NOT NOTICE PAIN ON FRIDAY WOKE UP SATURDAY WITH A SHIFT BACK.

FINISHING CONCRETE USING HAND TOOLS, HE STARTED NOTICING TINGLING IN FINGERS.

WENT TO TURN AND LOOK AT SUPERVISOR AND FELT SOMETHING TWIST IN BACK.

FINISHING CONCRETE USING HAND TOOLS STARTED NOTICING TINGLING IN FINGERS

BENT OVER TO MOVE BRAKE HOUSING AND FELT PAIN DOWN LEG.

EE REMOVING 4WAY SLING, SLING FROM HOOK ON CRANE, USED LEFT HAND TO HOLD LATCH OPEN, PULLEDSLING OUT WITH RIGHT HAND

CLEANING BRAKE VALVE PART AT SOLVENT TANK WITH BRAKE CLEANER. SPRAYED AND CLEANER WENT UNDER SAFETY GLASSES.

REPETITIVE HEAVY GRIPPING AND LIFTING.

CUMULATIVE TRAUMA TO RIGHT SHOULDER

WHILE WORKING ON THE PRESS AT THE MACHINE SHOP, A PIECE OF STEEL SLIPPED OUT AND HIT HIM IN THE LEFT HIP.

SLIPPERY SURFACE - FEET SLIPPED OUT FROM UNDERNEATH. LANDED ON BACKSIDE WHILE ON TOP OF SCRAPER.

LIFTING SMALL TRANSFORMERS AND A CYLINDER. DUMPED THEM INTO A METAL BIN. LATER THAT DAY HE FELT BACK PAIN.

EE WAS WALKING OUT OF SHIPPING AND RECEIVING, WHEN HE REACHED THE BOTTOM OF THE STAIRS HE SLIPPED AND FELL ON HIS LOWER BACK AND RIGHT ARM AND ALSO SAID BACK OF NECK HURTS.

WHILE CLIMBING UP AND DOWN LOOKING FOR PARTS, THE EMPLOYEE TWISTED HIS KNEE.

EE WAS MOUNTING A TRUCK TIRE WHEN TIRE BAR SLIPPED OFF RIM AND HIT RIGHT KNEE.

WAS PRUNING TREES AND PLANTS AT C.M. SYAR'S HOUSE. WHEN PULLING ON IVY, THE VINES BROKE AND HAND AJMED INTO SHEARS HELD BY OTHER HAND.

EMPLOYEE WAS WASHING VEHICLE WITH RAG AND JAMMED FINGER IN MIRROR.

EE FAILED TO BLEED OFF AIR LINE BEFORE ATTEMPTING REPAIR.

GLASS FUEL FILTER BURST WHILE CHECKING FOR LEAK

WHILE CLIMBING ONTO FUEL TANK WORKING ON OFFROAD WABCO ROCK TRUCK HE SLIPPED IN THE LOOSE DIRT THAT WAS ON THE TANK. THE ACT OF TRYING TO AVOID FALLING OFF THE TANK CAUSED THE MUSCLE TO PULL. ON FRIDAY, 10-6 HE FELT PAIN AS HE REMOVED COVERALLS & WENT TO HIS PERSONAL DR. ON 10-8 HE FELT CONTINUED PAIN SO SAW SYAR'S IND. MEDICAL DR. OFJOBCARE. HE IS NOW RESTRICTED DUTY RE BENDING/LI

EE WAS SHOVELING ROCK WHEN HE STRAINED/SPRAINED HIS RIGHT UPPER BACK.

EE WAS TRYING TO PUSH DIFFERENTIAL INTO PLACE WHILE LYING UNDER TRUCK. NOTE: EE DID NOT DETERMINE INJURY PAINFUL ENOUGH TO SEEK MEDICAL CARE & TAKE TIME OFF FROM WORK UNTIL 11/15/94. HE SAW DO CTOR ON 11/16/94.