Avísenme cuando se presente un nuevo incidente de la MSHA en Victorine Mine.
EMPL STACKING 50 LB ANFO BAGS WHEN HE SLIPPED AND STRAINED UPPER CHEST.
EMPLOYEE WAS GRAB SAMPLING A MUCK PILE ON SURFACE WHEN A ROCK ROLLED DOWN THE PILE AND STRUCK HIM ON THE RIGHT LOWER LEG.
EMPLOYEE SLIPPED AND FELL WHILE DISMOUNTING OUR SCISSOR LIFT TRUCK- STEPPED ON A ROCK TWISTED ANKLE.
EMPL WAS GEETTING OFF OF STSH MUCKER WHEN HE JUMPED INSTEAD OF STEPPING OFF EQUIPMENT RIGHT FOOT LANDED ON TOP OF SMALL ROCK WHICH ROLLED CAUSING HIM TO SPRAIN RIGHT ANKLE.
EMPL WAS DRILLING UP HOLE STEEL SLIPPED OUT OF CENTRALIZER & FELL TO GROUND.. EMPL WAS TRYING TO PICK UP DRILL STEEL & PUT IT BACK ON DRILL WHEN HE PULLED BACK.
EMPLOYEE WAS LIFTING 5 FT INNER B W CORE TUBE FROM -90 DEGREE DRILL HOLE WHEN FELT PAIN IN GROIN AREA
BRACKET ON LOWER HYD BROKE WHILE SETTING RIG ON 45DEGREE HOLE,CAUSING RIG(DRILL FEED FRAME) TO FALL FROM 45DEGREES TO 70DEGREES.EMPLOYEE CAUGHT ON HYD HOSES ON BACK SIDE OF RIG BEING JERKED UP OFF OF GROUND AND INTO METAL BOOM.
WAS INSTALLING VENT LINE IN 202 G HEADING HE WAS STADING ON THE BACKHOOD OF A STSH SCOOP HE SLIPPED AND FELL TO T HE GROUND.
UNPLANNED ROOF FALL AT OUR 600 N 600 E INTERSECTION. NO INJ. WERE INVOLVED OUR POWER WATER TO COMPRESSED AIR WQAS AFFECTED THE ROOF ALL WAS ABOUT 20 METERS IN LENGTH AND 4 METERS IN WIDTH. ABO UT 200 TONS FELL DUE TO 5 FT. SPLIT SET BOLTS THAT WA> INSTALLED BY PREVUOUS MINING CO.
DRILL HELPER CUT WRIST WHEN WRENCH SLIPPED WHEN TIGHTENING WATER SWIVEL.
EMPL WAS MOPPING A HALLWAY SHE OVEREXTENDED HER BODY WHILE MOPPING STRAINED HER LOWER BACK
EMPL WAS REMOVING SHACKLE FROM JAW DYES HE PUT HIS FOOT BETWEEN JAW DYES AND THE SEDE OF THE HOPPER JAWS MOVED AND PINEED HIS FOOT HE HAS BEEN TRAINED NOT TO HAVE HIS FEET ON DOWNHILL SIDE OF JAWS
EMPLOYEE WAS DRIVING A FORD TRACCTOR DOWN AN INCLINE WHEN THE LEFT FRONT WHEEL HIT A ROCK CAUSING TRAILER TO TIP OVER
EMPLOYEE WAS ROOF BOLTING WITH A GARDNER DENVER 83 ROCK DRILL. THE LEG KICKED OUT PINNING HIS LEFT THUMB BETWEEN THE DRILL AND THE LEG.
INJURED WAS LOADING DRIFT ROUND WHEN ROCK FELL OUT OF BACK & STRUCK EMPL ON HEAD. BLOW BROKE HIS HARDHAT LINER & KNOCKED HIM TO FLOOR.
EMPLOYEE WAS STANDING AT OPERATOR'S POSITION OF TAMROCK JUMBO. HE REACHED OVER CONTROLS AND PICKED UP A HYDRAULIC VALVE BODY ASSEMBLY. AS HE LIFTED, HE FELT PAIN IN LEFT GROIN AND TESTICLE. T HE EMPLOYEE IMMEDIATELY DROPPED VALVE ASSEMBLY.
INJURED WAS DRI5LING IN THE BACK FOR SPLIT SET INSTALLATION USING A GD S83 JACKLEG HIS HOSES WERE GETTING TOO CLOSE TO HIS FEET SO THE EMPLOYEE LOOKED DOWN AND W/ HIS RT HAND MOVED THE HOSES H IS L HAND WAS R9STING ON THE MACHINE HIS PARTNER ALSO LOOKED DOWN AND THE VICTIM WAS THEN STRUCK BY 3 FT X 3 FT X 6 IN SLAB OUT OF THE BACK
EMPLOYEE WAS US3NG A SCALING BAR TO PUSH A MAT AGAINST THE BACK WHILE ROCK BOLTING. A PIECE OF LOOSE CAME OUT AND STRUCK MINER ON HAND.
EMPLOYEE WAS LO2KING UP WHILE ROCK BOLTING WITH A JACKLEG.A ROCK FELL OUT OF THE BACK AND STRUCK EMPLOYEE IN THE MOUTH.
INJ WAS CHUCK T9NDER FOR ROCK BOLT DRILLER USING PUSHLEG.SMALL PIECE OF LOOSE FELL FROM BACK AS HOLE WAS BEING COLLARED.INJ NOT LOOKING AND WAS STANDING TOO CLOSE TO DRILL.LOOSE STRUCK HIM ON FORARM. 3
EMPLOYEE WAS ST5NDING ON A LADDER WHILE TAKING A HOSE OFF AIR HEADER WHEN HIS LADDER SLIPPED. EMPLOYEE FELL FOUR FEET TO GROUND.
EMPLOYEE WAS ST5NDING ON MUCKER BUCKET TO REMOVE CABLE. ANOTHER EMPLOYEE CUT ROPE HOLDING CABLE UP RELEASING CABLE TENSION, CAUSING EMPLOYEE TO FALL OFF BUCKET-APPROX. 5 FT.
EMPLOYEE WAS RO7KBOLTING IN 202 B WITH 83 JACKLEG.HE CHANGED STEEL IN DRILL,DRILLED OUT TO BACK.WHEN HE PULLED DRILL OUT OF HOLE,CHUCKTNDER ON DRILL FLEW BACK.MACHINE DROPPED,EMPLOYEE WENT DOW N WITH MACHINE.8TEEL CAME OUT OF HOLE,FELL 13' AND HIT EMPLOYEE ON FOOT.
INJ DRILLING HO5ES FOR ROOF SUPPORT USING GD 583 FEED LEG DRILL WHEN ROCK FELL STRUCK HIM ON NOSE.ROCK WAS DISLODGED WHILE COLLARING HOLE.
EXCESSIVE SPEED3- POSSIBLE MECHANICAL FAILURE - POOR JUDGEMENT BY OPERATOR WERE THE CAUSE. OPERATOR SUFFERED BROKEN THIGH BONE AND SEVERELYE MEC DAMAGED KNEE
EMPLOYEE WAS FEEDING ON PLANK THROUGH STATIONARY ROUTER BOARD DICKEDL BACK WHEN A KNOT WAS INCOUNTERED PULLING LEFT HAND WHICH WAS ALREADY PAST THE CUTTING ZONE INTO THE ROUTER BLADES.
EE WAS WLAKING ACROSS SHOP YARD WHEN HE STEPPED ON A ROCK PUTTING A KINK IN HIS BACK. EE CAN RETURN TO WORK OPN LIMITED DUTY. YARD HAS SMALL ROCKS IN IT APPROX 2" IN DIAMETER.
EMPLOYEE WAS CUTTING STRIPS OF WOOD ON A TABLE SAW-THE PIECE OF WOOD HE WAS USING TO PUSH THE WOOD HE WAS CUTTING BROKE AND HIS HAND SLIPPED AND HIT THE SAW BLADE CUTTING HIS FINGER.
SWEEPING FLOOR,PIECE OF METAL BLOWN INTO HIS EYE .EMPL WAS WEARING SAFETY GLASSES.
3"X12"X12\ BOARD FEL HITTING EE IN THE LEG.
I,NAME WAS TRYING TO PUT A LARGE ROTARY DRILL BIT IN THE SIDE BOX OF THE DRILL TRUCK, HE GOT HIS FINGER CAUGHT BETWEEN THE TOOL BOX AND DRILL BIT.
I,NAME WAS HIT BY A SET OF COMA-ALONGS CAUSING HIM TO FALL OFF THE SCAFFOLDING.
TRYING TO PULL A PIECE OF EXPANDED METAL FROM UNDER PILE
I.NAME WAS OPERATING FORKLIFT CARRYING A PIECE OF STEEL 24\X6\X1/4" WHILE TRANSPORTING THE STEEL SECTION A GUST OF WIND CAME UP & THE STEEL HIT I.NAME ON THE HEAD SHOULDER & BACK.
ADJUSTING THE JAW ON JAW CRUSHER WAS STANDING ON BELT WRENCH SLIPPED & CAUSED ME TO FALL.
COMING OUT OF SUPPLY ROOM TO WORK ON VEHICLE,STUMBLED AND FELL AGAINST WORK TABLE.
RETURNING INTO TUNNEL AFTER DUMPING ORE ON DUMP APPLIEC BRAKES IN ROUGH SPOT TO SLOW MACHINE FOOT SLIPPED OFF BRAKE PEDAL AND CAUGHT TOE END BETWEEN MACHINE AND DRIFT RIB OF TUNNEL