Miner was taking the pin retainer cap off of an excavator bucket (heavy round collar weighing about 30-40lbs). EE had to remove three bolts holding the collar on. It released easier than expected. EE's fingers were crushed between the collar and the bucket, breaking EE's left ring, and middle, fingers.
Lisbon Pit Metal/Non-Metal
Seguir esta mina
Avísenme cuando se presente un nuevo incidente de la MSHA en Lisbon Pit.
- Muertes
- 0
- Incidentes totales
- 23
- Años en registro
- 2002–2026
- Último incidente
- May 2026
| Trimestre | Horas trabajadas | Citaciones | S&S | Por 1M hrs |
|---|---|---|---|---|
| 2025 Q4 | 9,243 | 0 | 0 | 0.0 |
| 2025 Q3 | 572 | 1 | 0 | 1748.3 |
| 2025 Q2 | 9,078 | 0 | 0 | 0.0 |
| 2024 Q4 | 8,657 | 0 | 0 | 0.0 |
| 2024 Q3 | 655 | 2 | 0 | 3053.4 |
| 2024 Q2 | 11,740 | 0 | 0 | 0.0 |
| 2023 Q4 | 10,429 | 0 | 0 | 0.0 |
| 2023 Q2 | 10,762 | 1 | 0 | 92.9 |
Incidentes reportables
23 en archivo2026 · 1 incidente
2024 · 1 incidente
Miner was laying down changing a plate on the bottom of the screens on our plant. It is a very awkward position to change them and EE twisted wrong, causing pain in EE's back.
2023 · 5 incidentes
Miner slipped walking in mud and hit head on a concrete block.
Miner was using big bar on conveyor belt of rock crusher machine, rock wedged on machine, worker went to remove wedged rock, right hand slipped, smashing finger against a rock.
EE was having neck pain due to a massive boulder being loaded into EE's AT2 from another loader. The loading of this boulder caused the AT2 to jerk, causing whip lash to EE resulting in major neck pain.
The employee was pulling a piece of removable catwalk out of an HSI and EE pivoted the wrong way and twisted right knee. The knee is swollen.
EE was moving lines under a 100-ton conveyor. The Allen key EE was using to hold the bolts, wrapped around EE's glove and twisted EE's pinky finger resulting in a sprain to the finger.
2022 · 4 incidentes
The employee was replacing the angle iron brace on a metal door. The employee was in a man lift and the door swung down and hit them on the head and the top of the bar on the man lift.
Climbing into a slurry tank and lost footing causing the employee to fall 5 to 6 feet landing on elbow
Climbed over feeder onto the metal lip between feeder and box and foot got stuck
While repairing a fender in the shop, EE missed the fender while breaking it loose with the sledgehammer which caused EE's hand to strike the fender. This caused an injury to EE's left pinky nail.
2020 · 2 incidentes
EE states EE was assisting to clear a flocculent line when EE noticed that the hose line was starting to move as if it was about to fail. EE states EE abruptly turned to run and shut off the air feeding the line, when EE heard the line pop EE turned back to see the extent of the failure. EE believes when EE abruptly turned one way then back the other EE damaged EE's knee.
EE was welding in the HSI crusher. After welding for approximately 4 hours, EE states that a rock "the size of a softball" became dislodged from the crusher above EE and struck EE on head.
2019 · 2 incidentes
While building a temporary staircase at the Lisbon Scale House, EE stepped off the stairs onto unstable gravel. EE caught the edge of the stairwell with EE's left hand for balance, but then slipped another 2', causing EE to strain EE's left shoulder. EE immediately had pain when attempting to rotate EE's shoulder in any direction.
Miner was maneuvering wooden blocks away from a dozer receiving service, using a hand truck. EE's angle for moving the wooden blocks required EE to duck under some equipment and as EE did so, EE felt pain in EE's lower back.
2018 · 1 incidente
Two Miners and one supervisor were installing 24" x 25' plastic pipes. Normally equipment is used to place pipes, but this was impossible due to the location of this specific section of pipe. Miners were physically moving the pipe into place by hand. Miner felt lower-right back and leg pain while lifting and pushing pipe into place.
2012 · 1 incidente
Moving a board over his head, sliding it, then a big couple of popping noises came out of his arm and then it felt like something tore in his forearm.
2011 · 1 incidente
Cutting a piece of metal with a cutting torch the piece fell and EE swung his arm down watching the piece fall and torch burned his shin.
2008 · 1 incidente
EE was standing on the deck of a loader and was cleaning off the snow from the hood. His right foot slipped out from underneath him and he left shoulder fell against the hood of the loader.
2007 · 2 incidentes
EE was splicing a cord (straight line down & away from himself with a circle cut around cord at the end) and he grabbed the cord to pull it off. He was pulling the cord off & towards himself the knife in hand. His hand slipped off cord, & the knife cut his thumb & 1/3 of his tendon. EE got a few stitches on the tendon about 9 on the outside.
Pushing in a catwalk on a Hitachi backhoe and tore the muscles in his shoulder.
2002 · 2 incidentes
WAS ON A LADDER AND LADDER SLIPPED AND FOOT WAS PLANTED. HE WENT TO TURN AND TWISTED KNEE.
EMPLOYEE WAS SHOVELING WET SAND IN OUR SUSSEX PIT AND WENT TO TURN SIDEWAYS AND THEN FELT SOMETHING PULL IN LOWER BACK.