Amrize Crystal River Quarry Metal/Non-Metal

For reasons still unknown, the employee opened an energized 4160v cabinet and it appears that the employee used a 600v meter to test for voltage. This resulted in an arc flash, severely burning the employee and causing catastrophic damage to the electrical switchgear.

A subcontractor truck driver hauling aggregate sales (non-miner) claims injury when truck was struck by another truck driver (side-swipe collision) resulting in muscle soreness/strain. On May 9 trucker was evaluated & released by hospital. On May 16 a follow-up medical evaluation resulted in work restrictions. Truck driver is being accommodated with light duty

Employee was sliding a roller frame along the handrail of floating conveyor when the roller frame began to slide toward water. Employee tried to keep the frame from falling and hit his leg, below the knee, on the mid-rail of the conveyor. Fractured left tibial plateau.

Employee was skinning 4/0 THHN wire with pocket knife and the knife slipped from the insulation and cut his left thigh. Employee has approximate 1" cut on left thigh.

The ee was using a 4-inch flat bar on a conveyor belt as a straight edge for cutting. He started cutting the belt away from his body using a utility knife. While maintaining a grip on the knife, The force of pushing the knife and angle of the blade made the knife come of the cut, glance off of the 4 inch flat bar and made a 3.5cm laceration on the left index finger.

Employee was walking down shop stairs in the rain, slipped and fell. Employee was using handrail. Approximately one week later employee felt tingling in lower legs. Bruised back.

WHILE LIFTING A PIECE OF STEEL WITH A PRYBAR FOR PLACEMENT, THE PRYBAR SLIPPED AND HIT LEFT ELBOW.

REMOVING GRILL OFF LOADER, GRILL SLIPPED AND FELL LANDING ON TOE. COMPOUND FRACTURE- LEFT BIG TOE.

REMOVING TEETH FROM LOADER BUCKET TAPPING LOOSE WITH SLEDGE HAMMER, PIECE OF STEEL WEPT IN TO LEG. RIGHT THIGH-SLIVER OF STEEL.

EMPLOYEE WAS CHANGING GREASE DRUM ON SERVICE TRUCK AND TRIPPED WHGILE GETTING DOWN. EMPLOYEE SPRAINED HIS LEFT WRIST.

WHILE ASSISTING WITH MOVING DRAGLINE TRAIL CABLE DRAGLINE OPERATOR STRAINED BACK.

WHILE TYING BARGE, (SECURING) STERN CABLE, SLICED LEFT RING FINGER.

EMPLOYEE WALKING INSIDE DRAGLINE - FLOOR WAS WET, HIS BOOTS MUDDY. SLIPPED AND TWISTED KNEE.

EMPLOYEE BENT OVER TO PICK UP BOARD AND FELT BACK PULL.

EE WAS OPERATING DOZER AND BACKED OVER A RIDGE AND JARRED NECK.

EMPLOYEE WAS ASSISTING WITH MOVING A ROLLCART/ HOPPER WHEN HIS LEFT HAND SLIPPED FROM THE ROPE & HE GRABBED THE RAIL & THE ROLL CART RAN OVER HIS HAND. BROKE THREE FINGERS & LACERATED ONE.

CARRYING ROLLER WITH ANOTHER EMPLOYEE TURNED TO GET DIFFERENT GRIP & PULLED MUSCLE IN BACK

EMPLOYEE LIFTING A SENSOR ROLLER ONTO MOVING CART FOR FLOATING CONVEYOR-HURT ELBOW.

EMPLOYEE WAS CHANGING BUCKET TOOTH ON DRAGLINE, SLEDGE HAMME HIT BOLT WHICH KNOCKED TOOTH OFF AND WENT EMPLOYEE'S LEG.

EMPLOYEE WAS PULLING CABLE, LOST FOOTING AND PULLED MUSCLE IN BACK.

FINGERS GOT HUNG UP IN SHEAVE- CUT FINGERS.

BATTERY BLEW UP IN HIS FACE.FACIAL CUTS AND BURNED CORNEAS.

I.NAME WAS HAMMERING AND HAND SLIPPED AND PIECE OF METAL WENT INTO HAND.

VEHICLE RAN OFF ROAD AND THEN OVERTURNED.

SMASHED HAND BETWEEN CROW BAR AND PIC TOOTH ON CRUSHER.BRUISED HAND-LEFT.

FELL FROM OFFICE DOOR TO GROUND AND INJURED HAND RUPTURED TENDON IN LEFT LITTLE FINGER.