Chalk Hills Quarry Metal/Non-Metal

EE was adjusting air pressure on an air ram when the ram suddenly came down and caught EE's hand. EE went to the after hours clinic where they put 3 stitches in EE's left hand.

Was using a razor blade knife to cut insulation off an electrical wire. The knife slipped causing a cut across the middle finger on left hand.

Employee was carrying a rotary airlock plate from outside to the maintenance area in the warehouse to replace seals in the plate. EE slipped on the wet concrete ground causing EE to fall to the ground. The plate slipped out of EE's hands in the process of falling and once EE was on the ground the plate fell on EE's right leg. It had been raining off and on the morning of.

Employee was standing on a step, stacking pallets on a palletizer. The last pallet was placed on the machine crooked. While using bodily force to free the pallet, they stepped back off the step feeling a knee pop causing them to fall to the ground. As they stood back to their feet, they felt the knee pop again.

A contracted truck driver was loaded and getting ready to leave our property when EE noticed EE's front hub cap was missing. EE knelt down to check EE's wheel seal. While getting back up EE hit EE's head on EE's truck mirror leaving a cut in the side of EE's head. EE was taken to the hospital where they put 5 staples in EE's head. EE immediately returned back to work.

the miner was using a small sledge hammer to beat product out of a bin. While swinging the hammer, he struck an I bolt that's welded to the bin for lifting purposes. He went to the emergency room where they told him his thumb was broken. The Doctor told him to keep it taped up for a couple weeks and to come back if the pain got worse. The miner never had a second visit.

Slipped off hopper and twisted back

In the bagging warehouse, on the second level of bulk bags, while stepping down to lower level of bulk bags, caught foot in loop of a bulk bag and fell to next level on left arm, face, and side.

After loading a pneumatic, the spillage on the trailer was being blown off with an air hose when a chunk of dried cement came in contact with ee's eye.

EMPLOYEE'S ARM WAS PINNED BETWEEN BAG SPOUT AND THE BAG PLACER ON OUR 50 LB. BAGGER

DOOR ON BLDG WERE CLOSED BECAUSE OF COLD WEATHER, WE WERE OPERATING FORKLIFTS AND ALSO HAD A KEROSENE TORPEDO HEATER BURNING.

DOORS ON BLD WERE CLOSED BECAUSE OF COLD WEATHER& WE WERE OPERATING FORKLIFTS & HAD A KEROSENE TORPEDO HEATER BURNING.

DOOR ON BLDG WERE CLOSED BECAUSE OF COLD WEATHER, WE WERE OPERATING FORKLIFTS AND ALSO HAD A KEROSENE TORPEDO HEATER BURNING.

MINER WAS LIFTING A ELECTRICLA MOTOR MANUAL THAT WAS TO HEAVY AND CAUSED STRAIN ON HIS BACK. MINER SHOULD HAVE USED A PIECE OF EQUIPMENT TO LIFT AND MOVE HEAVY MOTORS OR ANY HEAVY OBJECT SO NO T TO HURT HIS BACK.