Cada lesión y muerte que la MSHA tiene registrada. Filtra por estado, año, sector, clasificación, experiencia o cualquier palabra clave de la narrativa del investigador.
Envíame un correo cuando un nuevo incidente coincida con estos filtros. Un correo de confirmación; cancela la suscripción cuando quieras.
Electrician had the dredge control panel propped open. The prop failed causing the panel to slam down striking EE's left arm just above the wrist. Urgent Care assessed injury as a contusion with no broken bones and directed right handed duty only until follow up appointment to reassess the injury.
While installing a timing belt on a screen, the counter weight came down pinching employee's middle two fingers on left hand between counter weight and flange. Diagnosis: Open fracture; injury of nail bed of finger.
On 9/27/24, employee was tightening 5/8" bolts with two wrenches when EE felt a sharp pain in the wrist. EE's wrist and hand became swollen. An x-ray revealed EE had a small piece of metal embedded in their hand from a scratch EE received the day before. Medical professionals removed the metal from EE's hand. EE's wrist was only strained.
Employee was dismantling a piece of equipment on the floor of the shop, EE stuck the back of EE's hand on a nearby wooden pallet and received an 1 1/2" long sliver in the back of EE's hand. Medical personnel cut the skin to push the sliver through to remove it.
Employee was adjusting a feed chute to prevent spillage. The chute is suspended by two chains. When the employee loosened one chain, the chute swung over and struck employee in the head. Employee had left hard hat in the truck and was not wearing it.
Changing screen and finger got pinched between bolt lock and side plate.
Employee was assisting with maintenance activities. EE was lifting a pulley shaft out of the bed of a truck and dropped it on their foot.
Truck driver forgot to latch the tailgate before being loaded. EE tried to clear stones from the latch by hand. EE's fingers got pinched by the tailgate and lacerated by the latch.
While shoveling material off of a radial stacker, the employee reported feeling pain in abdomen that continued throughout the day. After following up with the physician, EE was diagnosed with a hernia on 8/27/21. Repair surgery is scheduled for 10/14/21. EE currently has not lost any time and is not on restricted duty.
Company electrician was lifting a 40lb roll of wire into a van from the ground and injured their shoulder. Electrician did not lose time at the time of the incident, but needed surgery to repair the injury on 11/28/2018.
Employee was bending over to put a steel cover on a pontoon when EE felt a sharp pain in EE's lower back.
Injured employee was changing screen panels and cut a finger on the Unistrut channel that holds the panels in place. Employee needed to go to an urgent care facility where Dermabond was used to close the wound.
Two employees were hand-loading a fuel pump into the bed of a pick up truck. As they set the unit down, One employee had finger crushed by the pump base. EE had surgery to repair the finger on 11/17 and returned to work on 11/21. EE is currently on restricted duty.
Employee was turning a 4-sided die on the press brake. One end of the die slipped off the support chain and crushed the employee's finger.
3 employees were assembling conveyor sections to extend the field run. One section was not lined up properly. An employee attempted to pull it into alignment by hand & felt pain in his abdomen. He didn't immediately seek treatment. He later saw a doctor & was diagnosed with a hernia & will be scheduling surgery. He reported the injury on 5/23/14.