Buscar en el registro

The crew was unrolling cable from a spool. The employee was still holding on to the cable when the spool moved backwards. The employee did not report any issue until 8/2/2013 when he claimed the cable jerked him and complained of a strain in his lower back. Employee was sent to the doctor on 8/2/2013 and the doctor recommened physical therapy, which was completed on 10/10/2013.

Electrican tighting up the guywire for overhead electric line and the guy wire insulator snap into, two parts and one part fell onto EE's lower left arm and cut the skin and left a deep cut.

Employee was pulling a rock out that was wedged between the primary crusher frame and some grease lines. When he dislodged the rock, it fell and pinched the little finger of his left hand against a steel cross member.

EE was jacking & cribbing the Cat 990 Loader to remove the rear end. Sliding wooden blocks under the loader he ran a splinted in palm of hand. He pulled exposed splinter out & continued to work the rest of the day(Friday). He came back Monday & his hand was swollen. He reported the accident & asked to go to a doctor to see if some of the splinter was still in the hand.

EMPLOYEE WAS BENDING OVER TO LAY A SMALL PIECE OF CARDBOARD ONTO THE FLOOR IN THE GARAGE. AS HE WAS BENDING OVER HIS BACK SLIPPED OUT.

HE WAS CLIMBING DOWN OUT OF MACHINE. HIS FINGER CAUGHT ON THE SPRING THAT HOLDS THE DOOR LATCH. WIRE WENT INTO HIS FINGER. NO STITCHES WERE NEEDED. TETANUS SHOT WAS GIVEN.

THE EMPLOYEE WAS REPAIRING SPARE FRESH WATER PUMPS & INJURED HIS BACK WHILE ATTEMPTING TO LIFT THE PUMP SHELLS

LIFTING STRAIN OR INS.

MECHANIC WAS WORKING ONT EH BRAKES OF A 980C LOADER. HIS ASSISTANT AND HIMSELF HAD THE RIM PROPPED UP WITH TWO-BY-FOUR BOARDS LAID ON THEIR EDGE. THE BOARDS SLIPPED AND THE MECHANIC'S FINGER S WERE PINCHED.

EE WAS ATTEMPTING TO LIFT A PIECE OF STEEL BY HIMSELF WHENHE REALIZED THAT IT WAS TOO HEAVY WHEN HE SET IT BACK DOWN HE PINCHED HIS FINGER BETWEEN THE STEEL & THE BOARD THAT IT WAS SETTING ON

INJURED WAS CUTTING A PIECE OF 5/8" STEEL THAT WAS LEANING AGAINST A HAND RAIL. HE WAS PUTTING A CLAMP ON ONE END OF THE SHEET OF STEEL HE WAS CUTTING. HE FINISHED CUTTING OFF THE PIECE OF S TEEL. THE PIECE FELL AND HIT INJURED'S RIGHT HAND ON THE LITTLE FINGER.

EE WAS WORKING ON PUTTING BRACES IN THE LOWER PART OF THE TRUCK HOPPER. HE WAS PUTTING IN THE FRAME STRUCTURE. THIS IS A TIGHT AREA TO WORK. YOU HAVE TO DO A LOT OF LIFTING BY HAND AND YOU CAN T STAND UP STRIGHT. EE SAID THAT WAS THE AREA HE WAS WORKING IN WHEN HE FORST NOTICED PAIN.

INJURED WAS LEANING AGAINST THE SHOP DOORS OFF THE MAIN GARAGE THAT WERE IN THE LOADER BUCKET. HE WAS USING HIS SHOULDER TO BALANCE THE DOORS UNTIL THE BUCKET WAS ROLLED BACK FAR ENOUGHT TO BA LANCE THE DOORS. AFTER HE WALKED AWAY A FEW STEPS HE SAID HE FELT A PAIN IN THE MIDDLE OF HIS BACK. IT ALSO HURT IN THE MIDDLE OF HIS CHEST WHEN HE WOULD TAKE A BREATH.

EMPLOYEE WAS HELPING PLANT APPRENTICE PUT SCRAPE MATERIAL FTOM AROUND PLANT AREA INTO HIS FRONT END LOADER BUCKET THEY WERE LIFTING AN OLD SECTION OF STEPS THE EMPLOYEE HEARD A POP IN H IS BAC K HE DUMPED THE LOAD & THEN LOADED A TRUCK WITH ROCK HIS BACK DID NOT HURT WHILE HE WAS SITTING & OPERATING HIS LOADER WHEN HE GOT OFF HIS LOADER & WALKED HIS BACK HURT HE CAME TO THE OFFICE

EMPLOYEE REMOVE8 RADIATOR CAP FROM LOADER AND RECEIVED STEAM BURNS TO LEFT ARM & LEFT LEG.

REPLACING LOOSE3GUARD ON CONVEYOR.

SPRAINED OR DISLOCATED BACK WHILE SPOOLING CABLE ON SPOOL. EMPLOYEE WAS REELING 5/16 CABLE ON SPOOL AND ROLLED SPOOL OVER WHEN ACCIDENT OCCURRED

RANDY WAS WORKING ON A LOADER UNDERNEATH WHEN A FOREIGN OBJECT FELL INTO HIS EYE