Buscar en el registro

Taping a blast hole, reached down to grab EE's tape measure, felt a pop in EE's back.

Employee was welding and lifted his shield to chip. A piece of slag went into his eye-lid. The slag was removed and he worked the remainder of the shift. The next day he came to work at 4pm and worked until approximately 9pm. At 9pm while rubbing his eye and it became irritated so he went to Greenbrier Medical Center and was told he had a corneal abrasion.

Replacing compressed gas cylinder from service truck. He began moving it by rotating the cap when the cap came off the bottle and hit him in the tooth. The tooth has chipped and had to be capped.

Miner was positioning screening cloth on top screening deck when his pinky finger got cut between the cloth and screening structure. Miner was not wearing gloves when the accident occurred. Miners finger required stitches which makes this accident reportable

Employee was rocking the sheave on the grizzly feeder with his right hand because he thought the bearings were going out. Turned to talk to the employee beside him and caught his free hand (left) between the belt and the pulley, cutting off the very tip of his finger.

Employee was at the plant installing a shaft. Felt something in his back "twitch". Employee did not mention the injury until 04/06/2006 to report the injury. Employee said his back has been hurting him since the injury. The injury has just recently become reportable due to appointment with a neurosurgeon resulting in loss of 1 day and Rx medication.

LIFTING DRILL HAMMER & HURT HIS BACK. ACUTE SPRAIN IN BOTTOM RIGHT SIDE OF BACK.

Employee was replacing the lid onto the impact crusher, as he turned the lid into place it pinched his finger causing a laceration.

WAS BENDING A PIECE OF METAL 8"X2"X1/8" WHEN THE METAL CAUGHT THE RIGHT INDEX FINGER BEHIND THE NAIL AND PINCHED THE TIP OF THE FINGER OFF.

WAS PUTTING SCREEN CLOTHE IN SCREEN WHEN THE CLOTHE CAUGHT ON SOMETHING CAUSING SCREEN TO COME BACK AND MASH FINGER.

EMPLOYEE WAS REMOVING A CUTTING EDGE FROM A LOADER BUCKET, WHEN IT CAME OFF IT BOUNCED AND HIT ON HIS RIGHT FOOT.

EMPLOYEE WAS PUTTING SHIMS IN JAW CRUSHER WHEN HE FELT PAIN IN HIS BACK.

EE BENT OVER TO RAISE LID ON MAIN WATER VALVE AT JAW, WHEN SHE FELT A SHARP PAIN IN HER BACK.

EE WAS LIFTING THE HOOD COMPARTMENT OVER THE ENGINE OF THE ROCKBREAKER WHEN HE FELT A TWINGE IN HIS BACK. HE REPORTED IT THEN BUT DID NOT GO TO THE DOCTOR UNTIL 12/26/00.

EE WAS CHANGING OUT A CARBON DIOXIDE TANK AT 1:30 PM. AT ABOUT 5 PM, HE FELT HIS BACK TIGHTENING UP.

EE WAS PUSHING ON A GATE HANLE ON A VIBRATING SCREEN WHEN HE FELT A PAIN IN HIS LOWER TO MID BACK.

EE WAS PUSHING ON A GATE WITH 2 OTHER EES. ABOUT 15 MINUTES LATER, HE WAS SWEEPING THE FLOOR AND FELT A PAIN IN HIS BACK.

EMPLOYEE SQUATTED DOWN TO MOVE A BARREL OF PARTS. HE PUSHED ON BARREL, BUT COULDN'T MOVE IT. ABOUT 15 MIN. LATER, HIS RIGHT LOWER BACK TIGHTENED UP AND HE COULDN'T BEND HIS HEAD DOWN.

EMPLOYEE WAS CARRYING SCREEN CLOTH UP STEPS WHENHE FELT PAIN IN HIS LOWER LEFTHAND SIDE OF BACK.EMPLOYEE WENT TO DOCTOR ON 5/25/2000.

EE WAS PICKING UP A 5 POUND PIECE OF METAL IN THE SHOP WHEN HE FELT A PAIN IN HIS LOWER BACK. HE WENT TO DOCTOR AND THEY SAID IT WAS MUSCLE SPASMS AND PUT HIM ON 3 DAYS OF LIGHT DUTY IN WHICH HE COULD NOT LIFT ANY MORE THAN 20 LBS.

EE WAS LIFTING A 3 GAL. BUCKET OF 57'S TO POUR INTO A SMAPLE SPLITTING DEVICE IN LAB. WHEN DOING THIS, GHE FELT A TWINGE IN HIS RIGHT SIDE. HE PULLED A MUSCLE IN HIS RIGHT RIBCAGE. EE STATED T HE BUCKET WEIGHED 30-40 LBS.

WELDER CUT FOREFINGER FIRST JOINT LEFT HAND WHILE INSERTING A BOLT INTO METAL PLATE SHARP EDGE OF METAL CUT FINGER REPORTED TO DR IMMEDICARE CRESCENT ROAD BECKELY 7 STITCHES TO CLOSECUT

WAS DRILLING BOLTS OFF OF ROLLER ON DOZER AND STARTED TO WIPE BROW AND A PIECE OF METAL FELL FROM GLOVE INTO RIGHT EYE.

EE WAS SHOVELING UNDER BELT AT SAND PLANT WHEN PAIN DEVELOPED IN BACK & RIGHT LEG

CRANE REPAIR REMOVING GEAR PINION. USED HAND TO PUSH GEAR OUT TO GROUND. GEAR PINNED HAND ON GROUND.

EE WAS LIFTING TIRE OFF WHEEL DOLLY, TIRE SLIPPED FORWARD CAUSING EE TO LOOSE BALANCE THUS STRICKING CHIN AGAINST TOP OF TIRE DOLLY.

EMPLOYEE WAS UNDER TRUCK BRAISING MUFFLER WHEN A PIECE OF MOLTEN BRASS STRUCK HIS LEFT ARM.

MUSCLE SPRAIN FROM LIFTING AND SHOVELING TAIL PULLEY SCREEN PLANT NUT IN PRODUCTION AFTER 1730

EE WAS SHOVELING XXX STONE FORM UNDER PULLEY TOMAINTAIN EQUIPMENT OPERATION WHEN HE EXPERINECED LOWER BACK PAIN AND NUMBNESS IN HIP.

SETTING CRUSHER. MASHED HAND BETWEEN CRUSHER AND PIECE OF SUPPORT.

MOVING METAL BOX FROM END LOADER, LID SLIPPED AND CAUGHT MIDDLE FINGER ON LEFT HAND CUTTING END OF FINGER ALMOST OFF.

EE WAS ON PLATFORM LOOSENING BOLT ON GUARD. ANOTHER EE WAS ON OTHER SIDE OF GUARD ASSISTING. HE KICKED GUARD. GUARD FELL ON OTHER EE INJURING HIS RIGHT HAND.

EE WAS PICKING UP A WELDER AND PULLED MUSCLE IN HIS BACK.

EE WAS LIFTING A PIECE OF METAL AND INCURRED BACK PAIN.

HE WAS CARRYING LARGE BOX TO SCALEHOUSE OFFICE FROM SUPERINTENDANTS' OFFICE BUILDING. BOX OBSTRUCTED VIEW AND HIT LEFT KNEE ON METAL POLE THAT WAS PLACED AS BARRIER.

EMPLOYEE STATED HE WAS WORKING ON CABLE ON 988-B WHEEL LOADER AND GOT OFF OF LOADER, PULLED MUSCLE IN BACK ON THE LEFT SIDE.

LIFTING A PIECE OF METAL INTO BACK OF TRUCK.

BRINGING A PIECE OF METAL INTO SCREEN HOUSE, HIT DOOR FACING AND METAL SLIPPED CUTTING 5 TH. FINGER ON RIGHT HAND.

MAINTENANCE MAN WAS REMOVING A PORTION OF EXHAUST PIPE (CAST IRON, APPROX. 16" IN DIA, WEIGHING APPROX. 40-60 LB) FROM A 769-C 35-TON CAT HAUL TRUCK. EXHAUST WAS UNBOLTED, BUT JOINT WAS STUCK. WHILE IN PROCESS OF BREAKING JOINT CONNECTION, THE UNION SUDDENLY BROKE AND SECTION OF EXHAUST FELL ON LEFT HAND, WHICH WAS POSITIONED ON TRUCK FRAME FOR SUPPORT AS SUBJECT WAS STANDING ON TH

EMPLOYEE FAILED TO REMOVE HIS HAND FROM THE DOOR JAM OF THE LOADER

EMPLOYEE TOOK BATTERY BOX LID TO 988B TO CHARGE BATTERY (TO JUMP IT OF) HE PUT THECABLES ON THE LOADER THE CABLES FELL & HIT THE LID TO THE BATTERY BOX THE LID FELL ON EMPLOYEES FINGER

WAS LOADING TIRE INTO SERVICE TRUCK, WHEN TAIL GATE BROKE CAUSING STRAIN ON BACK.

THE EMPLOYEE WAS HELPING PUT NEW VBELTS ON DRIVE THEY WERE ROLLING BELTS ON WITH SHEAVE BY TURNING IT WHEN SHEAVE TURNED OVER IT TWISTED EMPLOYEES LEFT WRIST & WRIST THEN CAME IN CONTACT WITH THE SHEAVE GUARD

EMPLOYEE DRILLED HOLE FOR ANCHOR TO SAFETY BELT, BENT DOWN TO PUT ANCHOR IN HOLE, A PIECE OF STEEL FELL FROM STEEL HOLDER & HIT HIM IN LOWER BACK.

EMPLOYEE WAS PULLING PUMP OUT OF POND, WHEN HE ATTEMPTED TO THROW CHAIN ACROSS I BEAM, CHAIN CAME BACK HITTING HIM IN THE MOUTH, BREAKING A PIECE OF THE EYE TOOTH ON THE RIGHT SIDE.

WAS LIFTING SACK OF STONE TO BE TESTED.

EMPLOYEE WAS ATTEMPTING TO COME DOWN A LADDER FROM 180-D SHOVEL.

DOING MAINTENANCE TO PRIMARY CRUSHER EMPLOYEE WS CRAWLING OUT FROM BENEATH PITMAN ON PRIMARY CRUSHER WHEN HE STOOD U P MISJUDGED DISTANCE FROM BEAM & STRUCK MIDDLE OF HIS BACK AGAINST IBEAM

PICKED UP A SLAT SCHIP WEIGHING APPROX, 10 LBS. FELT A SHARP PAIN LIKE "HIS BACK WAS GOING TO BREAK IN TWO. CONTINUED TO WORK U NTIL 3:30 P.M., HIS NORMAL PUNCH-OUT TIME. DID NOT REPORT TH IS INCIDENT TO ANYONE. H E SAID H E TOOK 6 TYLENOL. CAM TO WORK 10/26/93/ INJURED CAN TO THE OFFICE AND REPORTED HE HAD INJURED HIS AND WAS GOING TO THE DOCTOR. HE WAS TOLD TO REPT THIS FR

EE UNLOADS SAW TABLE-FINISHED PRODUCT AS WELL AS WASTE MATEIRAL. INJURED EE PICKED UP SOME WASTE MATERIAL FROM TABLE AND WAS THROWING IT IN THE WASTE CONTAINER. THE SLATE BROKE INTO AND FELL A CROSS HIS LEFT FORARM, CUTTING HIS FOREARM, REQUIRING STITCHES TO CLOSE.