Buscar en el registro

Employee was carrying hydraulic oil containers from shop to loader and sprained ankle while walking over concrete pad that had mounds of topsoil on it.

Employee was shoveling material and felt a painful pop in EE's lower back.

Electrician had the dredge control panel propped open. The prop failed causing the panel to slam down striking EE's left arm just above the wrist. Urgent Care assessed injury as a contusion with no broken bones and directed right handed duty only until follow up appointment to reassess the injury.

While installing a timing belt on a screen, the counter weight came down pinching employee's middle two fingers on left hand between counter weight and flange. Diagnosis: Open fracture; injury of nail bed of finger.

Employee was adjusting a feed chute to prevent spillage. The chute is suspended by two chains. When the employee loosened one chain, the chute swung over and struck employee in the head. Employee had left hard hat in the truck and was not wearing it.

Employee was assisting with maintenance activities. EE was lifting a pulley shaft out of the bed of a truck and dropped it on their foot.

3 employees were assembling conveyor sections to extend the field run. One section was not lined up properly. An employee attempted to pull it into alignment by hand & felt pain in his abdomen. He didn't immediately seek treatment. He later saw a doctor & was diagnosed with a hernia & will be scheduling surgery. He reported the injury on 5/23/14.

Employee was cleaning the spirals of a sand screw with a wire grinding wheel. A wire from the wheel broke off and struck his eye.

The employee was lifting bags of cement and felt pain in his back. He did not seek medical treatment at the time of the injury. On 10/14/2010 he saw a physician and was told to take a leave of absence to have back surgery.

EE WAS STANDING ON A CONVEYOR, REACHING AND EXTENDING HIS BODY TO LIFT CHAIN FALL TO JIB CRANE OVER THE CRUSHER BASE. THIS INCIDENT OCCURRED IN FEBRUARY, BUT THE EE DID NOT SEEK MEDICAL ATTENTION OR TAKE TIME OFF FROM WORK UNTIL MARCH 25TH.

WHILE FUELING LOADER, THE HANDLE ON THE NOZZEL STUCK, EMPLOYEE TURNED AROUND TO SHUT OFF PUMP, TWISTING BACK AND HIP.

EE WAS CHECKING THE WASH PLANT BEFORE START-UP, CLEANING THE FEED CONVEYOR AND ATTEMPTING TO REMOVE A PIECE OF WOOD FROM THE BELT. THE EE PINCHED HIS FINGER BETWEEN THE SIDE OF THE HEADSTOCK & THE FEED BOX.

EMPLOYEE WAS CARRYING SKIRT BOARD RUBBER UP A FLIGHT OF STAIRS WHEN HE APPARENTLY PULLED A MUSCLE IN HIS UPPER RIGHT LEG.

EE WAS INSIDE SCREEN WORKING ON PLANT WHEN SOMETHING GOT INTO RT EYE.

EMPLOYEE WAS OPERATING WATER TRUCK(WATEERING DRIVEWAY). NOTICED REAR VALVE WAS NOT WORKING. HE LEFT SWITCH ON IN CAB AND WHEN HE GRABBED THE VALVE TO CHECK IT, THE VALVE OPENED PINCHING HIS RIGHT HAND BETWEEN VALVE AND THE TRUCK.

EMPLOYEE WAS WORKING ON CONVEYOR. PIECE OF RUST WENT IN EYE. PIECE WAS REMOVED ON 10-26-95 BY DOCTOR.

EE WAS ATTEMPTING TO REMOVE A LARGE ROCK FROM A CRUSHER. SOME STONE FRAGMENTS FLEW INTO EE LEFT EYE.

NEW EE, 1ST DAY ON JOB, CLAIMS TO HAVE HURT HIS SHOULDER WHILE PULLING A SIGN OUT OF THE GROUND.

EMPLOYEE ALLEGEDLY BUMPED LEFT KNEE ON LADDER OF HI-LIFT WHILE CLIMBING INTO CAB OF MACHINE.

EMPLOYEE WAS WORKING WITH A PIECE OF ANGLE IRON IN SHOP. PIECE OF IRON SLIPPED LANDING ON HIS BIG TOE-BREAKING. TOE.

STANDING NEXT TO ANOTHER EMP WHO PICKED UP PIPE CAUGHT EMP ON TOP OF L HAND STITCHES

LIFTING TOGGLE SEAT INTO PLACE ON JAW CRUSHER.HERNIA REQUIRING SURGERY 6-10-91.

DROPPED PINCH BAR ON L FOOT

WHILE EMPLOYEE WAS CHANGING FILTER IN CRANE, FILTER SLIPPED CUTTING LITTLE FINGER ON LEFT HAND.

VALVE AT BACK 2F HOT OIL TANKER APPARENTLY WASN'T COMPLETELY OFF WHEN EE TRIED TO REMOVE HOSE FROM TANK. HOT OIL BURNED EES BACK OF RT ARM & HAND.

IT IS ALLEGED THAT WHILE CHANGING SCREENS ON PROCESSING PLANT EMPLOYEE DROPPED SCREEN ON LEFT FOOT SPRAINING BIT TOE.