Buscar en el registro

Installation of guard. When guard was put into place employee's hand got caught in a pinch point.

Employee was removing a cutting edge bolt on a loader bucket and it cut a finger. Was wearing mechanics vinyl gloves.

Employee was palletizing and used their left knee to push on the stack of rocks to straighten them causing a bruise reported on 8/9/19. Employee requested medical attention on 8/12/19.

Employee was palletizing landscaping rocks when EE felt a burning sting in the lower right side of the abdomen. The employee had hernia surgery early this year in February. EE was seen in urgent care at the Health Center that same day and had an ultrasound on 7/01/2019. Diagnosis was a strain in the lower right abdomen, no damage to the repaired hernia.

Employee was lifting roll of fencing to wrap pallets and as they sat down the roll they dropped the roll in a weird way and felt their shoulder pop.

Employee was installing new boards to lowboy trailer. They bent over to pull out a new board, when they felt a pop in their back, no pain at the time. Employee did not request help to move the board when other employees were in the area.

Employee was pulling a rock from the sorting line to the discharge line and got finger caught between the rock and cross brace smashing the left ring finger.

Employee was palletizing rocks when ee pulled a stone from pile and another shifted and smashed middle finger on right hand.

Employee was processing stone and went to lift a piece of stone and felt a pain in their lower back. They refused medical at time of event. Employee went to doctor on 5/8/2017 and doctor put them on light duty.

Employee was palletizing stone and as ee stood up after picking up a stone ee felt pain in lower back. Employee did not request medical attention for this until 4/17/17.

Employee reported on 3/21/2017 that they pulled lower back muscle when employee twisted while moving product

Employee held on to the head of a worn plow bolt while another employee tried to take the nut off. Bolt spun in employees fingers and cut them.

Employee was palletizing and as EE removed a stone from the pile to place on the pallet, another stone slid down and caught the employees right hand ring finger, crushing it.

Employee was helping to install a V-Belt on motor sheave, and got ring finger caught between the two crushing the finger.

Employee did not report the incident to his supervisor until 12/16/15 which was diagnosed by a doctor to be tendonitis. Employee incident report stated that he was dismantling the suspension on a 1 ton service truck on 12/8/15. When he awoke on 12/9/15 he was experiencing pain in his left wrist. He worked for one week without telling anyone.

Employee performing a pre-shift start up and while opening inspection doors to check shoes left door bound up. While positioning himself to get a second hand and better grip on the door to apply more force to try and overcome the bind, the door fell back down on his right index finger. Employee went to emergency room and received 11 stitches but is back to work on modified duty.

Lifting and throwing rock out of haul road. Employee developed lower back pain.

Employee was removing an I-beam when one end of it unexpectedly dropped, raising the other end, pinching his finger between the beam and a chute causing his right middle finger to be cut.

Stacking landscaping rocks on a pallet. As he grabbed a rock from the pile, a rock from above slid down and struck his hand bruising his third finger.

Pulling on screen gates when he felt a burning sensation in his abdominal muscles.

Employee was lifting a piece of screen cloth to the screen deck when he bumped a piece of screen cloth that was staged to be lifted causing it to shift and strike his left hand cutting his fingers. He received stitches to his middle and ring fingers.

Employee was stacking rocks onto a pallet when a rock slipped and pinched his left middle finger. He received 3 stitches in his finger.

Employee was installing a gear box. The gear box slid off the shaft and pinched the employees finger causing a cut on the finger.

Employee was replacing a sheave on a motor overhead. The taper lock came loose and the sheave struck the employee on the back of his hard hat causing a slight strain to the employees neck muscles.

Doing cleanup shoveling under a conveyor, injured back.

INCIDENT NOT REPORTED UNTIL OCTOBER 9, 2006. Employee claims original injury occurred 06/02/06. He did not inform the company until 10/09/06. EE claimed, "Nothing out of the ordinary" the he could remember to cause the injry. EE indicated he has injured this body part (lower back strain) before.

WORKER WAS CARRYING A STEEL GRATE. GRATE SLIPPED FROM HIS HAND AND STRUCK HIS LEG CAUSING LEG TO BE CUT & SCRAPED.

WORKER WAS UNLOADING 128TH ANVILS AND SMASHED/CUT FINGER ON LEFT HAND WHEN 2 ANVILS COLLIDED.

EMPLOYEE DROPPED HEAVY OBJECT ON LITTLE FINGER OF LEFT HAND AND CUT IT OPEN.

WHILE OPENING INSPECTION DOOR ON UD OF VERTICAL SHAFT IMPACT CRUSHER, HE LOST HIS GRIP ON THE DOOR AND IT FELL CLOSED, STRIKING RIGHT BIG TOE. EMPLOYEE DID NOT GO TO DR FOR 2 WEEKS.

EE WAS SHOVELING MATERIAL SPILLAGE FROM UNDER A CONVEYOR AND FELT SHDDEN PAIN IN RIGHT SHOULDER.

EMP WAS MOVING A SMALL ELECTRICAL STARTED WHEN SHE LOST HER GRIP AND DROPPED IT ON HER FOOT.

EE WAS LIFTING ANFO BAGS OUT OF DELIVERY VAN

EE WAS SHOVELING DIRT FROM UNDERNEATH CONVEYOR WHEN HE FELT A SHARP PAIN ACROSS HIS LOWER BACK.

EMPLOYEE WAS INSTALLING A FLIP GATE. HE WAS TRYING TO PUT THE CONNECTING PIN IN THE LINKAGE WHEN THE GATE MOVED SMASHING HIS FINGER BETWEEN THE CYLINDER AND THE LINKAGE ARM.

EE WAS OPERATING AIRTRACK. EE LIFTED A PIECE OF STEEL TO PUT IT IN THE RACK WHEN HE LOST STRENGTH IN ARM AND FELT SHARP PAIN.

EMPLOYEE WAS PULLING BAR OFF OF THE CONVEYOR WHEN THE BELT COVE SLID DOWN THE BAR SMASHING 3,4,5DIGITS ON RIGHT HAND BETWEEN THE BELT COVE AND FLAT STOCK ON END OF THE BAR.

EE WAS MOUNTING A GEARBOX AND MOTOR ON A CONVEYOR. HE ATTEMPTED TO PUT THE BOLT IN THE TORQUE ARM. THE GEARBOX AND MOTOR CAME DOWN SMASHING HIS HAND.

EMPLOYEE WAS GRINDING & WELDING IN THE SHOP AREA IT WAS A HOT DAY EMPLOYEE REMOVED HIS SAFETY GLASSES TO WIPE SWEAT FROM HIS FACE SOMETHING GOT IN HIS EYE CAUSING IRRATIATION TO EYE

EE WAS ROLLING 1 FULL BARREL AND 1/3 OF A BARREL OF USED OIL ONTO THE FORKS OF THE HYSTER FORKLIFT.

WHILE LIFTING VAN DOOR EMPLOYEE STRAINED BACK

WHILE TRYING TO OPEN SMALL GATE ON DUMP TRUCK PULLED DOWN & BACK POPPED VERTIBRE OUT OF PLACE

WHILE CLOSING GATE EMPLOYEE PULLED HARD AND TWISTED BACK

WHILE INSTALLING PLANTORY AXLE ON TEREX LOADER STRAINED LOWER BACK AFFECTING LEFT LEG & HIP.

EMPLOYEE WAS CLEANING ROCK FROM A SCREEN WHEN A ROCK CHIP STRUCK HIS KNEE.

ATTEMPTING TO OPEN SHOP DOOR WHICH WAS STUCK.RIGHT SHOULDER MUSCLES AND TENDONS WERE STRAINED.