Buscar en el registro

While installing the mounting flange to the wash plant waste pump, the flange fell off the housing seat approximately 2" smashing his left thumb between the flange and shaft of the pump. His thumb required some stitches but no broken bones.

While closing a sliding window in the crusher shack, the window came off track. EE pushed on the window to put it back on track and the window glass broke cutting his right hand.

While removing cutting edge bolts from a cat 988H loader, EE used his hand to push up a volt to lock it into place. At the same time he hit the trigger of the impact wrench with his other hand causing the bolt to spin in his hand. The worn bolt head cut his thumb through his leather glove. He was wearing all requited PPE and the loader was locked out and tagged.

Jaw crusher was plugged while cleaning rocks out strained his lower back. EE did not report pain in his back unitl 8/21/08.

Helping change crusher liner holding onto tag line and stepped between crusher and catwalk area. **Employee reported to plant manager and they determined no injury. On 7/17/07 the employee's elbow was swollen & he was sent to the clinic and fluid was removed.**

While working on chute liner employee holding steel plate lost his grip and plate landed on employee's foot, leaving a sliver of steel in his foot.

Quality control employee emptying sieve screens and a small particle of rock or dust bounced into his eye under his safety glasses.

REMOVING DEAD BED FROM UNDER JAW BELT, THUMB WAS PINCHED BETWEEN DEAD BED AND JAW FRAME.

WHILE CLEANING JAW CRUSHER GRATE, A ROCK CAME LOOSE AND FELL ON THE RIGHT HAND CAUSING 3RD FINGER TO BE HIT. THE EE NEEDED 4 STITCHES.

WHILE EXITING WATER TRUCK DRIVER HIT THE DRIVER'S SIDE DOOR HANDLE. THE HANDLE BROKE AND THE DRIVER CUT THE INSIDE OF HIS HAND.

WHILE REMOVING A PIECE OF OVERBURDEN FROM A JAW CRUSHER, THE OVERBURDEN BROKE AND A PIECE SMASH ED THE FINGER OF THE EE.

WHILE HELPING INSTALL ROLLERS IN A SCREEN THE ROLLER SLIPPED OUT OF ITS KEEPER. THE EMPLOYEE REACHED TO CATCH IT AND STRAINED THE MUSCLES IN HIS BACK.

WHILE REPLACING BELT AND TAIL PULLEY ON MP02 CONVEYOR. THE EE WAS HELPING LEFT THE TAIL PULLEY INTO PLACE WHEN THE TAIL PULLEY SLIPPED AND CAUGHT HIS HAND PUSHING IT AGAINST THE FRAME.

WHILE POURING CONCRETE EE WALKED IN WET CONCRETE WITHOUT PROPER SAFETY EQUIPMENT. CAUSING CHEMCIAL BURNS ON LEGS.

WHEN STEPPING OFF LADDER ONTO GROUND EMP TURNED TOO SOON AND TWISTED LOWER BACK.

WHILE INSTALLING WEDGES IN CRUSHER CONE HIT LEFT ARM ON BRACE.

HOLDING STEEL FOR WELDER OP

TURNING U-BELT 6Y HAND TO CLEAR TAILPULLEY WHEN A ROCK WENT PAST CENTER BELT ROLL ABOUT 4" PINCHING FINGER.

REPLACING JAW P5ATE, HE WAS HOLDING IT IN PLACE WITH FOOT, PLATE SHIFTED BACK BENDING FOOT BACK.