Buscar en el registro

Employee states that he was in process of unloading shovel bucket pins from the back end of his service truck. As he was rolling or scooting the pin from his truck, after it landed on the bumper, it either bounced or flipped and struck his right hand. Three of his fingers were mashed with the index finger being fractured.

Employee states that on July 8, 2004, while moving and handling de-watering pumps and waterline he strained his back. Employee continued to work and then on July 31, 2004, employee started missing work. Note: This injury was not reported to management until August 25, 2004.

Employee stated that he was in process of tightening roller cap bolts on a D-10 bulldozer. During the process, he inadvertently struck the trigger causing the impact wrench to thrust his right hand against the roller. He sustained a bruise and later on, was told that he may have a torn ligament in his knuckle area. Note: Employee did not start missing work until May 5, 2004.

EE WAS IN THE PROCESS OF CLIMBING DOWN FROM SCRAP METAL BIN WHEN HIS RING FINGER GOT CAUGHT ON THE CORNER CUTTING HIS FINGER. THE LACERATIONREQUIRED 6 STITCHES.

EE STATES HE WAS IN PROCESS OF OPENING A DOOR ON THE WET BAG POWDER TRAILER AS HE TOOK HIS HAND OPEN THE DOOR THE HANDLE SUDDENLY CAME AROUND AND STRUCK HIM ON THE UPPER LIP, CAUSING A LACER ATION NOTE: PLEASE SEE ATTACHED MEMO

MECHANIC WAS IN THE PROCESS OF CHANGING A TIRE ON THE SERVICE TRUCK. AFTER LIFTING THE TIRE HE SAID HIS BACK AND STOMACH BECAME SOAR. HE WAS LATER DIAGNOSED WITH A HERNIA IN HIS STOMACH.

WAS CLIMBING OUT OF COUTER WEIGHT BY PULLING HISSELF UP BY HIS ARMS AND NOTICED WHEN HE GOT OUT OF THE COUNTER WEIGHT HIS RIGHT SIDE OF HIS CHEST WAS NOT FEELING THE SAME HAD A SHORTNESS OF BR EATHE.

EE WAS STEPPING DOWN FROM A GENERATOR AND INADVERTENTLY PLACED HIS FINGER/HAND IN BETWEEN A LOOSE AND SECURED GUARD MASHING THE TIP OF HIS RING FINGER. THIS OCCURRED ON THE 1570 DRAGLINE ON MAINTENANCE DAY.

EE AND CO-WORKER WENT TO WORK ON A COAL LOADER, REPAIRING THE BACKUP ALARM. SHORTLY AFTERWARD, THEY CAME BACK TO THE WAREHOUSE AND STARTED GATHERING SUPPLIES TO PERFORM OTHER WORK. DURING THI S TIME AND WHILE EE WAS BENDING OVER TO PICK UP AN AIR HOSE, HE FELT A SHARP PAIN GO THROUGH HISLOWER BACK. HE WAS UNABLE TO SIT DOWN FOR A FEW MIN. EE RECEIVED X-RAYS AND MUSCLE RELAXERS.

PUTTING BEAM INTO PLACE. BEAM WENT BACK IN PLACE AND CAUGHT FINGER BETWEEN OTHER BEAM.

LIFTING MOTOR OFF TRAILER, HE PULLED MUSCLES IN HIS BACK.

EMPLOYEE STATED THAT HE WAS WORKING ON A 777 TRUCK. AS HE WAS CHANGING A GREASE HOSE AND REACHING ACROSS THE TRANSMISSION, HE FELT SOME- THING PULL IN HIS RIGHT SHOULDER/SIDE AREA.

EE WAS CUTTING OPEN EMULSION BAGS & PLACING THE MIXTURE IN BLAST HOLES. DURING THIS PROCESS, SOME OF THE EMULSION SPLASHED UP & WENT IN HIS OPEN MOUTH. HE SPIT MOST OF THE MIXTURE OUT EXCEPT F OR ABOUT 1/2 TEASPOON. SHORTLY THEREAFTER, HE GOT NAUSEOUS & COMPLAINED OF A HEADACHE. HE & THE MSDS SHEET WAS SENT TO CLINIC WHERE HE WAS GIVEN A SHOT FOR HIS HEADACHE.

EMPLOYEE HAD STOPPED DRILLING AND PARKED THE HIGHWALL DRILL IN ORDER TO WORK ON THE CHIP DEFLECTOR. AS HE WAS DISMOUNTING FROM THE LADDER THE BOTTOM STEP TO THE GROUND WAS SEVERAL FEET AND HE HAD TO HOLD ON TO THE HANDRAIL IN ORDER FROM HAVING TO JUMP OR LAND HARD ON THE GROUND. IN DOING SO HE APPARENTLY STRAINED HIS SHOULDER (PLEASE SEE ATTACHED).

EE WAS LIFTING A DRIVE SHAFT OUT OF A D9H DOZER AND STRAINED MUSCLE IN LEFT SHOULDER.