Buscar en el registro

WHILE REMOVING LUGS FOR A SHUTTLE CAR TIRE, THE WRENCH SLIPPED AND THE EMPLOYEE EXPERIENCED PAININ THE NECK AND BACK.

EE WAS USING A SLATE BAR TO CLEAN TAIL PIECE, AND BRUISED HIS GROIN AND LEFT LEG.

AFTER ANOTHER EE USED A CUTTING TORCH TO REMOVE THE HEADS OF BOLTS, THE EE USED A HAMMER TO BREAK LOOSE THE FISH PLATES. A PIECE OF HOT METAL STRUCK EE, DROPPING INTO BOOT. ABSENT SINCE 2-11-0 0.

EE WAS STRUCK BY A PIECE OF METAL IN THE RIGHT THIGH WHILE HOLDING AN EXTRACTOR TOOL. THE EXTRACTOR WAS BEING STRUCK WITH A HAMMER BY ANOTHEREE

WHILE PULLING ON RATCHET HOIST, THE EE EXPERIENCED PAIN IN NAVEL AREA. HE WAS MAKING A BELT SPLICE.

SPLITTING SHUTTLE CAR CABLE WITH KNIFE. THE KNIFE SLIPPED AND CUT RIGHT THIGH.

MAKING SHUTTLE CAR SPLICE. WHILE STRIKING BRADDING CVONECTOR TOOL WITH HAMMER, THE EMPLOYEE STRUCK HIS LEFT THUMB WITH HAMMER.

ASSISTING ANOTHER EE LIFT A SCOOP TIRE TO INSTALL IT ON SCOOP & EXPERIENCED BACK PAIN. WAS USING A BAR TO ASSIST WITH LIFT.

STRUCK L. THUMB WITH HAMMER WHILE BRADDING A CABLE CONNECTOR.

EE CUT LITTLE FINGER WHILE TRIMMING RUBBER SKIRT IN BELT TAIL PIECE.

EE WAS SHOVELING UP SPILLAGE UNDER A BELT CONVEYOR AND EXPERIENCED PAIN IN THE L. GROIN AREA.

WHILE CUTTING A PIECE OF CONVEYOR BELT TO BE USED AS AN INSULATING MAT, THE KNIFE SLIPPED AND CUT RIGHT LEG.

EMPLOYEE WAS USING A HEAVY STRIP OF METAL TO ADJJUST BRAKES ON TRAM MOTOR. THE METAL STRIP FELL WHEN THE MOTOR WAS MOVED & STRUCK THE EMPLOYEE ACROSS THE R. FOOT.

THE EMPLOYEE WAS HELPING INSTALL A CONVEYOR BELT TAILSECTION. WHILE BLOCKING UNDER THE TAILSECTION, IT SLIPPED OFF A PRY BAR AND PINCHED THE EMPLOYEE'S RIGHT THUMB BETWEEN THE FRAME AND A WOOD EN BLOCK.

USING RATCHET TO BREAK TRACK JOINT BOLT SLOOSE AND EXPERIENCED BACK AND NECK PAIN.

EMPLOYEE STATED THAT WHILE WORKING ON A CONTINUOUS MINING MACHINE HE ACCIDENTLY HIT HIS LEFT HAND WITH A HAMMER, CAUSING LACERATION REQUIRING TWO SUTURES.

EE STATED THAT WHILE HE WAS PRYING WITH A SLATE BAR, THE BAR SLIPPED AND STRUCK HIM ON THE LEFT ARM.

EE STATED THAT WHILE HELPING TO CHANGE A SHUTTLE CAR TIRE HE WAS LIFTING UP ON THE TIRE WITH A SLATE BAR WHEN THE OTHER EE JERKED THE TIRE OFF AT THE TOP CAUSING THE TIRE AND BAR BOTH TO FALL AGAINST HIS LEFT FOOT.

EE WAS HELPING TO INSTALL A BEARING BY USING A RED DEVIL TO PULL A TAILROLLER IN PLACE WHEN THE BUDDY HOOK ON THE RED DEVIL HAND HELD HOIST BROKE CAUSING HIM TO BE THROWN INTO THE PLANT STRUCT URE REFUSE BELT STRUCTURE.

EMPLOYEE WAS WORKING ON A CONTINUOUS MINER, DRIVING A HUB IN A PLANETARY WHEN A PIECE OF METAL STRUCK HIKM IN THE LEFT EYE. EMPLOYEE WAS WEARING SAFETY GLASSES.

EMPLOYEE STATED THAT WHILE HE WAS LOOSENING BOLTS ON THE MINE TRACK HE EXPERIENCED PAIN THE LEFT SIDE OF HIS BACK & IN THE LEFT LEG

THE EE STATED HE WAS USING A SLATE BAR TO TRY AND FREE UP THE DRILL BOOM WHICH HAD BECOME FOULED UP ON THE BOTTOM. WHILE DOING SO HE EXPERIENCED BACK PAIN.

EMPLOYEE WAS MAKING A BELT SPLICE AND WHILE PULLING ON THE RED DEVIL(HAND OPERATED WENCH) HE EXPERIENCED BACK PAIN.

PULLING ON BELT IN SHOP WITH PAIR OF CHANDELOCKS SLIPPED FELL BACK ON FLOOR

EMPLOYEE STATED THAT WHILE HE WAS CLOSING RAILROAD CAR DOORS WITH A BAR HE EXPERIENCED PAIN IN THE UPPER PART OF HIS BACK.

EMPLOYEE STATED THAT HE WAS LIFTING A 5 GALLON JUG OF KEROSENE WITH A ROPE UP TO THE CATWALK AT THE NO.1 REFUSE BELT DRIVE WHEN HE EXPERIENCED PAIN IN THE LOWER PART OF HIS BACK.

EMPLOYEE WAS HAMMERING ON A SPLICE RING WHILE WORKING ON A PT0 PLUG WHEN THE SPLICE RING SLID AND HE HIT HIS RING FINGER ON THE LEFT HAND WITH THE HAMMER CAUSING A LACERATION WHICH REQUIRED TH REE SUTURES.

THE EMPLOYEE WAS HAMMERING ON A SCOOP ROCKDUSTER IN THE SHOP. THE HAMMER MISSED AND STRUCK TWO FINGERS ON THE EMPLOYEE'S L HAND.

EMPLOYEE WAS OPERATING A ROOF BOLTER AND WHILE DRILLING A HOLE THE DRILL STEEL STOPPED UP ON HIM, HE BEGAN HIMING THE DRILL STEEL WITH A WRENCH WHEN THE WRENCH SLIPPED AND STRUCK HIM ON THE H EAD ABOVE THE LEFT EYE.

LIFTING UP TRACK ON YARD WITH MOTOR SOME CLEANING UPBLOCKED TRACK UP WITH CONCRETE BLOCK AFTERWARDS TO LET TRACK DOWN USED BAR KNOCK THE BLOCK OUT TRACK FELL DOWN ON BAR TO MASH FINGER AGAI NST PAVEMENT

EMPLOYEE WAS HELPING TO INSTALL A CRIB WHEN AN AXE ANOHTER EMPLOYEE WAS USING TO WEDGE THE CRIB SLIPPED OUT OF HIS HAND AND STRUCK EMPLOYEE ON THE LEFT LEG BELOW THE KNEE.

EMPLOYEE WAS USING A HAMMER HITTING ON A PIECE OF METAL IN THE PREPARATION PLANT WHEN A PIECE OF METAL FLEW INTO HIS LEFT EYE.

EMPLOYEE WAS CUTTING A PIECE OF TAPE OFF OF A MINER CABLE WHEN THE KNIFE SLIPPED AND CUT THE LOWER PART OF HIS RIGHT LEG.

STRAINED LEFT SHOULDER WHILE PLACING PIN IN BUCKET OF END LOADER

EMMP. WAS INYHE SHOP CUTTING A CABLE WHEN HIS KNIFE SLIPED CUTTING HIS LEFT HAND.

USING PRY BAR SLIPPED MASHING LEFT THUMB.

EMPLOYEE WAS IN3THE NORTHSIDE WORKING ON A DOZER.HE WAS PRYING ON THE CAT CHAINS WITH A SLATE BAR,WHEN THE BAR SLIPPED PINCHING HIS SMALL FINGER BETWEEN THE BAR AND ENDLOADER DIPPER BLADE,CUTT ING HIS FINGER.4ENDLOADER WAS BEING USED TO ASSIST IN REPAIRING DOZER.)

EMPLOYEE WAS HE5PING TO INSTALL A TRAM SPEEDREDUCER IN A MINER USING A SLATE BAR AND THE NEXT MORNING HE EXPERIENCED PAIN IN THE LOWER PART OF HIS BACK.

RAISING SHUTTLE3CAR JACK SLIPPED HIT FOOT.

PRYING WITH SLA7E BAR. BAR SLIPPED AND MASHED FINGER.

WRENCH SLIPPED 3 R.HAND HIT AGAINST SHUTTLE CAR

WHILE DRAGGING 8UBMERSIBLE PUMP WITH A ROPE,THE PUMP CAUGHT ON THE MINE FLOOR AND CAUSED A SUDDEN JERK WHICH RESULTED IN LOW BACK PAIN.

WHILE CHECKING 2UT WORK AREA NEXT TO THE PLANT HEADHOUSE, THE EMPLOYEE WAS STRUCK IN THE HEAD BY A PIECE OF FALLING SCRAP METAL THROWN FROM THE MAGNET ROOM OVERHEAD BY THE HEADHOUSE OPERATOR A S HE WAS CLEANI3G UP DEBRIS FROM THE FLOOR AND SHOVELING IT OUT THE WINDOW.

VICTIMS LEG WAS3CAUGHT BETWEEN A RUBBER TIRE LAAT CAR AND A TRACK MOUNTED LOCOMOTIVE AFTER A MINE TIMBER SLIPPED AWAY FROM BETWEEN THE TOW PIECES OF EQUIPMENT THE TIMBER WAS BEING USED TO RAM THE FLAT CAR UP3INTO A X CUT THE VICTIM SUFERED A FRACTURED FIBULA TO RIGHT LEG

REMOVING SEGMEN7 FROM FINAL DRIVE ON D-8 DOZER AND HAD METAL TO EMBEDED LOWER STOMECH APPROX.1" BELOW THE NAVEL FROM STRIKING SEGMENT WITH AN EIGHT POUND HAMMER.

SETTING BITS ON3CONT.MINING MACHINE WITHOUT EYE PROTECTION AND FLYING METAL WENT INTO LEFT EYE.

EMPLOYEE WAS TU9NING A BOLT TO TIGHTEN A CONVEYOR CHAIN ON A CONTINUOUS MINER WHEN HE EXPERIENCED A PAIN IN HIS BACK.

TIGHTENING WHEE5 ON S/CAR PULLED MUSCLE IN RT SHOULDER.

SETTING TAIL PI9CE WHEN JACK BROKE ALLOWING THE TAIL PIECE TO SWING AND BIT THE VICTIMS LEG

EMPLOYEE WAS HE5PING MAKE A SPLICE IN T HE SOUTH MINE BRIDGE BELT. WHILE TAKING OFF BELT CLAMPS. THE TOP CLAMP RELEASED SUDDENLY STRIKING THE EMPLOYEE S HAND.