Buscar en el registro

The employee was using a shovel to try and get a rock out of the #1 conveyor belt scraper when EE hit hand on the conveyor. The next day the hand started swelling up so EE went to see a doctor. They told EE EE fractured the thumb and put EE on restricted duty for two weeks.

Employee was using a come along to change head pulley bearings when their right index finger got cut by getting caught between the come along and the conveyor transmission/gearbox.

EE was cutting a zip tie off of the portable screening plant. EE hit the back of their hand on a guard and cut self.

Employee was cutting a hose with a utility knife and it ran across EE's left leg above the knee and required 4 stitches.

Employee was working on the #1 conveyor removing a pulley with a pry bar and the pry bar hit them on the left side of the face causing a facial contusion.

Employee was using a razor knife to cut drive belts that were hanging from HP400 Crusher when employee cut self with the knife on left arm.

The miner was working on replacing a tramp release cylinder on a cone crusher, and went to use a hammer to remove a pin. The hammer slipped and hit EE's middle finger causing a cut.

While doing plumbing work, the employee caught left hand thumb between a pipe wrench and a jaw wrench. This caused the finger nail on EE's thumb to tear, EE went to the hospital where they gave EE stitches to repair it.

While adjusting a rubber curtain with a razor knife the employee cut EE's index finger

Individual was breaking up frozen material and ice while sitting in a bin when a piece broke free and landed across EE's knee bruising the knee and ligaments.

Employee was cutting wrapping material with a razor knife away from the head shaft on the 4 1/4 cone crusher when they sliced their thumb.

Employee was loosening the ball valve on the Deister Triple Deck Wash Plant. Employee was using a pipe wrench and felt a pain in this shoulder. Employee left work and consulted a Doctor.

Employee was holding a slug wrench while another employee was striking it with a hammer. Employee swinging hammer missed the wrench and hit injured employee's hand.

Employee cut his knee while cutting a piece of rubber belt.

A conveyor belt needed to be trimmed with a razor knife. So an assistant went over to trim the belt and drew the knife toward his hand

Employee was cutting a piece of conveyor belt with a plastic utility knife. The knife broke and the employee cut his finger.

Replacing a screen on a screen deck tightening bolt with breaker bar. Felt right shoulder pop. Had no strength in arm after.

Cut finger with razor knife while stripping a wire.

Installing a skirt board rubber on #2 feeder, had to trim to fit using a utility knife, slipped and hit left leg on inner calf of leg. 1" cut, 1" deep, 5 stitches.

Clearing a block shoot with pry bar. Poked it several times. When bar went through he hit finger on super structure and cut left hand ring finger requiring 4 stitches.

Tightening bolts on 4 1/4 crusher after adjusting it. Felt his back pull.

Employee was cleaning stone out of a screen with a pry bar. The bar jammed and the chisel end of the bar cut through his glove and into his hand.

Cutting rubber, knife hit employee in leg.

EE WAS REPLACING THE HOSE ON THE EXCAVATOR. HE HAD TO MOVE WIRE OUT OF THE WAY (HE TOOK OFF HIS GLOVE FOR BETTER MEASUREABILITY). HE CUT HIS THUMB WITH A UTILITY KNIFE.

CHANGING STEEL ON 7' CRUSHER, PULLING ON CROW BAR, WHEN HE FELT A POP & PULL AT SAME TIME IN STOMACH AREA.