Buscar en el registro

TWO REPAIRMEN WERE CLOSING A 12 INCH AIR OPERATED VALVE. AIR PRESSURE WAS LOW SO THEY WERE USING AN EIGHT LB HAMMER TO STRIKE VALVE. A PIECE OF STEEL BROKE OFF AND LODGED IN CHEEK OF EMPLOYEE. EE DID NOT SEEK MEDICAL TREATMENT UNTIL 5-28-01. DR REMOVED STEEL AND STITCHED WOUND.

TWO EMPLOYEE'S WERE REPAIRING A POWER LINE AND SCALING ROOF. WHILE SCALING ROOF AND CUTTING DOWN OLD ROOF WIRE A PIECE OF RUST WAS BLOWN INTO THE LEFT EYE OF THE ELECTRICAL REPAIRMAN. DR. REMO VED OBJECT, DRILLED OUT INFECTION & PRESCRIBED EYE DROPS.

MECHANICAL REPAIRMAN WAS USING A SOCKET AND TORQUE WRENCH TO TIGHTEN THE HEAD BOLTS ON A JOY AIR COMPRESSOR; THE SOCKET SLIPPED AND THE MAN HIT HIS ELBOW ON A PIPE. ELBOW BRUISED AND SORE; DO CTOR RECOMMENDED LIGHT DUTY.

EE WAS USING A 16 POUND SLEDGE HAMMER TO KNOWCK A PIN OUT OF THE HOIST EYLINDER OF AN ST-8 SCOOPTRAM. EE MISSED WITH ONE SWING AND FELT A PULLING PAIN IN HIS BACK. THE DR TREATED INJURY WITH M USCLE RELAXERS.

EE STATES THAT HE WAS SHOVELING SPILLED ORE FROM THE CONCRETE FLOOR, HE RAISED HIS HEAD QUICKLY AND HIT A LOW HANGING BEAM. EE WAS TREATED BY A CHIROPRACTOR FOR MUSCLE SPASM IN NECK, THREE TRI PS AND TREATMENTS WERE REQUIRED.

EE WAS ATTEMPTING TO REMOVE A VICTANCIC PIPE CLAMP WHICH WAS LOCATED OVER HIS HEAD. AS HE HIT THE CLAMP WITH A HAMMER FOREIGN MATERIAL GOT INTO HIS LEFT EYE.THE NEXT DAY HE WENT TO A DR & HAD IT REMOVED

MECHANICAL REPAIRMAN WAS REMOVING A BROKEN BOLT FROM THE PACKING GLAND OF A SLURRY PUMP. HE WAS USING A 24" PIPE WRENCH, WHILE PULLING ON THE WRENCH, IT SLIPPED AND HE FELT A PAIN IN HIS BACK

TAKING APART CONCRETE FORMS SMASHED LITTLE FINGER ON RIGHT HAND.

THE EMPLOYEE STATES HE HAD A TEN INCH ADJUSTABLE WRENCH IN ON EHAND AND TWELVE INCHPIPE WRENCH IN THE OTHER HAND AND WAS ATTEMPTING TO BREAK LOOSE A ONE HALF INCH STEEL PIPE UNION. WHEN THE UNION BROKE LOOSE THE EMPLOYEE STATES THAT HE FELT A STRAIN IN HIS BACK. THE EMPLOYEE ALSO STATES THAT HE HAS AN INJURY TOT HE BACK FROM THE PAST. EMPLOYEE MADE A TRIP TO A CHIRO TO RELIEVE

EE WAS CUTTING TAPE FROM A RUBBER HOSE ON A LONG HOLE DRILL WHEN THE KNIFE SLIPPED AND CAUSED EE TO CUT HIS HAND. THE HOSE HAD BEEN TAPED FOR TEMPORARY REPAIR AND EE WAS REMOVING TAPE TO REMOV E THE HOSE FOR PERMANANT REAPRI. EE RECEIVED APPTOX FIVE STITCHES ON THE THUMB OF HIS LEFT HAND.

EMPLOYEE WAS WORKING WITH A CREW OF 3 MEN TO ROTATE A 12 INCH STEEL PIPE. THE PIPE WAS ONE OF 3 THAT WAS LOCATED ABOUT 7 FT. ABOVE GROUND LEVEL. A MOBILE CRANE WAS HOOKED TO THE PIPE AS WELL A S COME-A-LONG HOIST. CLAMP WAS REMOVED. AS EMPLOYEE WAS TIGHTENING CHAIN HOIST, PIPE SWUNG FREE & EMPLOYEE LOST FOOTING & FELL TO GROUND. EMPLOYEE SUFFERED FRACTURED RIBS, CONCUSSION & SEPARA

EE WAS PREPARING TO CHANGE FROM USING ONE WATER STRAINER TO ANOTHER, IN THE SURFACE PLANT. THE WATER SHUTOFF VALVE IS A SIX INCH VICTAULIC FITTING, ATTACHED TO A SIX INCH STEEL PIPE. THE VALVE HANDLE WOULD NOT MOVE WITHOUT FORCE SO THE EE USED AN 8# HAMMER TO HAMMER THE VALVE HANDLE TO THE CLOSED POSITION. EE MISSED THE HANDLE AND SMASHED "RIGHT" INDEX FINGER.

EE WAS INSIDE A ROTARY KILN DRYER, AS THE EE WAS CLEANING BUILDUP OF MATERIAL OFF THE FLIGHTS WITH A HAMMER, MATERIAL ENTERED LEFT EAR. EE CLEANED EAR WITH Q-TIP AND BELIEVED HE WAS NOT HARMED . ONE WEEK LATER THE EAR WAS INFECTED. DR. CLEANED EAR AND TREATED FOR INFECTION.

A CONVEYOR BELT WAS TANLED AT THE HEAD PULLEY. THE EMPLOYEE AND OTHER EMPLOYEES WERE TRYING TO CORRECT THE POSITION OF THE BELT. WHILE TRYIN GTO PLACE A CONVEYOR BLOCKING DEVICE INTO POSITION THE EMPLOYEE WAS USING A PRY BAR. WHILE USING THE PRY BAR, THE EMPLOYEE FELT A SLIGHT GROIN STRAIN.

EMPLOYEE STATES HE WAS INSTALLING RUBBER INSERTS INTO A VIBRATING SCREEN WITH A SLEDGE HAMMER. HAMMER BOUNCED UP AND CAUSED EMPLOYEE TO HIT ELBOW ON A NEARBY PIPE. EMPLOYEE SAW DOCTOR ON 10/21 /93 - NO MEDICATION - STARTED HAVING PAIN & SAW DOCTOR AGAIN ON 12/20/93 - RESTRICTED DUTY.

EE STATES THAT HE WAS CHANING A CIRCUIT BREAKER ON RUBBER TIRED SCOOPT TRAM WITH A ADJUSTABLE WRENCH, THE WRENCH SLIPPED, CAUSING THE EE HAD TO HIT A PIECE OF SHARP CERAMIC INSULATOR. EE S RIG HT HAND REQUIRED SUTURES.

EMPLOYEE USED HAMMER TO REMOVE A WORN WEAR-EDGE ON A 988 LOADER BUCKET. EMPLOYEE STRUCK WEAR-EDGE WITH THE HAMMER AND A METAL CHIP BROKE LOOSE AND STRUCK EMPLOYEE IN RIGHT LEG, BETWEEN ANKLE A ND KNEE.

EMPLOYEE STATES HE WAS DISMANTLING PUMP AND WAS ATTEMPTING TO BREAK BOLTS LOOSE WITH WRENCH. WRENCH SLIPPED OFF BOLT AND CAUSED EMPLOYEE TO TWIST BACK.

EMPLOYEE STATES HE WAS ATTEMPTING TO LOOSEN BOLT ON A 2" PIPE CLAMP WHEN WRENCH SLIPPED CAUSING RIGHT THUMB TO SLAM INTO BOLT ON TOP OF CLAMP. RIGHT THUMB WAS FRACTURED AND THUMB NAIL WAS PULL ED OFF.