Buscar en el registro

Employee was clearing out a blockage on the fines chute underneath the jaw of the primary plant. The employee was using a metal bar to loosen the stuck material. When the last rock came free instead of falling down the chute it came out of the access hatch hitting the miner in the face and hand.

EE was attempting to remove a bearing on screen deck 4 of the rock plant using a Port-a-Power and H-Puller. When pressure was applied the threads were stripped and the H-Brace struck EE in EE's left side rib cage.

Employee was removing pin from side plate on loader bucket. While driving the pin out with a hammer, the hammer glanced the pin and struck a hard-face dot causing the dot to fragment. A metal piece of the dot penetrated the employees leather glove and into his right thumb. Employee was sent to medical office to remove the foreign object.

Employee was cutting a belt with a razor when the knife slipped and cut his right lower leg.

Employee was removing a dowpin from a nut guard to the crusher, when the wrench slipped, causing the top of his right index finger to cut on the sharp edge of the nut guard

Employee was loosening a bolt off a loader when the wrench broke, came back and hit him in the right eye.

Employee was hammering a wedge into a pin to close the door on the jaw crusher.

EMPLOYEE WAS REMOVING ANVILS FROM A CRUSHER UNIT. A PULLING TOOL COULD NOT BE FOUND, SO EMPLOYEE WAS USING A CHIPPING HAMMER TO EXTRACT THE ANVILS. THE HAMMER SLIPPED, PIERCING HIS LIP AND CHIPPING A TOOTH.

WORKER WAS LOOSENING A NUT ON A CONE CRUSHER UNIT. A WRENCH WAS ATTACHED TO THE NUT, AND THE WORKER WAS HITTING THE WRENCH WITH A 4" SHAFT. WORKER MISSED HIS TARGET AND SLAMMED HIS FINGER AGAI NST THE WRENCH.

EE ATTEMPTED TO CLEAR A BRIDGE OF MATERIAL IN THE PRIMARY JAW CRUSHER WHILE RUNNING WITHOUT AUTHORIZATION WITH A PRY BAR. THE BAR GOT CAUGHT BETWEEN A PIECE OF METAL & THE MOVING SIDE OF THE J AW WHICH CAUSED THE PRY BAR TO STRIKE EE

PULLING A PART ACROSS THE SHOP FLOOR. THE HOOK THAT HE WAS PULLING THE PART WITH SLIPPED OFF OF THE PART. HE SLIPPED ON THE OILY FLOOR AND STEPPED BACK INTO AN ENGINE BLOCK SITTING ON THE FLOO R.

54736YEE WAS CUTTING A PLASTIC TIE AT THE WASH PLANT DISCHARGE SCREEN WITH A POCKET KNIFE. WHEN THE KNIFE CUT THRU THE TIE, IT STRUCK HIS LEFT HAND AT THE THUMB JUST BELOW THE FIRST JOINT.

EMPLOYEE WAS SWINGING A 20 LB. SLEDGEHAMMER ATTEMPTING TO LOOSEN THE MANTLE ON A CONE CRUSHER. WHEN EMPLOYEE SWUNG THE SLEDGEHAMMER, HE FELT SOMETHING PULL IN HIS RIB AREA AND EXPERIENCED DIFF ICULTY IN BREATHING.

THE INJURED WAS UNCLOGGING THE CRUSHER WITH A ROD AND SLEDGE HAMMER.THE ROD MOVED AND THE SLEDGE HAMMER HIT HIS INDEX FINGER SMASHING THE FINGER.

EMPLOYEE WAS RE1AIRING A JAW CHEEK PLATE ON WASH PLANT USING A SLEDGE HAMMER EMPLOYEE WAS STANDING UNDER AN OPEN METAL DOOR WHICH IS HINDGED FROM THE T OP EMPLOYEE WAS BEATING AGAINST THE CHEE K PLATE WITH A 8LEDGE HAMMER ATTEMPTING TO LOOSEN IT A BOLT BROKE & JOLTED METAL DOOR CAUSING IT TO FALL ON HIS RT SHOULDER BLADE

EMPLOYEE ATTEMP7ING TO LOOSEN A PIECE OF RUBBER ON CONVEYOR BELT WITH A STEEL BAR APPROX.3FT LONG STEEL BAR SLIPPED & EMPLOYEE JAMMED HIS FINGER ON A SIDE RAILING