Buscar en el registro

EMPLOYEE WAS REMOVING BOLTS FROM A DIVERTER FLANGE, USING A WRENCH, EMPLOYEE STRAINED LEFT ARM MUSCLE WHILE PULLING ON WRENCH TO LOOSEN BOLTS.

EMPLOYEE WAS CUTTING A RUBBER BELT TO FIT IN 03 SCREEN HOPPER FOR SPLILLAGE PREVENTION. WHILE CUTTING BELT, KNIFE SLIPPED AND EMPLOYEE CUT INTO RIGHT LEG, REQUIRING SUTURES. UNSAFE ACT OF CUTT ING TOWARDS SELF. CORRECTIVE ACTION TAKEN TO PREVENT REOCCURRENCE WITH COUNSELING.

EE WAS MOVING AN ACCESS DOOR FROM A MATERIAL ELEVATOR. AS HE WAS REMOVING THE LAST CLAMP ON THE DOOR, IT FELL STRIKING HIM ON THE RIGHT FOOT JUST BEHIND THE STEEL TOE OF HIS BOOT RESULTING IN DOUBLE METATARSAL FRACTURE.

EMPLOYEE WAS USING A STEEL BAR TO CLEAN OUT A CHOKE UP OF MATERIAL IN A DISCHARGE CHUTE. AS THE BAR BROKE THROUGH THE MATERIAL, IT JERKED THE E MPLOYEE, PULLING MUSCLES IN HIS UPPER RIB CAGE A ND NECK AREA. INJURY RESULTED IN SPRAIN/STRAIN TO NECK.

EMPLOYEE WAS POSITIONING THE SEAL ON THE FEED END OF #2 KILN DURING SCHEDULED MAINTENANCE SHUT DOWN. SEAL WAS SUSPENDED FROM A HOIST WITH A STRAP. THE SEAL TURNED AND PINCHED THE EMPLOYEES FIN GER BETWEEN THE SEAL AND THE KILN. SPLINT ON FINGER DID NOT RESTRICT EMPLOYEE FROM PERFORMING NORMAL JOB FUNCTION.

EE IS A MAINTENANCE MECHANIC AND WAS REQPAIRING A COLLER DRIVE BEARING. AS HE WAS TIGHTENING A BOLT, THE WRENCH SLIPPED OFF OF THE NUT HE WAS TIGHTENING AND HE STRUCK HIS LEFT ELBOW. LATER THA T EVENIGN AND THROUGH THE NIGHT, PAIN INCREASED AND FLUID FORMED ON THE ELBOW. EE OBTAINED MEDICAL TREATMENT.

EMPLOYEE WAS USING A UTILITY KNIFE TO CUT TWO CARDBOARD BOXES APART AND HE CUT TOWARDS HIS OTHER HAND. KNIFE SLIPPED AND HE CUT HIS LEFT HAND, THUMB SIDE OF PALM, 3/4 INCH LACERATION REQUIRIN G SUTURES.

A 500 HP MOTOR WAS REMOVED FOR REPAIR. THE BASE PLATE NEEDED CLEANED OF BUILT UP MATERIAL BEFORE SPARE MOTOR COULD BE INSTALLED. INJURED AND ANOTHER ELECTRICIAN WERE CLEANING OFF MOUNTING PLAT E WITH A SCRAPER. INJURED EMPLOYEE WAS WIPING AWAY DIRT AS SECOND EMPLOYEE WAS CHIPPING AWAY LOOSE MATERIAL. COMMUNICATIONS BROKE DOWN BETWEEN THE TWO EMPLOYEES AND EMPLOYEE WAS STRUCK ON HAN

EMPL WAS IN PROCESS OF PUTTING COAL IN BIN BY DUMPING COAL THROUGH GRATING & RUNNING IT UP ELEVATOR TO BIN. EMPL WAS USING PRY BAR TO POIKE REMAINING COAL THROUGH GRATE. EMPL STRAINED BACK AS HE WAS USING PRY BAR TO DISLODGE COAL.

EMPLOYEE NOTICED IRRITATION OF HIS LEFT EYE WHILE IN ROUTE HOME AFTER WORK ON 3-11-91. EMPLOYEE REPORTED TO SUPERVISOR AND SAFETY CHAIRMAN OF EYE IRRITATION THE NEXT MORNING UPON REPORTING TO WORK. MEDICAL TREATMENT WAS OBTAINED, DIAGNOSIS WAS A FOREIGN BODY, METAL RUST, IMBEDDED IN LEFT EYE. MEIDCATION WAS PROVIDED, EMPLOYEE RETURNED TO WORK WITH NO RESTRICTIONS THE NEXT DAY.

EMPLOYEE WAS UNCHOKING A MAGNESITE BALL MILL FINES LINE THAT WAS CHOKED UP. EMPLOYEE HAS HITTING PIPE WITH A HAMMER AND FINES FELL FROM ABOVE AND ENTERED LEFT EYE. EMPLOYEE WAS WEARING SAFET Y GLASSES AT THE TIME BUT DID NOT HAVE DUST GOGGLES ON.

INJURED EMPLOYEE AND TWO OTHER EMPLOYEES WERE ATTEMPTING TO CLOSE A RAILCAR DOOR. THE DOOR WAS NOT PROPERLY ALIGNED AND WAS SLIGHTLY CATCHING THE EDGE OF THE CAR NOT ALLOWING HTE DOOR TO SEAT PROPERLY. CONSEQUENTLY THE LATCHING MECHANISM WOULD NOT PROPERLY CLOSE. EMPLOYEES USED A PIPE TO PUT EXTRA FORCE ONT EH DOOR CLOSURE MECHANISM. WHILE DOING THIS THE DOOR HANDLE SPRUNG BACK

USING WRENCH TO TIGHTEN NUT AND BOLT PAIN AND SWELLING NO TREATMENT TIL 9-6-90

USING RATCHET SOCKET JUMPED OFF STRIKING IN UPPER LIP

EMPLOYEE WAS OPERATION A CHAIN HOIST RAISING A BARREL FROM A PIT. IN ORDER TO KEEP THE BARREL FROM HITTING THE FLOOR, HE WAS PUSHING ON THE CHAIN TO DIRECT THE RISING BARREL. EMPLOYEE FORGOT A BOUT HIS HAND RISING WITH THE CHAIN AND HIS LEFT INDEX FINGER WAS CAUGHT BETWEEN THE CHAIN AND THE GUARD. RESULTING LACERATION REQUIRED 9 SUTURES.

EMPLOYEE WAS ASSISTING ANOTHER MAINTENANCE MAN IN REMOVING A HUB FROM A MOTOR SHAFT USING A HYDRAULIC WHEEL PULLER THEY WERE USING A 50 TON JACK & WERE HEATING THE HUB WITH A HEATING TORCH ONE EMPLOYEE WAS PUMPING HYDRAULIC JACK WHILE INJUREMPLOYEE WAS HEATING THE HUB I NAME WALKED AROUND IN FRONT OF THE PULLER TO HEAT THE OTHER SIDE OF THE HUB WHEN THE THREADS STRIPPED OUT OF PULL

EMPLOYEE WAS STRIKING SIDE OF HOPPER TO KEEP STONE FLOWING. DUE TO EXTREME COLD, STONE TENDS TO FREEZE TO SIDE OF HOPPER. EMPLOYEE WAS USING STEEL BAR TO STRIKE HOPPER. EMPLOYEE STRAINED MUSCL E AS HE WAS STRIKING BIN.

EMPLOYEE WAS CLEANING WATER DRAIN WITH SHOVEL. WATER, DIRT SPLASHED INTO FACE. EMPLOYEE WAS WEARING SAFETY GLASSES. REMOVAL OF SUPERFICIAL FOREIGN BODY FROM (R) EYE. REPORTABLE DUE TO MEDICATI ON PROVIDED BY DOCTOR. AK-CHLOR 1 FOUR TIMES A DAY FOR 5 DAYS.

WHILE INSTALLING BOLTS IN SCREW, DIRT FELL DOWN FROM ABOVE. DIRT WENT IN EYE. EMPLOYEE WAS WEARING SAFETY GLASSES BUT NOT DUST GOGGLES. THIS IS A DIRTY AREA AND VIBRATION CAN CAUSE DIRT TO FLA KE OFF OR FALL. EMPLOYEE MUST WEAR DUST GOGGLES IN DIRTY WORK AREAS. REPORTABLE DUE TO RUST FLAKES EMBEDDED IN EYE. REMOVED WITH NO COMPLICATIONS.

REPAIR SCREEN BENDING OVER TIGHTENING BOLTS WIHT WRENCH PULLING AS HE WAS BENDING FELT PAIN IN LOW BACK AREA.

AFTER SHOOTING 1 KILN EMPLOYEE WAS HELPING TO BREAK UP COATING BALLS WITH A SLEDGE HAMMER IN 1 BALL ROOM AT THE END OF 1 COOLER. WHEN STRIKING A COATING BALL A SMALL PIECE OF COATING FLEW OUT FOUND ITS WAY 7O HIS LEFT EYE. EMPLOYEE WAS WEARING SAFETY GLASSES AT THE TIME.

EMPLOYEE WAS HE5PING TO REPLACE A SEAL RING IN A COAL MILL. SEAL WEIGHED APPROX. 150 LB. HE WAS OPERATING A MANUAL CHAIN HOIST, LOWERING THE SEAL INTO PLACE SEAL WEDGED CAUSING SLACK IN CHAIN. AS EMPLOYEE WO9KED TO FREE SEAL, IT SLIPPED FREE CAUSING HOIST HANDLE TO SWING. HANDLE STRUCK EMPLOYEE ON THUMB NAIL SMASHING THUMB BETWEEN HOIST HANDLE AND WATER PIPE EMPLOYEE WAS HOLDING ON

EMPLOYEE WAS ATTEMPTING TO DISCONNECT A COUPLING ON A WATER LINE TO INSTALL A FLOW SWITCH. THE PIPE WRENCH SLIPPED, PINCHING LEFT THUMB BETWEEN PIPE WRENCH AND CONCRETE WALL ACCIDENT OCCURRE D IN A MAN HOLE AND WORK WAS HAMPERED BY CONFINED WORKING QUARTERS.