Buscar en el registro

EMPLOYEE STATED THAT HE HAD JUST FINISHED CUTTING A PIECE OF METAL WITH A CUTTING TORCH.ANOTHER EMPLOYEE STRUCK THE METAL WITH A HAMMER,AND A PIECE OF THE HOT METAL CONTACTED HIS LOWER EYELID. DOCTOR PRESCRIBED EYE MEDICATION).

EMPL REMOVING TOOTH FROM LOADER BUCKET USING HAMMER.STRUCK TOOTH WITH HAMMER CAUSING PIECE OF METAL FROM TOOTH TO FLY FREE EMBEDDED IN KNEE.

EE WAS CLOSING A BOTTOM DOOR OF A RAIL CAR WITH A PRYBAR. THE RAIL CAR DOOR SUDDENLY GAVE WAY AND THE SUDDEN LACK OF RESISTANCE CAUSED HIM TO JOLT TO KEEP HIS BALANCE AND THIS RESULTED IN A NE CK STRAIN.

EMPLOYEE WAS BREAKING A CHUNK IN A FEEDER TRAY USING A BAR. BAR SLIPPED AND HE CUT FINGER. (SUTURES REQUIRED TO CLOSE WOUND) RESTRICTED TO NO USE OF LEFT HAND.)

EE WAS USING A PUNCH AND HAMMER TO TIGHTEN A BEARING ON THE DRIVE SHAFT OF FM-2 WEST SEPERATOR. WHILE TIGHTENING THE BEARING THE PUNCH SLIPPED AND THE HAMMER STRUCK HIS LEFT THUMB CAUSING PAIN AND SWELLING.

EMPLOYEE WAS USING A BAR TO BREAK A CLINKER CHUNK IN THE COOLER. DEVELOPED DISCOMFORT IN LEFT ELBOW. EMPLOYEE WAS INJURED ON 12-30-89. DID NOT REQUEST MEDICAL TREATMENT UNTIL 1-8-90.

EMPLOYEE WAS CUTTING A ROPE ATTACHED TO A HANDRAIL, WITH HIS POCKETKNIFE, WHEN ROPE BROKE AND KNIFE CUT HIS LEFT FOREARM. (SUTURES AND PRESCRIPTION MEDICATIONS).

EMPLOYEE WAS WINING SLEDGEHAMMER TO INSTALL NEW TEETH ON LOADER BUCKET.THE NEXT DAY EMPLOYEE EXPERIENCED PAIN IN HIS NECK AND DOWN TO HIS RIGHT SHOULDER BLADE.

EMPLOYEE WAS USING A BAR TO CLEAN OUT A BALL SORTER, BAR SLIPPED AND STRUCK HIS FOOT, RIGHT BEHIND THE STEEL TOE OF HIS WORK BOOT.

SWING 5 LB SLEDGEHAMMER TO DRIVE COUPLING ONTO SWHEEL SHAFT FELT PAIN IN ABDOMEN.

CHANGING BLADES IN MILL SITTING POSITION BENDING FORWARD REMOVING BLADS WITH WRENCHES STRAINED MUSCLE UNDER L SHOULDER BLADE.

EMPLOYEE WAS HOLDING A BAR BETWEEN HIS LEGS FACING AWAY FROM RAILCAR HE WAS CLOSING BOTTOM DOORS ON HAMMERING THE BOTTOM DOOR CLOSED WITH A BAR MOVING BACK AND FORTH BETWEEN HIS LEGS HE HEARD A POP IN HIS BACK AND FELT A SEVERE PAIN IN HIS MID BACK

WHILE USING BAR TO LOCK BOTTOM DOOR OF RAILCAR, BAR SLIPPED AND EMPLOYEE STRUCK RIGHT ELBOW AGAINST RAIL CAR.

OPENING BOTTOMN DOOR ON RAIL CAR WITH PRYBAR PRYBAR SLIPPED & HIT RIGHT THUMB

EMPLOYEE SAID THAT WHILE IN THE PROCESS OF USING A BAR TO CLOSE A RAIL CAR BOTTOM DOOR AT THE S.W. END OF CEMENT STORAGE SILOS, HE FELT PAIN THE RIGHT INGUINAL REGION.

EMPLOYEE WAS HANDED A HOLDDOWN CLAMP BAR FOR A VIBRATING SCREEN, AND TURNED TO HAND IT TO THE NEXT LEVEL, AND EXPERIENCED A SHARP PAIN IN HIS STOMACH MUSCLE.

EMPLOYEE WAS IN THE PROCESS OF USING A 2 POUND HAMMER TO SET SHIMS & BRICKS IN THE #6 KILN REBRICKING JOB & RIGHT WRIST BECAME PAINFUL & SWOLLEN

EMP WA> STRUCK BY PRY BAR THAT HE WAS USING

EMPLOYEE SAID HE WAS CHUNKING ON SILO #42 AND FELT A PULL IN THE RIGHT SIDE OF GROIN.

WHILE PAINTING HANDRAILS WITH A BRUSH,EMPLOYEE BEGAN TO ITCH.RASH DEVELOPED ON LEGS AND BACK.

WHILE POKING OUT A BIN WITH A STEEL BAR, SMALL FINGER HIT HOUSING.

WHILE USING HAMMER TO CLERASN OUT REJECT TANK,EMPLOYEE FELT PAIN IN LOWER BACK.

WHILE LOOSENING A NUT OFF A BOLT, EMPLOYEE FELT A PULL IN RIGHT SIDE.

SAID HE WAS INSIDE FM4 ATTEMPTING TO MOVE LINER WITH A PINCH BAR WHEN TEH BAR SLIPPED AND HIT HIS MOUTH CUTTING HIS LOWER LIP.

EMPLOYEE SAID THAT HE WAS STANDING ON THE WEST SIDE OF SILO #6 FEEDER, CHUNKING ON THE SILO WITH A BAR. THE SILO FLUSHED AND CEMENT ENTERED BOTH EYES.

EMPLOYEE STARTED TO PUSH MATERIAL FROM CONVEYOR TO ELEVATOR USING A BAR. EMPLOYEE CAUGHT LEFT 4TH FINGER BETWEEN CONVEYOR HOUSING AND THE BAR WHEN THE MATERIAL GAVE.

EMPLOYEE SAID H9 WAS REPLACING ROLLERS ON C4 GELT FEEDER AND WHILE PULLING THE ROLLER WITH A ROPE THE ROLLER SWUNG DOWN AND HITHIS RT ARM AGAINST THE SIDE OF THE HOUSING CAUSING SORENESS IN H IS RT ELBOW 3

EMP HAS A BURSI7IS CONDITION AND WHILE USING AN 8 LB. SLEDGE HAMMER TO BREAK MATERIAL CHOCKED-UP IN A BIN AND FELT PAIN IN HIS SHOULDER. THIS IS REPORTED AS AN ILLNESS AND NOT AN INJURY

EMPLOYEE SAID T2AT AS HE WAS PUTTING A LUG ON WIRE OF THE U.P.S. SYSTEM IN THE T2-2 BUILDING, HE STRAINED TWO FINGERS ON HIS RIGHT HAND BY SQUEEZING THE WIRE CRIMPERS.

EMPLOYEE WAS RE4OVING DISCHARGE SCREEN BOLT WITH PUNCH AND SLEDGEHAMMER; WHILE HITTING PUNCH WITH SLEDGEHAMMER, FELT "POP" IN RIGHT HAND.

EMPL USING CHUN5ING BAR TO LOOSEN BUILDUP MATERIAL ON CEMENT SILO #33.BAR WAS HIT BY CHUNK OF MATERIAL AND EMPL LOST BALANCE AND TWISTED BACK.

EMPL JACKING UP3BRICK RING WHILE PUTTING NEW BRICK IN #6 KILN.JACK SLIPPED LOOSE AND BRICK FELL STRIKING EMPL RIGHT ARM BELOW BICEP.

EMPLOYEE WAS UN1LUGGING PHS 23 USING A HAMMER TOD RIVE A GUDGEON BOLT IN WHILE STRIKING THE BOLT WITH THE HAMMER RIGHT ELBOW STRUCK AGAINST THE SCREW BOX HOUSING

THE EMPLOYEE SA3D THAT HE WAS PUNCHING BUILDUP OFF THE KILN END DOOR AREA WITH A LONG PIPE & A LARGE CHUNK FELL FROM ABOVE & STRUCK THE PIPE & THE PIPE STRUCK HIM AND CAUSED HIM TO TWIST HIS R IGHT KNEE & FEL7 PAIN & HAD SWELLING. (DID NOT REQUEST TO SEE DR AT THIS TIME, HAD KNEE "GO OUT" 1-29-86 & WENT TO DR., NO WORK THAT DAY.

THE EMPLOYEE SAID THAT WHILE HE WAS STANDING ON A LADDER INSIDE THE TOLLER MILL USING A COME ALONG IN THE PROCESS OF CHANGING A SEGMENT ON ROLLER MILL ROLLER, HE FELT PAIN IN HIS LEFT ELBOW.

AFTER EMPTING A RAILROAD CAR LOAD OF COAL EMPLOYEE WAS ATTEMPTING TO CLOSE THE HATCH DOORS USING A 5FT STEEL BAR FOR LEVERAGE WHILE PULLING BACK ON THE BAR EMPLOYEE FELT PAIN IN HIS LOWER BACK

THE EMPLOYEE HAS HAD BACK PROBLEMS ON OCCASSION WHICH WE BELIEVE CONTRUBUTED TO THIS SPECIFIC PROBLEM.THE EMPLOYEE OVER EXERTED HIS BACK ON THIS OCCATION WHILE SWALING BEARING CAPS ON B2-IC1 W WITH AN EIGHT LB.SLEDGE HAMMER.