Buscar en el registro

EE was cleaning the mud off of a conveyor roller. He was using a hand help scraper to do so. His scraper came n contact with the convery belt and the handle of the scraper struck him in his left knee. He did go to the doctor and was placed on light duty.

EE was using a utility knife to cut the locks on a plastic nordbak bucket. While cutting the locks, whe slipped with the knife and cut her right ghigh. She did go to the doctor and received 4 stitches. There were no work restrictions, so she id return to full work duties. She had the stitches removed on 10/15/08.

EE WAS USING A 12# SLEDGE HAMMER AS A BACKING PLATE WHILE ANOTHER EE WAS STRIKING A PIN INTO THE PAN FEEDER DRIVE CHAIN. A SMALL SHARD OF METAL SPLINTERED OFF THE PIN AND STRUCK EE IN THE CHIN REQUIRING STITCHES AND REMOVAL OF THE 1/4" METAL CHIP.

EE WAS RETRACTING A 25 FT. STEEL TAPE AND THE BLADE CUT HIS MIDDLE FINGER OF HIS RT. HAND SMALL LACERATION CAUSED FOUR STITCHES TO BE PUT IN BY DR AT EMERGENCY ROOM.

EMPLOYEE WAS CUTTING A PIECE OF RUBBER BELTING AND THE RAZOR KNIFE SLIPPED AND CUT THE BACK OF HIS LEFT HAND, APPROX 1/4" LONG. 2 STITCHES WERE REQUIRED TO CLOSE WOUND.

EMPLOYEE WAS USING A PORTA POWER RAM TO SPREAD APUMP FROM IT'S BASE. UPON COMPLETION OF THE JOB THE RAM FAILED TO RETRACT FULLY AND MAINTAINED ASMALL AMOUNT OF PRESSURE. THE RAM WAS TAPPED WIT H A HAMMER AND THE RAM SPRUNG FREE, PINCHING THEMECHANIC'S HAND AGAINST THE PUMP BASE.

A MILL MECHANIC WAS USING AN 8# HAMMER TO KNOCK LINERS LOOSE IN THE CRUSHER PAN FEEDER. A PIECE OF THE STEEL LINER CHIPPED OFF & STRUCK HIM ON THE RIGHT CHEEK (RIGHT SIDE OF HIS FACE). FOUR STITCHES WERE REQUIRED TO CLOSE THE LACERATION.

ON 10/13/99 EE STRUCK A PIECE OF STEEL WITH A HMMER & A SHARD OF METAL STRUCK HIM ON THE LEFT HAND BETWEEN THE THUMB & 1ST FINGER. FIRST AID WAS DONE AT THE MINESITE & HE HEALED WITH NO FUTHER MED ATTENTION. ON 6/9/00 EE HAD A SMALL PIECE OF METEL REMOVED FROM HIS HAND REQUIRING 3 STITCHES

EE WAS USING A PORTA POWER HYDRAULIC RM TO PRESS A BOLT OUT OF THE MILL SHELL. AS PRESSURE MOUNTED, THE RAM SLIPPED FROM ITS FOOTING AND STRUCK THE EE IN THE CHEST.

EMPLOYEE WAS CUTTING A PIECE OF 1 1/2" RUBBER HOSE WITH A RZAOR KNIFE KNIFE CUT THROUGH HOSE VERY QUICKLY, THEN CUT INTO RIGHT THIGH. 3" LACERATION OF RIGHT THIGH. 13 STITCHES REQ. NO ARTER IES CUT.

MAINT MECHANIC WAS PUSHING AGAINST A 42IN STEEL BAR ATTEMPTING TO LEVER A PAN FEEDER PAN INTO POSITION SO IT COULD BE BOLTED INTO PLACE MECHANIC WAS PUSHING AGAINST BAR WITH HIS SHOULDER & ATT EMPTED TO TWIST HIS BODY FOR MORE LEVERAGE FELT HIS LOWER BACK STRAIN DR RECOMMENDED THERAPY

MAINTENANCE MECHANIC WAS USING A PORTA POWER HYDRAULIC TOOL TO BREAK BEADS ON A HAUL TRUCK TIRE. TIRE WAS MOUNTED ON LEFT FRON TOF CAT 777 TRUCK. PORTA POWER WAS BRACED BETWEEN THE SUSP. CYLIN DER AND RIM BEAD ON THE TIRE. AS PRESSURE WAS APPLIED AT THE HOSPITAL.

EMPL WAS SHOVELING & HOSING KNELSON CONCENTRATOR DEVICE. WATER & DIRT SLURRY SPLASHED FACE. EMPL FELT EYE ARRITATION 2 HRS LATER. NEXT SHIFT HE REPRTED TO FOREMAN & WENT TO DR,

LOOSENING THE BIT THE STEEL WEDGE SLIPPED ALLOWING IT TO STIKE MIDDLE FINGER BROKEN IT AT TIP

TRUCK DRIVER WAS HELPING EE CUT THE HOSE ON A NEW CONTIANER OF BATTERY ACID. EE HAD TAKEN OFF HIS SAFETY GLASSES FOR A MOMENT. AS THE HOSE WAS CUT, THE ACID SPURTED AND SPLASHED EE IN HIS LEFT EYE. EE IMMEDIATELY FLUSHED HIS EYE IN THE EMERGENCY EYE WASH. THE INCIDENT WAS NOT REPORTED UNTIL 11:40AM.

THE MINER INJURED HIS LEFT WRIST WHILE HUNTING APPROX. 7 DAYS EARLIER HE RECIEVED NO MEDICAL ATTENTION AT THAT TIME AND DID NOT REPORT IT TO HIS SUPERVISOR UPON RETURN TO WORK TODAY HE WAS USI NG A HEAVY WRENCH AND EXPERIENCED RENEWED PAIN IN THAT WRIST AND HAND. A DR CONFIRMED STRAINED TENDONS IN HIS LEFT WRIST.

HE WAS TIGHTENING BOLTS ON THE PIPE WHICH GOES TO THE HOLDING POND. HE DID NOT METION HE WAS INJURED UNTIL THE NEXT DAY.

EMPL HELPING REMOVE AG MILL FEED END SEAL RING.RING WAS BOUND UP AND EMPL PUT LEFT HAND BETWEEN SEAL RING AND FEED CHUTE BARRING RING OFF.BAR SLIPPED AND RING POPPED BACK PINCHING LEFT INDEX F INGER.TOP OF FINGER FROM 1ST KNUCKLE PULLED OFF OF THE BONE.

EMPLOYEE WELDED A DOG ON A PIECE OF STEEL TO USE AS A BASE TO PUSH A PIECE OF STEEL IN PLACE TO BE WELDED DOG CAME LOOSE & HIT EMPLOYEE ON LEFT SIDE OF FACE EMPLOYEE NEEDED STICHES DOG HAD A B UILD UP OF WELD FROM OTHER JOBS & MORE WELD WAS NEEDED

EMPLOYEE CLEANING CAMERA LENS.THE CAMERA IS ENCLOSED WITH AIR BLOWING THRU ENCLOSURE TO KEEP CAMERA CLEAN.THE EXIT AIR REGULATOR BECAME CLOGGED WITH MUD CAUSING ENCLOSURE TO BECOME PREESUREIZE D.EMPLOYEE REMOVED BOLTS FROM ENCLOSED COVER,TO CLEAN LENS AND COVER BLEW OFF,STRIKING AND FRACTURING EMPLOYEE'S LEFT ARM.

EMPLOYEE WAS PR2ING THE COVER OFF OF THE TOP OF VACUUM PUMP EXHAUST WHEN HIS PRY BAR SLIPPED AND HE CUT THE KNUCKLE ON HIS LEFT INDEX FINGER.

EE WAS HOLDING 5 STAMP TO MARK A GOLD BAR ANOTHER EE WAS HITTING THE STAMP WITH A HAMMER & MISSED STRIKING THE EES INDEX FINGER & BREAKING IT.

I NAME WAS USIN1 BOLTS TO PULL A PIPE CLAMP TOGETHER. HE WAS USING ONE I NCH BOLTS AS HE MADE THE LAST TURN ON THE BOLTS THE 3X1/2 INCH PLATE SNAPPED, STRIKING HIS LEFT HAND THUMB, FRACTURING THE TIP OF THE3THUMB.

I.NAME AND I.NA4E WERE CHANGING A GEAR BOX ON A DISCHARGE CONVEYOR THEY WERE USING A CHAIN FALL TO LIFT THE GEAR BOX THE CHAIN HOOKED ON A BOLT ON THE GEAR BOX AND THEN LET LOOSE CAUSING THE G EAR BOX TO DROP3DOWN ENOUGH TO PINCH I.NAMES LITTLE FINGER ON HIS RT HAND BETWEEN THE GEAR BOX AND THE FRAME SPLITTING THE FINGER AND FRACTURED IT