Buscar en el registro

Employee was cutting drip line on the leach pad with a box cutter. The knife slipped and cut EE's lt. Wrist. There was profuse bleeding reported by the co-worker and they helped apply pressure and elevation as they assisted the injured worker to the aid station. Arterial surgery repairs were performed at the emergency hospital.

Another employee was removing teeth from a 992K loader. While using a hammer to break the teeth loose it chipped the tooth causing a piece of metal to go flying which then hit IE in the chin. This broke the skin open and imbedded into IE's chin.

It has been muddy on the mine. The operator was shoveling the tracks of the dozer and was pushing hard. EE then felt something in the right knee pop.

Miner was removing loader teeth off a bucket using a 12lb sledge hammer when a piece of metal flew off and lodged into EE's left leg. The leg immediately bruised and slightly bled. The miner was treated onsite and released early to seek further medical attention.

Employee was removing guard from roller on crusher, struck guard with hammer causing guard to spin and strike employee on bridge of nose and side of face, employee given injection due to complaint of pain.

Employee states ee was swinging a scraper to beat pads clean on Press #3 and shoulder popped out resulting in a shoulder dislocation.

EMPLOYEE WAS BARRING OUT A CHUTE AT THE CV-20 TO RS-03 TRANSFER POINT. A ROCK FELL FROM THE PLUGGED AREA, BOUNCED OFF THE BELT OF RS-03 AND STRUCK THE 4' PRY BAR THE EMPLOYEE WAS USING WHICH C AUSED THE PRY BAR TO HIT THE EMPLOYEES LT. SIDE FACE.

EMPLOYEE WAS TRIMMING AWAY THE TELLOWMINE PIPE WALL TO EXPOSE A BROKEN SPLINE FOR REMOVAL. EMPLOYEE HAD JUST CHANGED THE BLADE IN HIS RAZOR KNIFE. DURING THE TRIMMING OF THE WALL THE BLADE SLIPPED OFF THE PIPE AND LACERATED THE FINGER.

EE WAS PLACING A 65 LB DOR BAR IN THE SAFE AND THE BAR STARTED TO TURN OVER. WHEN THE EE TRIED TO CATCH THE BAR HIS FINGER WAS PINCHED BETWEEN A SHELF IN THE SAFE AND THE DORE BAR CAUSING THE INJURY.

EE WAS CUTTING OFF A BOX TOP WHEN THE KNIFE SLIPPED AND LACERATED THE LEFT HAND ON THE THUMB SIDE REQUIRING SUTURES.

EMPLOYEEWS INSTALLING A BALL STUD IN A STEERING CYLINDER USING A HAMMER AND SOCKET. HE WAS HOLDING THE SOCKET IN HIS LEFT HAND ON THE SOCKET AND SWUNG THE HAMMER STRIKING HIS LEFT HAND,LACERAT ING THE THUMB.

EMPLOYEE WAS SLICING AN APPLE IN HIS HAND. THE EMPLOYEE LOOKED UP TO SAY SOMETHING AND THE KNIFE SLIPPED LACERATING THE PALM OF HIS HAND REQUIRING STITCHES.

DURING REPLACEMENT OF BUCKET TEETH ON A CAT 992 LOADER THE EMPLOYEE STRUCK AN OLD BUCKE TTOOTHB EING REMOVED WITH THE SLEDGE HAMMER AND A PIECE OF THE TOOTH FLEW OFF LACERATING THE EMPLOYEES L EFT LEG REQUIRINNG SUTURES.

DURING INSTALLATION OF A DOGBONE PIN ONE EMP WASUSING A 4 LB HAMMER TO KNOCK THE COLLET INTO PLACE. HAMMER GLANCED OFF COLLET, HIT THE BUCKET AND STRUCK OTHER EMP FINGER, SITTING APPROX 2 FEET AWAY.

EE WAS ATTEMPTING TO REMOVE A BURNED OUT FUSE FROM THE ELECTRICAL PANEL OF A PICKUP. THE KNIFE SLIPPED AND LACERATED THE EE IT. INDEX FINGER REQUIRING 4 SUTURES.

EMPLOYEE WAS USING A UTILITY KNIFE TO SPLIT AND SPLICE PLASTIC DRIP LINE ON LEACH PAD. HE WAS HOLDING THE DRIPLINE IN FRONT OF HIM AND INSERTED THE BALDE. THE BALDE SLIPPED AS HE APPLIED PRE SSURE, SLICKING A 1 1/2" LACERATION IN HIS WRIST. THE CLEANLY CLICED WOUND REQUIRED SUSTURES TO CLOSE IT.

EMPLOYEE WAS USING A SLEDGE HAMMER TO LOCK A BUCKET TOOTH IN PLACE BY STRIKING THE TOP OF THE TOOTH.A CHIP FLEW OFF THE TOOTH AS HE STRUCK IT AND EMBEDDED BELOW THE KNEE.THE CHIP WAS 1/4" IN D IAMETER AND LESS THAN 1/16" THICK.

EE WAS PATROLING WEST OF LEACH PAD AROUND CLAY DUMP WHEN HE GOT STUCK. TRIED TO USE HANDYMAN JACK TO LIFT THE TRUCK TO GET OUT. JACK SLIPPED AND THE HANDLE HIT HIM IN THE MOUTH LACERATING HIS UPPER & LOWER LIPS. ONE TOOTH WAS KNOCKED LOOSE.

UNCLOGGING CRUSHER ROCK DISLODGED HIT ON HAND

AN ACCUMULATION OF MUD CAUSED A TAIL PULLEY ON CONVEYOR SYSTEM TO BIND CONVEYOR WAS STOPPED & LOCKED OUT & THE EMPLOYEE PROCEEDED TO USE A CROW BAR TO BREAK THE MUD FREE THIS RELEASED TNESION ON THE CONVEYOR BELT WHICH CAUSED THE TAIL PULLETO ROTATE THE CROW BAR STRUCK THE EMPLOYEE CAUSING HIM TO FALL THIS FALL WAS TO THE SAME LEVEL EMPLOYEE STRUCK HIS HEAD OCCIPITAL REGION AGAINST

TWO EMPLOYEES WERE ATTEMPTING TO DISLODGE BRIDGED ROCKS FROM BOTTOM OF FEED BIN. THEY WERE USING A CHOKER CABLE AND TWO CHAIN HOISTS TO PULL THE ROCK. THE CHOKER CABLE SLIPPED ON THE ROCK CAUS ING A POPPING NOISE. THE NOISE CAUSED EMPLOYEE, I.NAME TO JERK HIS HEAD TO THE LEFT. HE HIT HIS HEAD ON THE SIDE OF THE CRUSHER FEEDER CHUTE.