Buscar en el registro

Bulk loader closing railcar gate with bar. Gate gear skipped track, right hand was smashed between the bar and the bottom of railcar. Bulk loader was taken to ER, diagnosed with hand contusion. Given a hand brace to wear, released to return to work 6/17/2021.

EE was cutting timber shaft guides. The saw used would not cut the depth of the guide. EE used a sledge hammer to break off the end. EE reported that they felt a pull in right lower back, while doing this.

Scaling the roof by hand with a scaling bar. As he was scaling a loose rock fell and struck the bar causing intense pain in right arm.

He was removing a guide by cutting it into manageable pieces and his hand got caught between two pieces of timber which cut his finger.

The employee used a bar to lift an object. The bar slid out pinching his right pinky finger. Received 3 stitches.

EMPLOYEE WAS REMOVING A HEATER HOSE FROM THE MAINTENANCE TRUCK WHEN HIS SCREW DRIVER SLIPPED AND HE HIT HIS FINGER AGAINST THE HOSE CLAMP. WAS TAKEN TO THE EMERGENCY ROOM WHERE HE RECEIVE D SOME STITCHES.

EMPLOYEE WAS HOLDING LADDER FOR CO-WORKER WHO WAS DRIVING A WEDGE INTO CEILING TO OPEN A GAP IN A SALT LAYER TO BE SCALED DOWN. THE WEDGE SLIPPED, RICOCHETED OFF THE CEILING AND HIT EMPLOYEE O N THE LEFT INDEX FINGER.

EE WAS LOOSENING A NUT ON THE LID OF THE EIMCO WITH A LARGE PIPE WRENCH, WHEN THE WRENCH SLIPPED AND SMASHED HIS RING FINGER ON HIS LEFT HAND BETWEEN THE WRENCH AND STEEL PLATE, CAUSING A FRAC TURE AND BRUISING OF THE NAIL. DID NOT SEEK MEDICAL TREATMENT IMMEDIATELY. IT WAS A FEW DAYS LATER.

EE WAS ATTEMPTING TO CLOSE THE SLIDING DOORS ON THE BOTTOM OF THE HOPPER RAIL CAR, WITH A PRY BAR. HE STUCK THE BAR IN THE HOLE FOR THIS PURPOSE AS INSTRUCTED, BUT THE BAR SLIPPED OUT WHEN HE APPLIED PRESSURE, CAUSING HIM TO LOSE HIS BALANCE, PULL AND STRAIN HIS RT SHOULDER AND RT SIDE OF HIS NECK. EE WAS GIVEN PRESCRIPTIONS OF PAIN RELIEVER AND MUSCLE RELAXER.

HE WAS SHOVELING AND SWEEPING SALT FROM UNDER THE FINE BELT (TAIL PULLEY) IN HIS WORK AREA. HE WAS WORKING IN A STOOPED POSITION AND POSSIBLY TWISTED WRONG WHILE SHOVELING OR SWEEPING. HAS HAD PAIN IN LOW BACK AREA. WENT TO CHIROPRACTOR FOR BACK MANIPULATIONS.

EE WAS TRYING TO CLOSE THE SLIDE DOOR ON THE BOTTOM OF A HOPPER CAR WITH A PRYBAR. HE INSERTED THE BAR IN THE HOLE OF THE SHAFT AND WHEN HE STARTED TO RAISE THE PRYBAR TO TURN THE SHAFT IT TUR NED IT ALL AT ONCE. THE END OF THE PRYBAR SMASHEED EE'S FINGER AGAINST THE RAILCAR. HE SMASHED HIS MIDDLE FINGER ON HIS RIGHT HAND, BROKE AND TORE FINGERTIP INCLUDING NAIL.

STRAINED LOWER BACK WHILE SWINGING A HAMMER IN A CRAMPED POSITION, WHILE TRYING TO GET SALT TO FLOW FROM THE JUMMER SCREENS.

EMPLOYEE WAS USING A HAMMER TO TAP AN INSERT IN SHOOT STRUCK HIS THUMB.

WAS SWEEPING FLOORS AND BACK STARTED HURTING.

HOLDING DOOR JAMB APART JACK POPPED OUT STRUCK IN CHEST