Buscar en el registro

EMPLOYEE WAS USING UTILITY KNIFE TO CUT TIE WRAPS FROM PIPE. THE KNIFE SLIPPED CUTTING THE EMPLOYEE'S LEFT INDEX FINGER. REPORTABLE DUE TO STITCHES RECEIVED.

EE WAS TRYING TO REMOVE A SPEED REDUCER FROM HEAD SHAFT ON PRODUCT ELEVATOR. THERE WAS A GEAR PULLER USED TO REMOVE REDUCER. EE WAS APPLYING PRESSURE TO GEAR PULLER WITH 12 INCH ADJUSTABLE WRE NCH. THE WRENCH SLIPPED AND EE STRUCK HIS RIGHT ARM ON MOTOR MOUNT LOCATED BEHIND HIM. ALSO HE HIT HIS RIGHT HAND INDEX FINGER AT THE KNUCKLE.

CONTRACTOR EE CUT INSIDE PALM OF LEFT HAND ON STEEL ANGLE IRON WHILE SWEEPING FLOOR WITH BROOM.

EE WAS INSTALLING A NEW STEEL DISCHAGE CHUTE AT THE END OF 1 DRYMILL. THIS WAS NOT A ROUTLINE MAINTENACE JOB IT REQUIRED EE TO DO AS LOT OF PUSHING AND PULLING ON CHUTE IN ORDER TO ALIGN BOTH ENDS OF CHUTE WITH EXISTING DUCT WORK. BECAUSE OF THIS ACTIVITY REQUIRED TO MOVE THE CHUTE. HE STRAINED SOME MUSCLES IN HIS LOWER BACK.

EE WAS CHANGING DRIVE END BEARING ON 16 INCH DIA SCREW FROM FLINT BELT TO NO. 2 GLASS SILO. HE WAS PUSHING ON A WRENCH WITH HIS RIGHT HAND. WHEN THE WRENCH SLIPPED AND HE PULLED SOMETHING LOOS E IN HIS RIGHT HAND HE NOTIFIED HIS SUPERVISOR SAID HIS HAND WAS OK AND CONTINUED TO WORK THE REMAINDER OF DAY EE WAS SENT TO CO DR ON WED DR HAD HAND X RAYED AND EE HAD PULLED MUSCLE.

EMPLOYEE WAS ATTEMPTING TO PRY UP A CORNER OF TEH ROTEX SCREEN WHEN HE STRAIGHTENED UP HE COMPLAINED ABOUT A PAIN IN HIS BACK.HE CONTINUED TO WORK THAT DAY.SUNDAY HE WAS MOVING SOME MATERIAL A ND FELT A SHARP PAIN IN HIS BACK.

EMPLOYEE WAS HOLDING A COLD CHISEL AGAINST A BEARING INTER-RACE ON #3 DRYMILL PINION. HE WAS HITTING THE CHISEL WITH A HAMMER. A PIECE OF STEEL CAME OFF FACE OF CHISEL AND HIT HIM IN THE ARM. HE REPORTED ACCIDENT BUT DID NOT FEEL THAT THE PIECE OF STEEL HAD ENTERED HIS ARM. AFTER SEVERAL DAYS OF HEALING, A LUMP FORMED UNDER SKIN SO HE WAS SENT TO THE DOCTOR TO HAVE CHECKED.