Buscar en el registro

EE WAS TRANSPORTING LONGWALL PANS ON A SHIELD DOLLY. COMING DOWN IN THE DIP AT 343 CROSS CUT, THE DRAW BAR BROKE AND THE DOLLY CAME LOOSE FROM ANOTHER DOLLY. SO EE WAS IN THE PROCESS OF JACKIN G THE PAN UP OFF THE LOWBOY SO HE COULD REMOVE THE PIN. WHILE REMOVING THE PIN, THE PAN FELL PINNING THE EE BETWEEN THE PAN AND THE TRACK RAIL.

EE WAS CUTTING BAND OFF CABLE WITH UTILITY KNIFE. KNIFE SLIPPED AND HE CUT HIS LEFT HAND.\

EMPLOYEE WAS HELPING MECHANIC INSTALL NEW BELTS ON SECTION FRESH WATER PUMP. WHEN ATTEMPTING TO PRY THE BELT INTO PLACE WITH A SCREWDRIVER WHILEPULLING THE BELT WITH HIS OTHER HAND, HIS MIDDLE FINGER GOT CAUGHT UNDERNEATH THE BELT & WAS CUT.

PULLING ON WRENCH TIGHTENING A BOLT IN THE MINER HEAD WHEN HE FELT A PAIN IN HIS LEFT KNEE. ALSO HEARD A LOUD POPPING NOISE.

INJURED WAS CUTTING OFF A FIRE EXTINGUISHER TAG USING A RAZOR KNIFE. LOST CONTROL OF KNIFE AND CUT HIS RIGHT THUMB.

EMPLOYEE WAS USING BAR TO LIFT DRIP PAN BACK ON CAR AFTER IT SLID PART WAY OFF AND FELT PAIN IN LOWER LEFT SIDE TOWARDS BACK.

WHILE INSTALLING TROLLEY WIRE, WRENCH SLIPPED OFFOF BOLT AND INJURED FELL BACKWARDS ONTO A STONE CAUSING PAIN IN LEFT RIB AREA. (FRACTURE LEFT 10TH RIB).

INJURED WAS STEPPING DOWN FROM SEMI=TRAILER (FLATBED) WHEN CHANNEL LOCK PLIERS GOT CAUGHT ON STRAP STEEL ON SIDE OF TRAILER CAUSING THEM TO TEAR INTO HIS RIGHT UPPER ARM CAUSING A DEEP LACERAT ION. SUTURES REQUIRED.

MAKING A SPLICE ON BELT USING A RAZOR KNIFE. KNIFE SLIPPED CUTTING INJURED ACROSS TOP OF LEFT WRIST. (SUTURES.)

WHILE REMOVING HOISTS FROM LOAD, HANDLE SLIPPED OUT MAKING CATCH MECHANISM RUN HITTING INJURED'SLEFT THUMB TRAPPING IT BETWEEN LATCH AND CRANKERCAUSING LACERATION. FIVE SUTURES REQUIRED.

HOLDING A WOODEN POST FOR CO WORKER, THE POST SHIFTED AND CO WORKER SUNG AN AXE TO SET A WEDGE AND STRUCK INJURED ON RIGHT HAND CAUSING SMALL LACERATION TO RIGHT MIDDLE FINGER.

USING AIR BAG TO LIFT SHIELD DOLLY. THE BOARDS USED TO BLODK ENDS OF BAGS CAME LOOSE AND SWUNG BACK HITTING THE INJURED IN RIGHT LEG.

HITTING A PIPE WRENCH WITH A SLEDGE HAMMER (12LBTO KNOCK LOOSE A JIC FITTING ON WATER COUPLER, STRUCK HIS LEFT HAND CAUSING LACERATION.

EMPLOYEE WAS USING A RATCHET WITH A CHEATER BAR. RATCHET SLIPPED OFF THE BOLT HE WAS TRYING TO GET LOOSE AND HIT HIS WRIST AGAINST THE CARRIAGE ON BELT TAKE UP.

PUMPING GREASE INTO MINER HEAD. LID ON GREASE BUCKET OPEN, ON DOWN STROKE OF PUMPING HE CUT HIS LEFT FINGER KNUCKLE ON THE OPEN LID. LACERATION REQUIRED 5 SUTURES.

USING A BOWSAW TO CUT A TREE LIMB THAT HAD FALLEN FROM THE BANK TO THE LOAD DOCK AREA. AFTER MAKING HORIZO9NTAL TOP & BOTTOM CUTS, A VERTICAL CUT WAS STARTED WHEN THE BLADE STUCK. WHILE EXERTI NG ADDL PRESSURE TO FORCE THROUGH THE CUT, LEFT HAND SLIPPED OFF HANDLE AND CAME ACROSS BLADE. ALACERATION OF THE PALM APPROX 3"L OCCURED

WORKING ON HEADLIGHT COVER TIGHTENING UP BOLTS, WRENCH SLIPPED OFF BOLT HEAD STRIKING MIDDLE FINGER LEFT HAND ON CHAIN HOOK.

USING COMEALONG TO PICK UP THE BOTTOM BELT. THE PLANK BROKE AND THE SHORT END OF THE PALNK AND A PIECE OF STONE HIT HIM ON THE HEAD (12"X8"X2") KNOCKING HIM BACK ON HIS BACK.

CUTTING BANDS FROM PILE OF STANDS STORED TWO BUNDLES HIGH. STANDS CAME DOWN CAUGHT LITTLE FINGER BETWEEN TWO STANDS LACERATING AT FIRST JOINT ON INSIDE.

CUTTING A PIECE OF HOSE WHEN HE SLIPPED AND FELLWHILE FALLING THE KNIFE HE WAS USING CAME IN CONTACT WITH HIS LEFT HAND CAUSING A CUT IN THE FLESHY AREA BETWEEN THE THUMB AND INDEX FINGER.

CUTTING TAPE OFF A CHECK VALVE ON A T&T PUMP WITH A RAZOR KNIFE WHEN IT SLIPPED AND HE LACERATED HIS LEFT THUMB.

REBUILDING A PLATE SHIFTER AND WAS TRYING TO REMOVE A BOLT IN A ROLLER. INJURED WAS STRIKING THE ROLLER TO LOOSEN THE BOLT WITH A SMALL SLEDGE HAMMER. HE PLACED THE ASSEMBLY ON THE FLOOR AND H IT THE ROLLER. IT BROKE INTO PIECES AND ONE CUT THE TOP OF HIS HAND AND AREA BETWEEN HIS MIDDLE AND RING FINGER.

EMPLOYEE WAS TIGHTENING LUG NUTS ON A SHUTTLE CAR WHEEL USING A RATCHET BREAKER BAR WITH A CHEATER BAR ATTACHED TO IT. THE RATCHET BROKE AND CHEATER BAR SLIPPED AND STRUCK HIM IN THE FOREHEAD. HE FELL STRIKING HIS HEAD ON COAL RIB.

EMP WAS CUTTING OFF PLASTIC TIES ON THE AIR COMPRESSOR PIPING. HE WAS REACHING OVER HEAD USING AUTILITY KNIFE. DIRT FELL IN HIS EYE AND HE DUSKED HIS HEAD & CUT HIS LEFT MIDDLE & INDEX FINGERS

EE WAS TURNING TRACK RAIL WITH SLATE BAR. HE LET BAR GO AND STOOD UP. THE RAIL ROLLED BACK OVER CAUSING THE BAR TO STRIKE THE EE ON THE LEFT SIDE OF THE FACE.

EMPLOYEE WAS KNEELING DOWN USING A TRACK JACK TO GET A SUPPLY CAR BACK ON TRACK WHEN THE JACK BAR SLIPPED OUT OF THE JACK HITTING HIS CHIN.

EMPLOYEE WAS TAPPING ON A BEARING RACE WIHT AHAMEMR WHEN A CHIP CAME OFF THE HAMMER LODGING UNDR THE KNUCKLE ON RIGHT INDEX FINGER.

EE WAS TRYING TO MOVE A 6 X 6 PUMP ACROSS TRACK WITH A STONE BAR. HE FELT PAIN IN LOWER BACK.

EMPLOYEE WAS CUTTING BELT WITH UTILITY KNIFE WHEN HIS HAND SLIPPED OFF OF THE KNIFE CUTTING HIS RIGHT LITTLE FINGER.

EMPLOYEE WAS DRIVING THE PIN OUT OF THE DRIVE CHAIN ON A BELT WHEN A PIECE BROKE OFF AND STRUCK HIM IN THE LEFT THUMB. (AS DESCRIBED BY EMPLOYEE

EMPLOYEE WAS ATTEMPTING TO TURN AN 8" "H" BEAM IN SCOOP BUCKET WITH A BAR WHEN THE BAR CAME OUT CAUSING PAIN TO HIS RIGHT WRIST.

EE WAS JACKING UP PUMP CAR WHEN THE JACK SLIPPED STRIKING HIM ON THE RIGH HAND PINCHING IT AGAINST THE RIB .

EMPLOYEE WAS TRYINGTO ALIGN RAILROAD TRUCK. HE LIFTED THE TRACK WITH A SLATE BAR AND STRAINE DHIS BACK.

EMPLOYEE WAS CUTTING A LOOSE STRAND OF BELT WITH A RAZOR KNIFE WHEN HE SLIPPED CUTTING HIS LEFT THIGH. (AS DESCRIBED BY EMPLOYEE).

EMPLOYEE WAS CUTTING SOME CHAIN USING A HACKSAW THE HACKSAW SLIPPED ON THE CHAIN CUTTING HIS LEFT THUMB. (AS DESCRIBED BY EMPLOYEE)

WHILE INSTALLING PIN IN RELAY BAR ANOTHER EE WAS DRIVING PIN INTO RELAY BAR AND ACCIDENTLY STRUCK INJURED S LEFT HAND.

EE WAS WORKING ON GRADEALL BRAK PANCAKE. HE WAS SAWING OFF LONG THREADED ADJUSTMENT BOLT WHEN HIS HAND SLIPPED, CUTTING HIS MIDDLE FINGER ON THE PANCAKE.

HE WAS WORKING WITH ANOTHER EMPLOYEE WHEN THEY STUCK A LONGWALL HAMMER INTO THE END OF A WOODEN CABLE REEL AND WHEN HE HIT THE HAMMER WITH HIS HAMMER IT CAUSE A PIECE OF METAL TO FLY OFF OF TH E HAMMER AND IT ENTERED THE BACK OF HIS LEFT HAND. (AS DESCRIBED BY EMPLOYEE)

95107UTTING MINER CONVEYOR CHAIN TOGETHER USING 2 LB HAMMER TO DRIVE THE LINKS IN WHEN PIECE OF CONVEYOR LINK PIN BROKE OFF AND STRUCK UPPER PORTION OF CHEST.

EMPL LAYING ON THE GROUND WHILE INSTALLING STRUCTURE AND ROLLER AT THE TAKE -UP OF A-BELT. PRYING A BOTTOM ROLLER INTO PLACE AND IT SPRUNG HITTING HIM IN HEAD.

EMPLOYEE WAS KNOCKING A HOLE IN STOPPING WITH SLEDGE HAMMER FOR VENTILATION PURPOSES.THE HAMMER STRUCK AND THREW EMPLOYEE OFF BALANCE CAUSING HIM TO STRIKE HIS FINGER ON BLOCK STOPPING.AS DESC RIBED BY EMPLOYEE.

EMPL REMOVING BOLT FROM FILTER PRESS SHAFT COUPLER.HOLDING A 1 7/8" OPEN WRENCH.THE NUT SPUN OFF AND CAUGHT LEFT INDEX FINGER BETWEEN THE NUT AND WRENCH.

EMPLOYEE WAS RESETTING POST WHEN THE BAR HE WAS USING SLIPPED CATCHING HIS FINGER BETWEEN THE BAR AND RIB.

EMPLOYEE WAS HELPING CREW JACK PORTAL BUS ON TRACK USING JACK, WHEN JACK KICKED, STRIKING EMPLOYEE ON HAND AND THUMB.

EMPL ASSISTING ANOTHER MECHANIC TIGHTENING A BOLT.WRENCH SLIPPED CATCHING FINGER UNDER WRENCH.

EMPLOYEE CAUGHT FINGER BETWEEN JACK AND TRACK TIE WHILE JACKING UP A PARTS CAR. AS DESCRIBED BY EMPLOYEE,

EMPL HOLDING POST WHEN ANOTHER EMPL STRUCK HAND WITH HAMMER.

WHILE STRIKING UNIT WITH HAMMER HANDLE HIT EMP IN SIDE OF HEAD

VALVE BANK OFF OF TRANSMISSION TRUCK FELL ON EE S HEAD AS HE WAS WORKING ON TRUCK. HARD HAT WAS BEING WORN AT TIME OF INCIDENT.

EMPLOYEE HIT HIS LEFT THUMB WITH AN AXE WHILE LEVELING CAP BOARD ON BOTTOM TO SET POST AS DESCRIBED BY EMPLOYEE