Buscar en el registro

PRYING WITH BAR MOVING MOTOR AT THE BIG BRANCH AREA.

INJURED CLAIMS TO HAVE BEEN LEANING OVEN HANDRAIL ON THICKNEN FLUME PULLING UP ON ROPE WHICH WAS CONNECTED TO 4 INCH METAL PIPE AND CLAIMS THAT HE FELT PAIN IN RIBS AS HE PULLED UP ON ROPE AND PIPE 2 MEN PULLING IN UNSAW ON 10FT SECTION OF4 INCH PIPE.

INJURED CLAIMS TO HAVE INJURED BACK SOMETIME DURING SHIFT WHILE HELPING HOIST LARGE TRANSFORMER INTO CABINET BY USE OF CHAIN HOIST.INJURED COMPALINED OF BACK HURTING THROUGHOUT THE SHIFT BUT C OULD NOT EXPLAIN HOW HE INJURED BACK.ACCIDENT IS BEING PROTESTED.

REMOVING TIRE WITH SLATE BAR, IT SLIPPED CAUSING HIM TO FALL TO FLOOR

INJURED WAS HITTING SIDE OF COAL CHUTE WITH 12# HAMMER WHEN HAMMER HEAD CAME OFF OF AHNDLE CAUSING INJURED TO HIT A PIECE OF METAL WITH HIS AHND .HE WAS SWINGING HAMMER HANDLE.

CLEANING GRIZZLY AT THE ROTARY BREAKER USING A ROOF BOLT TO REACH THROUGH DOOR REACHED TOO FAR CAUSING PAIN IN BACK

USING A HAMMER TO REPLACE A GEAR ON HEAD ROLLER WHEN THE HAMMER SLIPPED HITTING FINGER.

HE WAS TRYING TO OPEN DRYER DOOR WITH A HAMMER AND AS HE PULLED ON THE DOOR, HE HAD PAIN IN HIS BACK.

INJURED WAS POSITIONING 8"X67 " METAL PIPE TO BE WELDED WHEN FELLOW EMPLOYEE HIT TIP OF FINGER WITH #10 SLEDGE HAMMER.INJURED WAS WEARING GLOVES AT TIME OF ACCIDENT.

USING A CHAIN AND HAMMER TO GET BROKEN SCREW OUT OF THE END OF PUMP SHAFT.

EMPLOYEE WAS CLEANING THE CLOSING DOORS ON THE RAILROAD CARS. WHILE USING A BAR TO CLOSE LATCH ON THE DOOR, THE BAR SLIPPED CAUSING EMPLOYEE TO FALL.

HE WAS LEANING OVER FEEDER DISCHARGE END AND TURNING TURNBUCKLE WITH A SHORT BAR WHEN THE BAR SLIPPED AND HIT HIS FACE.

WAS IN TRACTOR 8ECK REPLACING PANIC SWITCH WHEN THE WRENCH SLIPPED CUTTING HIS FINGER.

TRYING TO DRIVE3THE PIN OUT OF THE MINER BOOM WITH A LONG BAR WHEN THE BAR BROKE HITTING EMPLOYEE ON THE RIGHT LEG.

PUTTING HYDRAUL3C HOSE ON ROOF BOLTER. HE WAS USING AN OPEN END WRENCH AND HITTING IT WITH A HAMMER WHEN THE WRENCH SLIPPED CAUSING THE HAMMER TO HIT HIS THUMB.

EMPLOYEE WAS CU7TING BELT WITH KNIFE, PULLING KNIFE TOWARD HIM, WHEN THE KNIFE SLIPPED AND CUT THE EMPLOYEE ON HIS LEFT THIGH.

SCRAPING BUILD 6P OFF SIDES OF CHUTES TO PREVENT PLUG UPS IN CHUTES AND HIT CLAMP CUTTING HIS KNUCKLES.

REPLACING STEEL3HOSE ON DOZER PUSHING END OF STEEL PIPE WITH BAR AND BAR SLIPPED CATCHING HIS FINGER BETWEEN THE PIPE HE WAS HOLDING AND ANOTHER PIPE

BUSTING ROCK WI7H A SLEDGE HAMMER AND WHILE RAISING HAMMER TO HIT ROCK, HE HIT HIS KNEE.

USING A HAMMER 5ND SCREWDRIVER TO PRY THE LOCK OFF ON THE BATHHOUSE SUPPLY ROOM DOOR WHEN THE SCREWDRIVER FLEW OFF AND HIT EMPLOYEE IN RIGHT EYE.

REMOVING KING PINS FROM FRONT END OF TRUCK USING PUNCH AND HAMMER.

DRIVING SHAFT THROUGH BEARING HOUSING SLEDGE HAMMER WHEN THE HEAD OF THE HAMMER CAME OFF STRIKING LEFT HAND

CLOSING RETAINING BAR ON CAGE TO HOLD PIPE IN PLACE AND CAUGHT THUMB AGAINST CHANNEL ON CAGE.

EMPLOYEE WAS USING HAMMER AND PUNCH TO REMOVE U-JOINT FROM DRIVE SHAFT WHEN A CHIP OF METAL CLEWOFF OF PUNCH AND STRUCK INJURED IN STOMACH. STO

INJURED WAS IN PROCESS OF REMOVING RADIATOR FROM ENDLOADER BY USING A 3/8" RATCHET AND SOCKET. INJURED EXPERIENCED PAIN IN ELBOWS WHILE PULLING ON RATCHET HANDLE. THIS APPEARS TO HAVE BEEN A R ECURRENCE OF AN OLD INJURY IN THAT SURGERY HAS BEEN PERFORMED IN THE PAST ON THE SAME ELBOW

INJURED WAS USING A UTILITY KNIFE TO CUT HOLES IN SKIRT RUBBER (BELT) WHEN KNIFE SLIPPED CASUSING LCERATION TO T HUMB WHICH REQUIRED THREE (3) STITCHES

THE INJURED WAS ATTEMPTING TO TAKE A LEVEL WIND OFF OF A S/C WHEN THE WRENCH HE WAS USING SLIPPED OFF THE BOLT. THE INJURED THEN STRUCK HIS FINGER ON THE SIDE OF THE REEL. THERE WAS A SMALL CU T ON HIS RIGHT RING FINGER. THE INJURED HAD GREASED & DIRT ON HIS HANDS. THE HAND BECAME INFECTED.

INJURED WAS INSPECTING A BEARING A RAW COAL SCREEN WHILE USING A PIPE WRENCH TO TIGHTEN UP ON THE COUNTERWEIGHT THE WRENCH SLIPPED CAUSING HIS HAND TO CONTACT THE RAW COAL SCREEN WHICH HADS HARP EDGES ON IT

INJURED WAS TRIMMING THE RUBBER FLAP ON THE TRUCK FEEDER CHUTE WITH A RAZOR KNIFE HE WAS CUTTING TOWARDS HIMSELF USING BOTH HANDS. THE KNIFE SLIPPED, STRIKING HIMSELF WITH THE KNIFE BLADE ON H IS RIGHT THIGH CAUSING A I INCISION.

CUTTING LENGTH OF FLEXIBLE HOSE OFF PUMP WITH KNIFE.CUTTING TOWARDS HIMSELF,KNIFE SLIPPED CAUSING INCISION 1\\ LONG ON UPPER RIGHT THIGH.

USING A HAMMER TO DRIVE OLD BEARING OFF PUMP SHAFT AND A PIECE OF METAL CHIPPED OFF THE HAMMER LODGING AGAINST BONE IN LEFT LEG BELOW KNEE.

THE VICTIM WAS POUNDING ON A DRILL HEAD WITH AN AX HE HAD HIS DRILL STEEL LODGED INTO THE CHUCK THE CHUCK BROKE A PIECE FLEW OFF AND STRUCK VICTIMS LEG

USING HANDLE ON GRIP HOIST TO TAKE UP SLACK IN BELT WHEN EMPL HIT FINGER ON FIRE OUTLET ON FIRE SUPPRESSION OUTFIT.

USING BOW SAW ...WHEN SAW SLIPPED OUT OF GROOVE AND STRUCK HIS LEFT INDEX FINGER CAUSING LACERATION....POST NOT SECURED WHICH CONTRIBUTED TO MOVEMENT.