Buscar en el registro

EE was using a combination wrench to loosen a bolt; the wrench slipped causing ee to strike his right hand on a channel support.

Employee was pulling on the chain of a chain hoist and experienced pain in his right shoulder.

Employee was using a utility knife to cut a cardboard box. Employee lacerated his left thumb with the utility knife.

Employee was bending a piece of 1/4" x 2" steel strap around a piece of pipe. He lodged one end of the strap between the pipe and a pipe hanger, and was heating the strap with a torch and hitting it with a hammer. The strap came out of the area between the pipe and pipe hanger and struck the employee in the mouth.

EE WAS STANDING NEAR THE TOP OF A 16' STEP LADDER SWINGING A 3 LB HAMMER TRYING TO LOOSEN A PVC FITTING WHEN LADDER WOBBLED CAUSING HIS BACK TO TWIST. THIS REPORT IS BEING FILED DUE TO PHYSICA L THERAPY BEING STARTED ON APRIL 10, 03 AND TO CONTINUE FOR AT LEAST TWO WEEKS.

LOOSENING BOLTS ON A MOTOR USING A WRENCH FELT PAIN IN LOWER BACK

WHILE LIFTING A SECTION OF A VIB. COAL SCREEN, USING A CHAIN HOIST, EE FELT PAIN IN HIS SHOULDER.

EMPLOYEE DROPPED A ONE AND FIVE-EIGHTS COMBINATION WRENCH ON HIS LEFT FOOT, WHILE PERFORMING MAINTENENCE ON PUMP. PLEASE SEE ATTACHED NOTE ON DOCTOR'S REPORT AND DATES.

EE WAS USING A KNIFE INSTEAD OF WIRE STRIPPER OR HOLDING WIRE WHERE KNIFE COULD STRIKE HAND.

WHILE WALK NEAR A STAIRWAY EE SLIPPED & HIT HIS LEG ON AN ANGLE IRON SUPPORT

EE WAS CUTTING METAL BAND WHICH THEN STRUCK AND LACERATED HIS LEFT WRIST WHEN TENSION RELEASED.

EE WAS REMOVING AN 8 " PIPE FROM PLANT. WHILE RIGGING A COME-A-ALONG, IT BECAME TANGLED, EE PULLED ON IT CAUSING THE HOOK TO BECOME UNTANGLED AND STRIKE HIM ON THE LIP.

EMPLOYEE WAS USING A POCKET KNIKE TO CUT A NYLON TIE RAP WHEN THE KNIFE SLIPPED & CUT HIS HAND. HE RECEIVED 3 STITCHES AT INDIANA HOSPITAL E.R.

WHILE BENT OVER WIRE BRUSHING THE THICKNER FLUME, EMPLOYEE FELT PAIN IN HIS LOWER BACK.

INJURED WAS REMOVING A LANTERN RING FROM #A356 PUMP WITH A PACKING PULLER. WHILE PULLING WITH BOTH HANDS HE FELT PAIN IN HIS NECK.

TIGHTENING BOLTS ON AN ELBOW (PIPE) IN THE 'A' SCRUBBER ROOM.

EMPLOYEE WAS DESCENDING STEPS ON #A-50 PETERSON FILTER WHEN HE SLIPPED, STAINING GROIN MUSCLE. NOTE. FIRST DAY OFF WORK WAS 12-17-93, OPERATION TO CORRECT.

EE WAS CLEANING OFF ROWING THE B DRYER BED WHEN HE EXPEREINCED A PAIN AND PULL ON THE BACK OF HIS NECK AND DOCUN HIS LEFT ARM HE FIRST SAW DR ON 11-16-93 AND CONTINUED TO WORK WITHOUT AESTRICT ION HE STARTED TO MISS WORK ON 11-29-93.

WITH PASSING COMMENT TO FOREMAN..EMPLOYEE STATED HE HAS A LITTLE PAIN IN BACK. EMPLOYEE WAS PERFORMING HIS NORMAL DUTIES SHOVELING, CLEANING ETC. ETC. ON 8/23/93 EMPLOYEE SENT TO INDIANA HOS PITAL WITH CHEST PAIN HE CLAIMS IT WAS CAUSED ON 8/18/93.

THE EMPLOYEE WAS ATTEMPTING TO CLEAR A COAL FEEDER CHUTE WITH A LONG BAR.

HE WAS ATTEMPTING TO TIGHTEN AN ALTERNATOR ON A REFUSE TRUCK USING A PRY BAR AND A WRENCH. THE BAR SLIPPED CAUSING HIS FINGER TO HIT A SHARP METAL BRACE, CAUSING A LACERATION TO HIS MIDDLE FIN GER ON HIS RIGHT HAND.

INJURED WAS ATTEMPTING TO ADJUST THE TAIL PULLEY ON BELT CONVEYOR #3, USING THE ADJUSTING BELTS, WHEN HE PUSHED ON THE WRENCH TO APPLY TORQUE TO IT. HE FELT PAIN IN HIS BACK.

WHILE PULLING OUT THE SLIDE GATE AT #BIN 2, INJURED WAS RATCHETING A COME-A-LONG AND HE FELT SOMETHING IN HIS SHOULDER (MUSCLE PULL).

WHILE CLEANING A SPRAY NOZZLE A BURR PUNCTURED HIS MIDDLE FINGER.NOTE -INJURED WAS OFFERED MEDI ATTENTION AND REFUSED HIS FINGER BECAME INFECTED AND WENT TO THE DOCTORS AT A LATER DATE.

REPLACING STEEL BEAM DRIVING BULL PIN WITH BALL PEEN HAMMER WHEN HAMMER STRUCK CLIP ON BEAM GLANCED STRUCK BACK EMP L HAND WHICH WAS HOLDING PIN

USING PC OF PIPE, TO CLEAN OUT CHUTE STRAINED BACK

HE WAS TIGHTENING BOLTS ON A ROUST-ABOUT PIPE COUPLING USING A WRENCH. ELBOW BECAME SORE. HE DID NOT MISS ANY WORK UNTIL 3-13-91.