Buscar en el registro

Employee was operating a piece of equipment (dozer) when he came to uneven ground which resulted in the jarring of his back.

Employee was using a pneumatic impact wrench to tighten a bolt. He used his left shoulder to lean against the wrench for more leverage. This resulted in pain to his shoulder and chest. After seeing a medical professional this injury was not MSHA recordable; however the employee wished to get a second opinion at which time it became reportable.

Employee was using pressure washer to clean equipment when he decided to use on his boot. The wand slipped and went in his boot resulting in a burn to left foot

Employee burned his eyes due to a welding flash.

Employee was assisting in the maintenance to shaker when the crane malfunctioned when lowering shaker, pinning employee's left hand between the spring and mounting plate.

Employee alleges pain in left arm from shoulder to wrist due to repetitive operation of controls on dozer.

EE was using air ratchet tool, attempting to remove bolt from VSI table on crusher when he hit his hand against table.

EE was using a hydraulic jack to place metal liner up against crusher wall when the jack slipped hitting employees left forearm.

EE was operating the dredge when he stood up to close the door, at which time the cutter head hit a log causing the dredge to bounce, slamming the door against employee's right hand.

(3 EMPLOYEES WERE INJURED IN THIS ACCIDENT.) EE WAS ASSISTING IN THE INSTALLATION OF A REPLACEMENT DECK ON SHAKER WHEN THE DECK FRAME SUDDENLY SLID INTO PLACE, STRIKING EE IN THE PELVIC AREA (SURGICAL REPAIR REQUIRED).

(3 EMPLOYEES WERE INJURED IN THIS ACCIDENT.) EE WAS ASSISTING WITH INSTALLATION OF A REPLACEMENT DECK ON A SHAKER WHEN THE DECK FRAME SUDDENLY SLID INTO PLACE, STRIKING EE IN THE PELVIC AREA (SURGICAL REPAIR REQUIRED).

(3 EMPLOYEES WERE INJURED IN THIS ACCIDENT.) EE WAS ASSISTING WITH INSTALLATION OF A REPLACEMENT DECK ON SHAKER WHEN THE DECK FRAME SUDDENLY SLID INTO PLACE, STRIKING EE'S RIGHT FOREARM (SURGICAL REPAIR REQUIRED).

EE was assisting co-worker with plant maintenance inside primary shaker when the flash from welding being conducted by co-worker caused burns to his eyes. Given prescription for pain.

EE WAS ASSISTING IN WELDING THE PRIMARY SHAKER WHEN HE SUSTAINED WELDING BURNS OF THE EYES.

THE EE WAS OPERATING THE SURGE LOADER AND WHILE HE WAS BACKING UP HE NOTICED THAT HE WAS ABOUT OTO HIT THE HATCH ON THE EXCAPE TUNNEL. HE TURNED HIS HEAD FAST, AND LATER HIS NECK AND SHOULDER BEGAN TO HURT.

EMPLOYEE WAS OPERATING A MIG WELDER WHEN THE SLAG BURNED THROUGH HIS GLOVE CAUSING 2ND DEGREE BURNS TO LEFT HAND.

EMPLOYEE WAS OPERATING CUTTING TORCH FRO AN EXTENDED PERIOD OF TIME RESULTING IN STRAIN TO HIS NECK AND LOWER BACK.

OVER A PERIOD OF TIME, DUE TO OPERATING THE DRAGLINE, EE HAS DEVELOPED STRAIN TO BOTH KNEES.

EE WAS OPERATING DRAGLINE WHEN THE BRAKE PEDAL KICKED BACK UP, (DUE TO RUST BUILDUP CAUSED BY RAIN) HITTING RIGHT FOOT CAUSING SPRAIN TO RIGHT ANKLE. Y

EE WAS OPERATING HUYDRAULIC SHOVEL WHEN BOOM RELEASED CAUSING SHOVEL TO ROCK FORWARD, RESULTING IN ALLEGED NECK STRAIN.

EE WAS HOLDING A T POST WHILE A CO WORKER, OTHER WAS OPERATING THE T POST DRIVER. OTHER LOST, CONTROL OF THE DRIVER CAUSING IT TO FALL, HITTING EE FOREHEAD AND LEFT HAND.

LEVER ON ROAD GRADER KICKED BACK STRIKING EMPL'S HAND & JAMMING WRIST.

CHAIN BROKE OVE9 JAW CRUSHER DROPPING TOOTH OFF END OF CHAIN INTO CRUSHER,CRUSHER EXPELLED TOOTH AT EMPL AS HE TRIED TO ESCAPE.

INJURIED WAS GRINDING A DRILL BIT WHEN THE GRINDING WHEEL BROKE UP AND HITTING HIM IN THE HEAD.

EMP WAS OPERATING A BULLDOZER AND A LOW LYING THXXX TREE LIMB STRUCK HIM ACROSS THE NOSE

WELDING A PLATE IN THE CHUTE ON #1 TIPPLE ROLL AND GOT A PIECE OF HOT SLAG IN HIS EAR. HIS EAR GOT INFECTED