Incidentes mineros en Texas

Employee unhooked lanyard and fell through roof resulting in fatal injuries.

A contractor died after a concrete retaining wall collapsed into the excavated trench below crushing EE.

Unsure of what conditions contributed to the death

Third party delivery driver of raw materials was found deceased trapped between the frame and dump bed of EE's I-Bar owned and operated delivery truck. The driver was located on the West edge of the iron ore stockpile.

EE was operating an excavator in Pit 2 at SPS Atascosa. Pit 2 is located between two tailings ponds. 9:18 AM one of the tailings ponds breached causing tailings mixture to flow into the work site. Tailings mixture tipped over the excavator EE was operating cab side down. The front window broke, tailings mixture engulfed the cab & 75% of the vehicle. Employee could not escape.

Employee in the thin veneer area was crushed by a pallet of stone that was placed on them by another employee in a wheel loader.

Miner did not follow protocol. Therefore causing the death of the same.

Trench was dug to repair drain pipe. No sloping or shoring protection system was in place. Trench was approximately 10 foot deep and 8 foot wide. Side wall collapsed and crushed worker.

At this time unknown dump point failure causing haul truck operated by the deceased to back and roll down the dump point.

Arc flash event involving electrical equipment that resulted in burns to the employee's arms and torso as well as electrical equipment damage. The employee was injured and hospitalized after the incident but, passed away in the hospital on 08/22/2024.

May 9, 2024 at 0800 hours when a manlift operator ran EE's manlift, an 8008 JLG, serial number 0300310942, into the canopy covering the C35 conveyor belt coming out of C35 tunnel. The operator was pinned between the roof edge and the man basket hand rail.

An over the road truck driver was crushed while trying to unload gravel. Driver was parked in a jackknife position while trying to unload some of the gravel in EE's bed. While attempting to dump, EE's lift cylinder snapped and the trucks trailer fell on top of the driver's side killing the driver. 911 was called immediately and MSHA was called after.

Improper procedure performed, improper PPE, and not following SOP. *A customer truck driver fell from a large container mounted on the trailer of the truck while descending the container. The customer truck driver died from the injuries on August 7, 2023.

An outside truck driver came onto this site to get loaded where the driver then parked their truck and was out of view from out scale house. Driver began to work on the back of the truck where the air bag blew out from under the truck and hit the driver in the head. Driver was not our employee, nor was the driver supposed to be working on their truck.

While SC0539 Bulldozer was traveling on 1B Ramp, a large volume of material entered the road and contacted the bulldozer.

At time of filing it is believed a front-end loader struck the back of the tractor trailer. The position of the victim at the time of the accident is still under investigation. The victim was found under the rear driver's side tires of the tractor.

326 FL Excavator operator tracked over berm into Settling pond

Employee was working with a 3 man crew dismantling a Caterpillar 390F Excavator. During dismantling, EE was impacted by the counterweight. The other 2 crew members did not witness the accident.

Dredge operator was missing and eventually found at bottom of lake.

Customer truck driver pulled into tarping area behind another truck and failed to set parking brake before exiting the truck. The driver did not use wheel chocks as required. The customer truck driver was fatally injured when customer's truck moved forward and pinned customer truck driver against the other drivers truck.