Buscar en el registro

EMPLOYEE WAS GROUND SUPPORTING BACK OF TUNNEL WHEN SOME LOOSE MATERIAL SLID DOWN DRILL STEEL STRIKING EMPLOYEE ON HEAD CAUSING A CUT NEEDING STITCHES.

EMPLOYEE WAS PUTTING IN GROUND SUPPORT AFTER BARRING DOWN. LOOSE MATERIAL SLID DOWN DRILL STEEL STRIKING EE ON HIS NOSE CAUSING A CUT NEEDED 4 STITCHES.

Employee was ground supporting the back at alpine heading, when loose material fell, sliding down drill steel, striking employee on the face and left side of head.

EE CLAIMS HE WAS HELPING DRILL A FACE ROUND, WHEN A LOADER OPERATOR APPROACHED AND MUCKER APPARENTLY HIT AGAINST EE'S LOWER BACK, CAUSING INJURY. HIS PARTNER CLAIMS HE DID NOT SEE ANYTHING. THE MUCKER BUCKET WAS 5' IN THE AIR OR HIGHER; COULD NOT HAVE HIT HIS BACK AREA.

WHILE DRILLING FOR GROUND SUPPORT HOLES THROUGH CHAINLINK FENCE, LOOSE MATERIAL FELL OUT OF BACK, PUSHING CHAINLINK FENCING AND DRILL STEEL AGAINST EE'S BACK, CAUSING A BACK INJURY AND CUT ON FOREHEAD.

EE WAS GROUND SUPPORTING, HE WAS CUTTING SOME OLD BOLTS WITH A TORCH, WHEN THE CHAIN LINK HOLDING THE BOLT SLIPPED AND LOOSE MATERIAL FELL STRIKING EE ON RIGHT SHOULDER AND RIGHT LEG.

DURING GROUND SUPPORT, DEBRIS FELL ON HARD HAT. 2-15-02 PER CALL USING FORK LIFT.

THE EE WAS INSTALLING GROUND SUPPORT, WITH A DRILL MACHINE,JACKLEG, WHEN HE SMASHED HIS MIDDLE FINGER AT THE TIP. CAUSING A BONE SPLINTER. Y2107400272

EE WAS MUCKING SHAFT BOTTOM, MUCKER JUMPED GEAR TO NEUTRAL AND STRUCK HAULAGE WALL.

EMPLOYEE WAS HELPING A MINER GROUND SUPPORT ON UNEVEN GROUND WHEN SOME LOOSE MATERIAL FELL & ROLLED DOWN DECLINE SLOPE STRIKING THE EMPLOYEE ON THE BACK OF THE RIGHT KNEE CAUSING SOME BRUISING TO THE CALF AREA.

EMPLOYEE WAS CLEANING UP MUD WITH A CLAM SHELL, AS HE WAS MOVING CLAM SHELL INTO BUCKET, CLAM SHELL CLOSED ON LEFT HAND LITTLE FINGER.

EE WAS INSTALLING GROUND SUPPORT, AS HE WAS ROCK BOLTING SOME MATERIAL CAME DOWN AND HE WAS STRUCK ON THE NECK AND SHOULDER AREA.

WORKER TURNED TO RUN DURING GROUND MOVEMENT WHILE SUPPORTING THE ROOF. STRAINED BACK MUSCLES.

EE WAS OPERATING A JACKLEG DRILL. HE SLIPPED AND FELL ON A ROCK HANDING ON HIS RIBS AND HIS HEAD.

WORKER WAS PERFORMING GROUND SUPPORT OPERATIONS, IN WITH HE WAS INSTALLING A SPLIT SET ROOF BOLT TO SECURE A MAT TO THE BACK. WHILE INGAGING THE JACKLEG TO DRIVE, THE BOLT HOME, IT SLIPPED AL LOWING THE MAT TO FALL CUTTIN GTHE WORKERS ARM.

EE WAS TRAMMING WITH A MUCKER TO ORE RAISE. HE RAN OVER A GROUP OF ROCK WHICH JARRED HIM ENOUGHT TO STRAIN BACK MUSCLES.

EE WAS OPERATING THE DOZER, HE TURNED AROUND TO BACK UP LIFTING HIS ARM, HEARD & FELT A POP DISLOCATING HIS RIGHT SHOULDER.

EE WAS INSTALLING CHAIN LINK FENCING AS GROUND SUPPORT WITH DRILL MACHINE, MACHINE SLIPPED CAUSING EE TO COME IN CONTACT WITH FENCE SHARP EDGE, CUTTING LEFT FOREARM.

EMPLOYEE LOST HIS BALANCE AS HE WAS BOLTING FOR GROUND SUPPORT AND LOST CONTROLL OF THE JACKLEG AS IT SPUN COMMING DOWN STRIKING EE ON HIS HEAD AND RIGHT ARM.

WAS HELPING ROCK BOLTING, GROUND CAME DOWN HITTING HIM ON THE HEAD, SHOULDER AND CUT FINGER.

EE WAS TRYING TO GUIDE AIR TRACK DRILL STEEL STARTER WITH LEFT FOOT SO IT WOULD ENGAGE ONTO DRILL STEEL COUPLING. FOOT SLIPPED AND DRILL STARTER CAME DOWN ON LEFT FOOT TOES. CAUSING INJURY.

EMPLOYEE LIFTGED THE WELDR MOTOR HOOD AND STUCK HIS RIGHT HAND INTO, THE MOTOR. COMPARTMENT. STRIKING RIGHT HAND FINGERS AGAINST MOTOR FAN.

EMPLOYEE WAS DRILLING HOLES ON WORK BENCH WITH HAND DRILL. DRILLING CHIP FLEW UP AND INTO LEFT EYE.

EMPLOYEE WAS WORKING IN A MAN BASKET BEING LIFTED BY A BOOM CRANE, WHEN CABLE FROM CRANE SUPPORTING MAN BASKET BROKE DROPPING BASKET AND CRANE SHEAVE BLOCK. CRANE SHEAVE BLOCK WEIGHS APPROX 4 00 LBS AND DROPPED ONTO THE MANBASKET STRIKING EMPLOYEE CAUSING INJURY.

HE WAS HOLDING PEICE OF METAL WHILE HE DRILLED A HOLE INIT. THE DRILL BIT BROKE AND THE DRILL HIT HIM IN THE RIGHT HAND CAUSING CUT ON TOP OF HAND HE WENT TO DR. BECUASE CUT WAS NOT HEALING R ETURNED TO WORK SAME DAY.

EMPL BLOWING CALCINER TUBE WITH AIR LANCE WHEN HOT PRODUCT BLEW BACK MAKING CONTACT WITH EMPL NECT AND RIGHT ARM.

EMP WAS BLOWING OFF PARTS FOR REBUILD MOTOR WITH AIR HOSE AND GOT PIECE OF METAL IN LEFT EYE

EMPLOYEE WAS DRILLING A HOLE MOST CONTROL OF JACKLEG AND IT JACKKNIFED STRIKING EMPLOYEE ON THE LEFT CHEEK CAUSING A CUT.

EMPLOYEE WSA PULLING THE LIGHT SIGNAL CORD WHEN IT WRAPPED AROUND LEFT WRIST-CAUSING LEFT HAND TO JERK AND ROPE BURNS

EMP WAS ADJUSTING A FAN THAT WAS RUNNING FINGERS GOT CAUGHT IN BLADES CUTTING THEM

EMPLOYEE WAS INSTALLING ROCK BOLTS. THE PLATE SLIPPED DOWN THE BELT STRIKING AND CUTTING HIS RIGHT ARM.