Buscar en el registro

Employee was helping to install a shock absorber, while holding the nut with his hand, there was an impact wrench on the other side tighting the bolt.

Had stepped off of the drill to take a sample and heard a noise and looked up while a drill steel came down and hit on top of instep of his right foot and broke it.

The prell hose failed and blew prell into eye, causing minor burns to skin around eye and small laceration on eye.

EE WAS ATTEMPTING TO CHECK THE PUMPS IN THE BOTTOM OF THE PIT. THE WATER WAS GETTING TOO HIGH. AS HE STEPPED OFF OF THE STAIRS THE WATER WAS HIGHER THAT HIS BOOT TOPS. THE WATER WAS VERY HOT AND BURNT HIS LEFT ANKLE.

EE HAD PULLED A 15 PASSENGER VAN INTO THE SHOP TO CHANGE A FLAT TIRE ON THE LEFT REAR. HE CRAWLED UNDER THE VAN AND RAISED IT WITH A SMALL HYDRAULIC JACK. AS HE CRAWLED UNDER IT AGAIN TO RAISE IT HIGHER, IT ROLLED OFF OF THE JACK AND CRUSHED HIM.

Slate was being lowered with an overhead crane. Slate slipped and hit his hand. EE suffered deep laceration to right pinky finger. He was treated at hospital and released.

WHILE RETRIEVING THE CORE FROM A 45 DEGREE UPHOLE, EMPLOYEE UNSCREWED THE STUFFING BOX. THE OVERSHOT & STUFFING BOX CAME DOWN W/SOME FORCE & PINCHED HIS RT. HAND TO THE ROD SADDLE. THE BONES BETWEEN THE RT. THUMB & WRIST ARE SPLINTERED.

While working on drill press, drill bit caught causing a pice of iron to be pulled out of the clamp. Iron spun around causing a laceration to his left hand.

EE WAS SITTING IN THE TAMROCK BOLTER WHEN A LARGE BOULDER FELL OUT OF THE BACK AND CRUSHED THE CAB DOWN ONTO HIM.

CORDLESS DRILL WAS PLACED ON BOOM OF BOLTER. WHILE DRIVING IN A PIN THE DRILL FELL OFF BOOM AND THE DRILL BIT PUNCTURED RIGHT FOOT.

EMPLOYEE WAS USING A PIECE OF WIRE TO UNPLUG ANFO FROM AUGER. THE WIRE APPARENTLY CAUGHT IN THE MOVING AUGER AND PULLED THE END OF HIS FINGER OFF.

EMPLOYEE WAS DRILLING WITH JUMBO. HE WALKED FORWARD OF THE OPERATOR'S CAB. THE EMPLOYEE'S SHIRT BECAME ENTANGLED IN THE MOVING AUGER AND IT TWISTED HIM UP. HE WAS BRUISED AND SCRAPED.

EMPLOYEE HAD RAISED A HYDRAULIC BOOM AND THEN ATTEMPTING TO BLEED THE LINE OF PRESSURE. THE BOOM FELL AND THE EMPLOYEE JUMPED AND HURT KNEE. SOUGHT TREATMENT ON 8-16-98 AND HAD SURGERY ON 8-25 -98.

PINCHED AND BETWEEN THE DRILL AND A WATERHOUSE.

EE WAS ROOF BOLTING & SLAB STRUCK HIM

EE WAS WITHDRAWING THE DRILL STEEL FROM A DRILL HOLE IN THE BACK. THE MACHINE WAS ROTATING DUE TO HOLE BEING RAVELY. EE HAD CUT AIR PRESSURE OFF TO THE LEG COMPLETELY WHEN THE STEEL HUNG. WHEN THE STEEL HUNG, IT CAUSED THE LEG TO RELOCATE AND AT THE SAME TIME, THE STEEL FREED ITSELF, ALLOWING THE MACHINE TO FALL AND STRIKE EE ON THE FOURTH TOE OF HIS RT FOOT CAUSING A FRACTURE TO T

EE WAS GREASING A LHD WHEN THE NOZZEL OF THE PNUEMATIC GREASE GUN CAME LOOSE FROM THE ZIRK ALLOWING THE HOSE TO FLY AROUND & STRIKE HIM ON THE LEFT SHOULDER AREA CAUSING AN INJECTION OF GREASE .

EE WAS LOADING A HOPPER AT THE SECOND CUT CRUSHER WITH 992 C WHEEL LOADER. THE D-CLUTCH WAS VERY STIFF TO OPERATE AND AFTER CONTINUAL USE, HE SUFFERED A STRESS FRACTURE ON HIS LEFT FOOT.

WORKING ABOVE THE DRY MILL IN GRINDING, HOOKED A TUGGER TO AN H BEAM TO HOIST A 36" TUBBING. WHEN TUBBING WAS APPROX 25' UP, THE SAFETY CLIP ON THE TUGGER HOOK FAILED, THE HOOK CAME LOOSE FROM THE TUBING AND STRUCK EE ON THE RT INDEX FINGERCAUSING A LACERATION WHICH REQUIRED STITCHES.

WHILE PULLING A DRILL ROD OUT OF A DRILL HOLE, THE DRILL FELL AND EE ATTEMPTED TO PUSH IT AWAY FROM HIMSELF. WHEN DOING SO HE CAUGHT HIS RT 4TH FINGER IN A PINCH POINT CAUSING A LACERATION AND FRACTURE.

EE WAS ATTEMPTING A BIT CHANGE ON A SURFACE DRILL. WHILE ATTEMPTING REMOVAL OF THE OLD BIT, THE DRILL BUSHING SLID DOWN APPROX. 3' STRIKING HIM ON THE LEFT SIDE OF THE HEAD(INSTANTANEOUSLY AFT ER HIS HARD HAT HAD FALLEN OFF) CAUSING A LACERATION WHICH REQUIRED STITCHES.

EE WAS ROCK BOLTING IN 42-175/1 WHEN HE LOST CONTROL OF THE J-LEG. THE MACHINE FELL, EE FELL WITH IT AND STRUCK SOME ROCK ON THE SILL CAUSING A LACERATION AND FRACTURE.

EE & HIS PARTNER WERE INSTALLING GROUND SUPPORT WIRE IN THE Z4-190-16. THEY WERE ON THE LAST ROW OF HOLES, [READY TO PLACE ANOTHER PIECE OF WIRE] WHEN A ROCK OF 20-30 LBS IN WEIGHT FELL FROM T HE LEADING EDGE OF THE WIRE & STRUCK HIM ON THE LEFT FOOT ON OR AROUND THE ARCH CAUSING A FRACTURE.

EE WAS ROCKBOLTING WITH A JACKLEG. WHEN HE ATTEMPTED TO REMOVE THE STEEL FROM THE HOLE, IT THE MACHINE CAME DOWN PINCHING HIS LEFT FINGERS BETWEEN THE MACHINE SADDLE AND THE HEAD OF THE LEG.

EE WAS CHECKING TO SEE IF ATHE STICKER BAR ON A VL140 GARDNER DENVER DRILL WAS FROZE UP. THE MACHINE WAS PARTIALLY TURNED ON WHE HE PLACED THE PALM OF HIS HAND IN FRONT OF THE STRICKER BAR AND PRESSED IN. THE STRICKER BAR CAME INTO CONTACT WITH THE PISTON AND WAS THRUST OUTWARD STRICKING EE ON THE LEFT PALM CAUSING A BROKEN HAND.

EE WAS OPERATING A J-LEG IN R-3 (200) WHEN A ROCK ROLLED DOWN THE STEEL AND STRUCK HIM ON THE LEFT, LONG FINGER REQUIRING STITCHES.

CAUGHT FINGER BETWEEN SPINDLE WRENCH ON DRILL.

EMP WAS HELPING TO FIND A HYDRAULIC LEAK ON A BOLTEC BOLTING MACHINE. YELLED OK I FOUND IT AND THE OPERATOR THOUGHT HE WASNTED OILTO THE HOSE WHICH RESULTED IN AN INJECTION OF OIL TO EMPS RIGH T INDEX FINGER PAD.

J-LEG WOULD NOT RELEASE OFF BOLT IN THE BACK. AIR HAD BEEN TURNED OFF WHEN J-LEG CAME FREE IT CAME DOWN ALL AT ONCE SNMASHING HIS LEFT INDEX FINGER AND CAUSING A LACERATION AND BROKEN FINGER.

EE WAS PULLING OUT A TANGLE IN THE LINE OF THE DIAMOND DRILL & THOUGHT HIS PARTNER REALIZE THIS.WHEN HE PLACED HIS HAND IN THE TANGLE, HIS PARTNER TIGHTENED THE LINE.

EE WAS BOLTING THE BACK IN R-1 WITH A J-LEG, THE RING ONTHE BOLT BROKE AND THE J-LEG, THE RING ON THE BOLT BROKE AND THE J-LEG LUNGED UPWARD. HE LOOKED UP TO SEE WHERE THE J-LEG/MACHINE WAS AN D THE BOLT, PLATE CAME DOWN AND STRUCK HIM ABOVETHE UPPER LIP CAUSING A LACERATION THAT REQUIRED THREE STITCHES.

WHILE DRILLING A BENCH ROUND IN L-1/320(16), EMPLOYEE WAS THREADING A DRILL STEEL IN TO THE STRING WHEN THE THREAD CAUGHT ON AN UNNOTICED BURR. THE BURR CAUSED THE DRILL STEEL TO ROTATE WHILE IN EMPLOYEE'S HANDS AND HIS RIGHT WRIST STRUCK DRILL MAST CAUSING LACERATION TO THE LATERAL SIDE OF HIS WRIST.

DRIVING IN AN 8' BOLT WHEN A SOFTBALL-SIZED ROCK CAME DOWN STRIKING HIM ON THE LEFT CHEEK.

EE WAS COLLARING A DRILL HOLE IN THE BACK WHEN THE BIT STEEL LODGED IN A CRACK AND STOPPED ROTATION. THE MACHINE MOVED ANOTHER 1/4 INCH (APPROX)IN ROTATION WHEN A SOFTBALL SIZE ROCK FELL FROM THE BACK STRIKING EE ON THE CHIN.

ROCK FELL FROM BACK STRIKING SAFETY GLASSES CUTTING HIS NOSE.

EMPLOYEE WAS ROCK BOLTING WHEN HIS FINGER BECAME CAUGHT BETWEEN THE DRILL & THE LEG.

MAKING STEEL CHANGE & JACKLEG PULLED HIM INTO STEEL STRIKING FOREHEAD & CUTTING HIM

EE WAS SHOTCRETING AND HOSE BECAME PLUGGED, WHEN HOSE JUMPED IT SLIPPED FROM HIM AND THE SPRAY HIT HIM IN THE SIDE OF THE FACE.

ROOF BOLTING - 2' BOLT DRIVER CAME LOOSE AND STRUCK HIM BETWEEN THE EYES.

DRILLING WITH JACK LEG-STEEL PLUGGED & HE WAS ATTEMPTING TO CLEAN THE STEEL. SOMETHING FLEW INTO HIS EYE.

THE EMPLOYEE WAS REPAIRING A STARTER MOTOR OFF OF A HAUL TRIUCK HE APPLIED AIR OF THE START ER JUMPED HE REACHED OUT & CAUGHT IT THE GEAR OF THE START ER CAUGHT HIS HAND & CUT HIS PALM

EE WAS MUCKING DRIFT 55-61. AS HE WAS MAKING A TURN THE ROPS ON THE MUCKER HIT THE LEFT RIB. A ROCK CAME OFF OF THE LEFT RIB AND STURCK EE'S RIGHT HAND.

EE WAS COLLARING A HOLE IN BROW FOR THE INSTALLATION OF A ROCKBOLT WHEN THE DRILL STEEL DISLODGED A ROCK WHICH FELL AND STRUCK EE ON RIGHT SHOULEER , ARM AND HAND. CONTUSIONS AND ABRAISONS REW ULTED.

EMPLOYEE WAS ROOF BVOLTING FROM AN ELEVATED PLATFORM APPROX 3FT FROM THE SILL THE JACK LEG HE WASUSING BUCKED CAUSING HIM TO FALL FROM THE PLATFORM STRIKING HIS RT SHOULDER & ARM AGINST THE RI B & SILL IT WAS LATER FOUND THT THIS SHOULDER WAS FRACTURED

IN THE PROCESS OF RE SEALING BRAKE CALIBERS EE WAS USING COMPRESSED AIR TO REMOVE PISTON THE PISTON SHOT OUT PINCHING RING FINGER OF LEFT HAND RESULTING IN A FRACTURE.

EMPLOYEE WAS INSTALLING ROCKBOLTS AND DISLODGED A ROCK WHICH FELL STRIKING HIS LEFT INDEX FINGER. A FRACTURED FINGER RESULTED.

CONTROLS USED TO RAISE & LOWER WORK DECK HAD WORKED LOOSE SO THAT WHEN RELEASED THE WORKER CONTINUED TO RAISE THE TWO DRILL MACHINES WERE JAMMED INTO BACK CAUSING ONE TO BREAK THE CROWS FOOT L ETTING THE LEG KICKOUT EMPLOYEES ANKLE WAS CAUGHT IN BETWEEN THE TWO LEGS CONTUSED & CHIPPED BONE LT ANKLE

WHILE CUTTING A PIECE OF 3" ANGLE IRON A SECTION ROLLED AND FELL ABOUT 4 FEET LANDING ON THE EMPLOYEE'S INSTEP BEHIND THE STEEL TOE.

EMPLOYEE WHILE ROOF BOLTING LOST HIS GRASP ON DRILL MACHINE, THE MACHINE FELL & IN STRIKING WORK DECK CAUSED JACK LEG TO KICK BACK STRIKING MINER IN UPPER LEFT LEG. THIS RESULTED IN A SMALL CO NTUSINON & LACERATION REUIRING SUTURES.

EMPLOYEE WAS INSTALLING 8' SPLIT SET ROCK BOLTS WITH GARNDER/DENVER JACK DRILL MACHINE. IN ATTEMPTING TO ENGUAGE BOLT DRIVER ON BOLT DRILL MACHINE SLIPPED AND CAUGHT RT. HAND BETWEEN BOLT FING ER. SUTURES WERE VEQUIRED.