Buscar en el registro

0N 1/5/02 EE WAS WORKING IN FEEDER BREAKER. APPOROX 10:30AM HE BREATHED IN SOME SMOKE THAT CAME FROM HIS SHOE AFTER HE HAD STEPPED ON A HOT PIECE OF METAL. THE HOT METAL WAS SLAG/SCRAP FROM AN OXYGEN/ACETYLENE CUTTING JOB HE HAD JUST PERFORMED. SUPERVISOR WENT TO PICK UP INJ EE FOR LUNCH ABOUT NOON & SAW THAT EE LOOKED ILL SUPERVISOR ASKED EE IF HE WAS OK: EE ANSWERED IT WAS JUST

EE AND COWRKER WERE WORKING ON THE D50K DRILLINSTALLING THE MAST RAISE CYLINDERS. EE HAD WELDED TWO PIN BOSSES IN PLACE FOR THE LET LOWER CYLINDER PINHOLE. WHEN THEY TRIED TO INSTALL THE CYLIN DER THEY REALIZED THAT ONE OF THE WELDED BOSSES WAS NOT IN ALIGNMENT. EE STARTED TO CUT IT OFF THE A TORCH TO REPOSITION THE BOSS. WHILE EE WAS CUTTING, THE TORCH CAME ACROSS SOME GREASE, WHI

ON WED 2-22-95 EMPLOYEE WAS GRINDING ON METAL INTHE SHOP. ON FRI 2-24-95 HE BEGAN TO EXPERIENCE IRRITATION IN HIS LEFT EYE. HE DECIDED TO GO TO THE DOCTOR TO INVESTIGATE THE CAUSE. THE DR. DISCOVERED WHERE THERE HAD BEEN TWO SMALL METAL FRAGMENTS IN HIS EYE. THE DR. REMOVED RUST PARTICLES AND TREATED THE EYE.

EMPLOYEE WAS USING A 4" DISK GRINDER TO PREPARE A METAL SURFACE TO BE WELDED. METAL FILINGS ACCUMULATED ON THE HEAD BAND OF THE FACE SHIELD. WHEN HE FLIPPED UP THE SHIELD WHEN DONE GRINDING, T HE ACCUMULATED FILINGS FELL DOWN OFF THE HARD HAT & SOME GOT INTO HIS EYE. ONE 01/13/95 DR. ISSUED PRESCRIPTION FOR ANTIBIOTIC AS A PREVENTIVE MEASURE.

MINE INSTALLING A PIECE OF PLATE STEEL IN THE TRNASFER CHUTE FOR THE BELTS. MECHINC WAS STANDING ON WHILE ANOTHER EE WAS UNDER HOLDING THE PLATE AND WAITING FOR THE MECHANIC TO TACK WELD IT IN TO PLACE. THE WELDING MACHINE WOULD NOT OPERATE PROPERLY MECHANIC LEFT THE BELT AND WENT TO INVESTIGATE THE PROBLEM. FOUND THE THROTTLE SPRING ONT HE WELDER SERVICE TRUCK HAD CAME OFF.